Bogen LMM1S Handleiding

Bogen Mengpaneel LMM1S

Lees hieronder de 📖 handleiding in het Nederlandse voor Bogen LMM1S (4 pagina's) in de categorie Mengpaneel. Deze handleiding was nuttig voor 2 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

LMM1S

MIC/LINE

MIC/

C/LI

LINE

LMM S1

Mic/Line Input Module

Features

• Line mode for high impedance input

• MIC Mode for low impedance input

• Electronically balanced input

• Gain/Trim control with Gain range switch

• Bass and treble

• 24V Phantom power

• Audio Gating

• Gating with threshold and duration adjustments

• Fade back from mute

• 4 levels of available priority

• Can be muted from higher priority modules

• Can mute lower priority modules

• Removeable screw terminal input

54-2 56-0 A 07061 1

Specifications subject to change without notice.

5. Gain

Provides control over the level of input signal that can be applied to the internal signal buses

of the main unit. Balances the input levels of various devices so that the main unit controls can

be set to relatively uniform or optimum levels. 8-60 dB Gain range in MIC position, -2 to 401

dB in Line position.

1. Gate - Threshold (Thresh)

Controls the amount of input signal level neces-

sary to turn the module’s signal output on and

mute lower priority modules. Clockwise rotation

increases the necessary input signal level required

to produce audio output and mute lower priori-

ty modules.

6. MIC/Line In

MIC/Line level input on removeable screw terminal strip. Electronically balanced input.

3. Treble (Treb)

The Treble control provides +/- 0 dB at 0 kHz.1 1

Clockwise rotation provides boost; counterclockwise rotation provides cut. Center position

provides no effect.

2. Gate - Duration (Dur)

Controls the amount of time the signal output

and priority muting of the module remains

applied to the main unit’s buses after the input

signal falls below the required minimum signal

level (set by the threshold control).

4. Bass

The Bass control provides +/- 0 dB at 1 100 Hz. Clockwise rotation provides boost; counter-

clockwise rotation provides cut. Center position provides no effect.

LMM1S

MIC/LINE

MIC/

C/LI

LINE

WARNING:

Turn off power to unit and make all jumper

selections before installing module in unit.

Module Installation

1.Turn off all power to the unit.

2. Make all necessary jumper selections.

3. Position module in front of any desired module bay opening, making sure that the module

is right-side up.

4. Slide module onto card guide rails. Make sure that both the top and bottom guides are

engaged.

5. Push the module in to the bay until the faceplate contacts the unit’s chassis.

6. Use the two screws included to secure the module to the unit.

Gating

Gating (turning off) of the module’s output when insufficient audio is present at the input can

be disabled. Detection of audio for the purpose of muting lower priority modules is always

active regardless of this jumper setting.

Phantom Power

24V Phantom power can be supplied to condensor microphones when jumper is set to ON

position. Leave OFF for dynamic mics.

Bus Assignment

This module can be set to operate so that the mono signal can be sent to the main unit’s

A bus, B bus, or both buses.

MIC/LINE Switch

Sets input gain range for the intended input device. MIC gain range 18 – 60 dB, LINE gain

range -2 – 40 dB.

Jumper Selections

Priority Level*

This module can respond to 4

different levels of priority.

Priority 1is the highest priority.

It mutes modules with lower pri-

orities and is never muted.

Priority 2 can be muted by

Priority 1modules and can mute

modules set for Priority Level 3

or 4. Priority 3 can be muted by

either Priority or 2 modules1

and can mute Priority 4 mod-

ules. Priority 4 modules are

muted by all higher priority

modules. Remove all jumpers for

“no mute” setting.

*The number of priority levels avail-

able is determined by the equip-

ment the modules are used in.

LINE MIC

PHANTOM

PWR

GATING

ENABLE

BUS

ASSIGNMENT

PRIORITIES

J11

J10

J12

J13

MIC/LINE

SWITCH

LINE LEVEL INPUT

MIC LEVEL INPUT

OFF

PHANTOM

POWER

ENABLED

DISABLED

G ATING

BUS ASSIGNMENT

B BOTH

PRIORITY LEVELS

1 2 3 4

HIGHEST LOWEST

Product specificaties

Merk:	Bogen
Categorie:	Mengpaneel
Model:	LMM1S
Gewicht:	62.37 g
Stroomvoorziening:	24VDC
Frequentiebereik:	20Hz - 50kHz
Afmetingen (B x D x H):	34.92 x 88.9 x 79.3 mm