JETI AddCAP 1640 Handleiding

JETI Radiografisch bestuurbaar speelgoed AddCAP 1640

Lees hieronder de 📖 handleiding in het Nederlandse voor JETI AddCAP 1640 (2 pagina's) in de categorie Radiografisch bestuurbaar speelgoed. Deze handleiding was nuttig voor 50 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/2

A CAP 820DD

A CAP 1640 DD

By JETI model s.r.o 12. 6. 2013

AddCAP 820, AddCAP 1640

1. Description

AddCAP 820 and AddCAP 1640 are add-on capacitor units designed to enhance battery power supply for drive

systems using low-impedence electric motors (1-2 pole). They should also be used when the wires from your battery

to your ESC need to be lengthened more than 20cm (8 inches). In cases where the wires are longer, use one AddCAP

820 or AddCAP 1640 for each 20cm (8 inch) section. Another advantage of adding an additional capacitor is to

reduce possible interference which may be caused by current moving through your power wires. Recommended for

use with 2.5-6 mm2 (14AWG – 10AWG) wires.

2. Parameters

AddCAP 820 AddCAP 1640

Maximum voltage: 59V 59V

Dimensions: 60x19x18 mm 60x35x24 mm

Weight: 13g 27g

3. Installation procedure

1. Prepare the cables and tin (pre-solder) their ends.

2. Put the large piece of heat shrink tubing over the power wires. It will be slipped over the capacitor once

the power wires have been installed. Be sure to keep this tubing far enough away from the unit while you

are working so that it does not get shrunk when soldering the power cables.

3. Put the small shrink tubing over the cables at the wire support tabs (match the colors, see picture 1),

align the ends of the cables on the prepared solder pads as shown (cable ends should be as close to each

other as possible), then shrink the cables to the support tabs on the PCB using a heat gun.

4. Carefully solder the cables (see picture 2).

5. Put the large piece of heat shrink tubing over the capacitor. Shrink it with a heat gun and apply the

sticker (see picture 3).

Fig. 1 Fig. 2

Fig. 3

-2-

Product specificaties

Merk:	JETI
Categorie:	Radiografisch bestuurbaar speelgoed
Model:	AddCAP 1640
Kleur van het product:	Black, Green
Gewicht:	27 g
Breedte:	60 mm
Diepte:	35 mm
Hoogte:	24 mm
Soort:	Radio-Controlled (RC) Model Parts
Correct gebruik:	Universeel
Merkcompatibiliteit:	Alle merken
Aantal:	1
Spanning:	59 V
Compatibiliteit:	2.5-6 mm2 (14AWG – 10AWG) wires