Adastra CM30B Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Adastra CM30B (8 pagina's) in de categorie Mengpaneel. Deze handleiding was nuttig voor 41 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
CM30B & CM60B
Compact 100V mixer-amplifiers with Bluetooth™
Item ref: 953.105UK, 953.106 UK
User Manual
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
CM30B, CM60B User Manual
Introduction
Thank you for choosing Adastra -series mixer-amplifier as part of your public address system. This unit is designed to offer high an CM
quality, dependable service for mobile and installed systems.
Please read this manual to gain the best results from your product and avoid damage through misuse.
SAFETY SYMBOL AND MESSAGE CONVENTIONS
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS
RISQUE DE CHOC ELECTRIQUE NE PAS
OUVRIR
This symbol indicates that dangerous voltage constituting a risk of electric shock is
present within this unit
This symbol indicates that there are important operating and maintenance instructions in
the literature accompanying this unit.
SAFETY NOTICE
1. Prior to use, read through this manual
2. Keep the manual in good condition
3. Pay attention to safety warnings
4. Observe all operating requirements
5. Do not use the device near water or wet areas
6. For cleaning, only use a lint-free, dry cloth
7. Install according to the specifications
8. Place away from heat sources or heating appliances
9. Use mains lead provided and avoid damage to cable or connectors
10. Unplug power from mains during stormy weather or if unused for long periods
11. In case of malfunction, water ingress or other damage, consult qualified service personnel
12. Do not place in damp areas or near liquids or moisture. Do not spill liquids on the housing
13. Please pay attention to warning symbols during transit and placement
14. Terminals marked with the symbol are HAZARDOUS LIVE and should only be connected by qualified personnel
15. Ensure that the apparatus is connected to a mains socket with a protective EARTH connection
16. Ensure correct operation of the mains switch
Warning
To prevent the risk of fire or electric shock, do not expose any components to rain or moisture.
If liquids are spilled on the casing, stop using immediately, allow unit to dry out and have checked by qualified personnel before
further use. Avoid impact, extreme pressure or heavy vibration to the case
No user serviceable parts inside Do not open the case refer all servicing to qualified service personnel. – –
Safety
Check for correct mains voltage and condition of IEC lead before connecting to power outlet
Use double insulated speaker wire with adequate current rating for 100V speaker connections
Only use 1 type of output i.e. do not mix or combine these outputs on a single zone 8Ω or 100V –
Do not connect 8Ω speakers to the 100V terminal or 100V speakers to the 8Ω terminal
Do not allow any foreign objects to enter the case or through the ventilation grilles
Placement
Keep out of direct sunlight and away from heat sources
Keep away from damp or dusty environments
For rack-mounting, use an appropriate shelf unit (e.g. 853.055UK) and ensure adequate support
Ensure adequate air-flow and do not cover cooling vents at the front and rear of the amplifier
Ensure adequate access to controls and connections
Cleaning
Use a soft cloth with a neutral detergent to clean the casing as required
Use a vacuum cleaner to clear ventilation grilles of any dust or debris build-ups
Do not use strong solvents for cleaning the unit
CM30B, CM60B User Manual
Front panel
Rear panel
Connection and setup
Connect the rear IEC inlet (16 to the mains using the supplied mains lead (or an equivalent )
approved type). Ensure that the voltage is correct as indicated on the voltage selector (13) and that
the mains outlet is switched on. Alternatively, the amplifier can be powered by a 12V battery, such
as a car or boat battery, by connecting t -he “+” and “ ” of the battery to the 12Vdc INPUT (14) on
the rear panel. Ensure that DC cables are capable of handling the current (6A min. recommended)
Connect a microphone (if required) to the front panel jack or combo input (7).
Connect any line level audio inputs to the LINE IN connectors ( ) on the rear panel using good 21
quality RCA leads. An additional 3.5mm AUX line input (10) is provided on the front panel for
connecting a playback device such as smart phone or MP3 player. a
Further amplifiers can be connected from the rear LINE OUT sockets (20)
For stable FM radio reception, connect the Antenna F type socket (15) to a suitable FM antenna. ‘ ’
The CM series amplifiers can be used either as 100V line amplifiers or standard low impedance power
amplifiers. These 2 configurations cannot be used together, so it is important to decide which
method will be used at the start.
1.
MIC volume control
2.
LINE IN volume control
3.
USB/FM/Bluetooth/AUX volume control
4.
MASTER volume control
5.
USB input
6.
Media play display er
7.
Microphone input jack/XLR (CM30B jack only)
8.
VU meter
9.
FOG / SIREN / ALERT buttons (CM60B only)
10.
3.5mm stereo AUX input
11.
Media player controls
12.
Power on/off switch
13.
Mains voltage switch
14.
DC power terminals
15.
Antenna F connector
16.
IEC mains inlet & fuse holder
17.
COM speaker terminal
18.
8 speaker terminal Ω
19.
100V speaker terminal
20.
LINE OUT connectors (RCA)
21.
LINE IN connectors (RCA)


Product specificaties

Merk: Adastra
Categorie: Mengpaneel
Model: CM30B
Kleur van het product: Zwart
Gewicht: 3700 g
Breedte: 329 mm
Diepte: 210 mm
Hoogte: 84 mm
Breedte verpakking: 395 mm
Diepte verpakking: 315 mm
Hoogte verpakking: 130 mm
Bluetooth: Ja
Aan/uitschakelaar: Ja
Bluetooth-versie: 2.0
USB-poort: Ja
USB-connectortype: USB Type-A
Aantal USB 2.0-poorten: 1
Microfoon, line-in ingang: Ja
Versterker output power: 30 W
Videomogelijkheid: Nee
Equalizer-instellingen: Ja
Rack-montage: Ja
Frequentiebereik: 93 - 16300 Hz
AUX ingang: Ja
Aantal kanalen: 2 kanalen
Microphone input impedance: 1800 Ohm
Rackcapaciteit: 2U
AC-ingangsspanning: 110 - 230 V
AC-ingangsfrequentie: 50 - 60 Hz
Aantal microfooningangen: 1
Line inputs (RCA): 2
Versterker inclusief: Ja
Output impedance: 8 Ohm
Digitaal geluid verwerken: - Bit
Microfoon Signal-to-Noise Ratio (SNR): 73 dB
Booth out (RCA): 2
Line Signal-to-Noise Ratio (SNR): 79 dB

Heb je hulp nodig?

Als je hulp nodig hebt met Adastra CM30B stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Mengpaneel Adastra

Handleiding Mengpaneel

Nieuwste handleidingen voor Mengpaneel