SKS Compit Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor SKS Compit (6 pagina's) in de categorie Overige telefoon accessoire. Deze handleiding was nuttig voor 26 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/6
Dual 1/4'' Instrument To Balanced
& Unbalanced (1/4'' XLR) Direct Box
PDC22
www.PyleUSA.com
2
Fr ont and Rear Panel Layout
1. INPUT: 1/4" input connector.
2. PARA OUT: Its parallel output 1/4" jack for passing the input signal through to a
stage amplifier or monitor system.
3. ATT Switch: input attenuation, switchable(0dB,-20dB,-40dB)
4. BALANCED OUTPUT: Male XLR connector.
5. When engaged, the ground from the PDC22 chassis detaches from the GROUND:
XLR jack.
PDC22 Operation
A direct box, or DI box, provides the facility for the direct insertion of an audio signal
into a mixer or recorder. The oers a variety of DI solutions for live sound and PDC22
recording applications. You can connect all kinds of audio signals like guitars,
keyboards, outboard signal processors and even the high-powered speaker output
from an amplifier. The enables you to tap o the signal from a guitar or bass PDC22
guitar and pass the signal from the PARA OUTPUT to the on stage amplifier without
aecting the original sound. This can eliminate the need for mixing the guitar
amplifier, which in many cases is preferable, especially with bass guitar. The is PDC22
also very useful for connecting unbalanced signals from sources like signals DJ and
sub-mixers, eects processors and keyboards to a main PA or recording mixer.
1 2 3 1 2 3
5 4 5 4
Balanced Output
(opposite panel)
Input
Amp Speaker
Output
Amplier Amp Speaker
Input
PA Mixer
Link Output
SIGNAL FLOW
SIGNAL FLOW
www.PyleUSA.com
3
The balanced output provides a clean signal at a low level so long runs of PDC22
cable are possible. Another benefit from a balanced connection is common mode
rejection, which provides cancellation of the bad sounds (hums and buzzes) while
leaving the original signal pure.
Direct insertion of an Instrument into a PAsystem
One of the most common applications for using a DI box is getting the signal of
a bass guitar into the PA system. Simply put, the low frequencies produced by bass
are dicult to mic, so use of a DI box is almost always preferable. In addition, the
signal going to PA system can be tweaked by the FOH (front of house) engineer,
without aecting the sound the musician dials up on stage. You can use PDC22 to
plug a guitar directly into the PA system as well. Especially acoustic guitars with
pickups and when using electronic guitar processors and modelers. Follow the
diagram and steps below to connect a guitar to a PA mixer.
Connect the output of the guitar or bass to the INPUTPDC22
Connect 's PDC22 PARA OUT to the input of the guitar or bass amplifier.
Connect 's to the input of main PA mixer.PDC22 BALANCED OUTPUT
NOTE:
To avoid annoying pops and clicks be sure to mute (or turn down the volume control)
of your mixers output while connecting the PDC22.


Product specificaties

Merk: SKS
Categorie: Overige telefoon accessoire
Model: Compit

Heb je hulp nodig?

Als je hulp nodig hebt met SKS Compit stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Overige telefoon accessoire SKS

Handleiding Overige telefoon accessoire

Nieuwste handleidingen voor Overige telefoon accessoire