Gira 0869 00 Handleiding

Gira Rookmelder 0869 00

Lees hieronder de 📖 handleiding in het Nederlandse voor Gira 0869 00 (5 pagina's) in de categorie Rookmelder. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/5
GIRA
Info Smoke detector
Instructions for Installation
Smoke detector 45/00 Seite: 1 von 5
Smoke detector Art. Nr.: 0869 00 / 04
Product characteristics at a glance
• Battery-operated smoke detector with photoelectric scattered light principle
• Automatic self test of the smoke evaluation
• Ability to link up to 40 smoke detectors
• Loud, pulsing warning signal at approx. 85 dB (A)
• Battery change indicator
• Contamination/disturbance indicator
• Integrated test button for testing the function
• Battery compartment check: if no battery is installed in the smoke detector, it cannot be locked into
the socket
• Polarity reversal protection: the device cannot be destroyed due to incorrect battery connection
• VdS-recognition: G 200 121
Safety Indications
• Never paint over the smoke detector.
• Smoke detectors only detect the smoke of a fire, but not the flames themselves.
• Smoke detectors do not extinguish a fire. When the alarm sounds, search for the source of the fire
and call the fire department if necessary.
• Do not use rechargeable batteries (accumulators) or power packs for power supply. They can
cause disruptions or the premature failure of the device.
• The smoke detector produces a very loud and shrill sound, which can damage hearing. For this
reason, please observe a safety distance of 50 cm during the function test.
• The smoke detector only monitors a defined area in the vicinity of the installation site. Install
enough detectors to cover the entire living area and ensure optimum protection.
• People under the influence of alcohol or drugs may not be awakened by the signal sound.
Installation site
Smoke detectors should preferably be installed outside the door of or in bedrooms so that you will be
awakened by the smoke alarm at night. In buildings with several floors, at least one smoke detector
should be located on each floor.
The smoke detector will have optimum detection characteristics if it is installed under the ceiling in the
center of the room. If this is not possible, keep a distance of at least 50 cm from the wall.
If the smoke detector is installed in the kitchen, you should locate the device as far away from the
cooking zone as possible to prevent false alarms due to steam.
In large houses, you should use several, linked smoke detectors to cover the entire living area. If
smoke is detected by one smoke detector, it sets off an alarm and activates all connected smoke
detectors, which then also sound the alarm. Thus, you will be awakened during the night by your
linked smoke detector in the bedroom if the smoke detector in the cellar detects smoke.
GIRA
Info
Smoke detector
Instructions for Installation
Smoke detector 45/00 Seite: 2 von 5
Minimum protection: one smoke detector in
the hallway or in the stairwell of each floor
Optimum protection: one smoke detector in
each bedroom and living room
Unsuitable installation sites
In order to prevent false alarms and
malfunctions, do not install the smoke detector:
• in rooms where a large amount of steam,
dust, or smoke are produced under normal
circumstances.
• near hearths and open fireplaces.
• near ventilation shafts, since the stream of
air could possibly prevent smoke from
reaching the detector.
• near fluorescent and energy-saving lamps,
since the starter can trigger false alarms
due to the electrical fields caused by
turning the lamp on (minimum distance:
50 cm).
• in rooms where temperatures are below
+5°C or above +45°C.
Installation and commissioning
Remove the two spacers from the socket.
Otherwise, locking of the smoke detector is
not possible.
1. Install the socket e with the included
installation material.
2. Use the spacers f, if the linking line of
several smoke detectors is "surface-
mounted".
3. If needed, carry out the appropriate steps to
link several smoke detectors.
For this, read the chapter "Linking smoke
detectors".
4. Connect the 9V block battery i to the battery
connection and insert the battery into battery
bracket.
5. Stick the smoke detector c into the socket
and lock it by turning slightly clockwise.
Caution: If no battery is inserted, the smoke
detector cannot be fixed in the socket.
6. Carry out a function test.
c Smoke detector
d Connection block
e Socket
f Spacers
g Plug
h Screw
i Battery (9V)
j Test button
GIRA
Info
Smoke detector
Instructions for Installation
Smoke detector 45/00 Seite: 3 von 5
Linking smoke detectors
You can link up to 40 Gira smoke detectors with one another. The connection of the detectors is
achieved parallel with a two-core cable (e.g. telephone cable: J-Y(St)Y 2x2x0.6 mm). The total cable
length of the detector network may not exceed 450 m.
k + Linking
l - Linking
To link the smoke detectors, proceed as follows:
1. Pull the connection block from the smoke detector board.
2. Connect the color-coded clamps (green = plus; gray = minus) to the line as portrayed in the
illustration.
To do this, insert the stripped cores into the opened spring clamps and close the clamps by
pressing down on the handle.
3. Place the connection block on the board again.
Method of operation, self-test and battery test
The smoke detector recognizes a fire early on by its smoke development. It works according to the
principle of scattered light: light transmitters and receivers are arranged in the measurement chamber
so that the light signal emitted by the transmitter cannot directly hit the receiver (photocell). If smoke
enters the smoke chamber, the light signal is scattered by the floating particles contained in the
smoke. The scattered light rays hit the photocell and are transformed into an electrical signal there,
which triggers the alarm.
The function of the smoke evaluation is constantly checked by a self-test. Any errors are reported by a
disturbance signal (signal sound and light diode).
The battery test continuously checks the supply voltage. If the battery voltage sinks below a defined
level, the smoke detector reports for 30 days that battery must be changed. During these 30 days, the
smoke detector is fully functional.


Product specificaties

Merk: Gira
Categorie: Rookmelder
Model: 0869 00

Heb je hulp nodig?

Als je hulp nodig hebt met Gira 0869 00 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Rookmelder Gira

Handleiding Rookmelder

Nieuwste handleidingen voor Rookmelder

Kidde

Kidde CO120X Handleiding

2 December 2024
EQ-3

EQ-3 HM-Sec-SD-2 Handleiding

30 November 2024
EQ-3

EQ-3 HM-Sec-SD Handleiding

30 November 2024
EQ-3

EQ-3 HMIP-SWSD Handleiding

30 November 2024
Pentatech

Pentatech RA170Q Handleiding

24 November 2024
Cordes

Cordes CC-4100 Handleiding

18 November 2024
Cordes

Cordes CC-3000 Handleiding

18 November 2024
Cordes

Cordes CC-500 Handleiding

18 November 2024
Nexa

Nexa KD-134A Handleiding

18 November 2024
Gloria

Gloria R-5 Handleiding

16 November 2024