Expobar Brewtus II Handleiding

Expobar Espresso apparaat Brewtus II

Lees hieronder de 📖 handleiding in het Nederlandse voor Expobar Brewtus II (12 pagina's) in de categorie Espresso apparaat. Deze handleiding was nuttig voor 59 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/12

Expobar Brewtus II closer look v6.doc

A Closer Look

The details were correct at the time of writing, but the manufacturer and

Bella Barista reserve the right to change the technical specification of

the packaging, machines and any accessories supplied with the

machine (including quantity and type of accessories supplied)

Bella Barista

Nene Court, The Embankment,Wellingborough, Northants, NN8 1LD

Tel: 01933 273275

e-mail: claudettep@towability.com

Overview

The Expobar Brewtus II arrived well packed in a very sturdy cardboard box that has a little

space for accessories to be added. Nice to see the use of shaped polystyrene as a packing

material and this machine is unlikely to get damaged in transit.

Externally the machine is well ﬁnished, uses high quality components and has a solid and

quality feel. The warmer tray is reasonably well sized but not as large as a Vivi, the machine

is quite tall, there is sufficient clearance under normal height kitchen wall cupboards (non-

standard height cupboards would almost certainly cause a problem) and when under

standard height cupboards, there is not much clearance to place items on the cup warmer

tray. The Expobar Brewtus II has a few rattles from the drip tray and cup tray area, but these

are easily remedied and the vibe pump is reasonably quiet when operating, certainly it is not

obtrusive.

The drip tray is very large and in complete contrast to some machines is properly finished at

the front. The lower part curves to follow the bodywork underneath and has an extra front

plate to clean up any exposed edges, very similar to the Zaffiro. The drip tray has been cold

formed and although this leaves it thinner than a steel plate welded drip tray, it gives it a much

neater look inside with rounded corners which makes cleaning much easier. It is also not too

heavy when full of water, important when it can hold nearly 2.5 litres.

As with some other machines the portafilter basket comes assembled and the spouts in the

right place. The standard equipment is a double portafilter (2 spouts) and a single and double

basket plus a rubber disk to insert when backflushing.

The boilers are a good size at 1.5 litres each and because it is a twin boiler machine (one for

steam and hot water, the other for Brew water) there is no problem with steaming, brew water

stability, or brewing and steaming at the same time. 1200w heating elements are more than

sufficient to maintain temperatures and give fast recovery times. It is a very strong steamer

and the single hole steam tip works very well, the recovery time after drawing water for an

americano is fast and of course has no real impact on brew water temperature.

Some of the things I loved were:

• The simple lever on the bottom of the case that operated a valve which meant you

could switch from the internal tank to mains water operation. Just a fabulous idea that

would come into its own if you needed to descale a machine that is plumbed into the

mains water supply.

• The water and steam wands are well placed, mounted on ball joints and the knobs

are a really nice size.

• The digital temperature controller was great (it comes from a refrigeration application,

but is a very neat size), the look of it suits the machine and it functions impeccably.

• Just how well it was put together on the inside, the Spanish have certainly done a

nice job on this machine, with a lot of attention to detail and a very clever and well

thought through design.

As always, there are a few minor changes that I would like to see, even for this machine

(which I love), but no quality issues. The changes are mostly design related so may be

difficult to resolve.

Bella Barista

Nene Court, The Embankment,Wellingborough, Northants, NN8 1LD

Tel: 01933 273275

e-mail: claudettep@towability.com

Servicing this machine will be easy as all components are quite accessible, case removal is 5

screws, and the water tank platform (which may also need to be removed) has two screws

and a couple of hex screws (puzzling why they decided to use 2 hex screws?). There is little

potential for an inexperienced service engineer to damage the machine when removing the

case, the pump is quite accessible and pump replacement looks straightforward. The water

sensitive control board is mounted in the area least likely to be exposed to water during filling

the tank, or venting, as is the digital temperature controller.

There are no instructions regarding lifting the Expobar Brewtus II from the box and it is a bit

awkward. The best method is to lay the box on its side, slide the machine out in its

polystyrene shells and then flip it upright. It’s heavy and solid, but easily handled by one

person.

In summary; The Expobar Brewtus II is very nice machine for the domestic consumer to use,

easy for the reseller to support and maintain. It should provide years of reliable service with

the minimum of maintenance.

This is a machine that I expected a lot from and it did not disappoint. I can only say to

Expobar, well done you have done a great job on this machine (and I don’t praise these

companies lightly). I think for the competition to displace this machine or attack it’s market

would be extremely difficult. Expobar have the price right, the design right and it works really

well!

I even feel this machine is very good value for money, it’s not a cheap machine and for a

change I do think you are getting what you pay for. This is a subjective statement, but the

Expobar Brewtus II stands out amongst the crowd of prosumer machines.

The machine carries it’s electrical

rating sticker and serial number behind

the drip tray.

The vital statistics for this machine are quite conflicting (and in some cases

inaccurate) when reading various websites and supplied information, my most

accurate view from measurement, rating plate information and internal examination, is

as follows:

• Dimensions all approx. (not including steam/water wands) W = 260mm, D =460mm

H=420mm

• Heating elements are 1200W one in each boiler (but only one can be on at any one

time)

• Each boiler has a capacity of approximately 1.5 litres.

• Boilers are copper with brass ends

• Weight is approximately 20kg

• Pump in the test machine was an Ulka EX5 48W

• Group is an E61 type group

Product specificaties

Merk:	Expobar
Categorie:	Espresso apparaat
Model:	Brewtus II

Heb je hulp nodig?

Als je hulp nodig hebt met Expobar Brewtus II stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Espresso apparaat Expobar

Expobar Office Handleiding

8 Juli 2023

Expobar Ruggero 2 GR Compact Handleiding

8 Juli 2023

Expobar Brewtus II Handleiding

8 Juli 2023

Expobar Markus Handleiding

8 Juli 2023

Expobar Athenea Handleiding

8 Juli 2023

Expobar Office Control Handleiding

8 Juli 2023

Expobar Office Lever Handleiding

8 Juli 2023

Expobar Elen Handleiding

22 Oktober 2022

Handleiding Espresso apparaat

Nieuwste handleidingen voor Espresso apparaat

Gastroback 42604 Handleiding

21 September 2024

Gastroback 42610 Handleiding

21 September 2024

Rommelsbacher EKS1510 Handleiding

27 September 2024

Gastroback 42607 Handleiding

21 September 2024

Gastroback 42612S - Design Espresso Advanced Pro GS Handleiding

21 September 2024

Rommelsbacher EKO 366-E Handleiding

27 September 2024

Gastroback 42611 Handleiding

21 September 2024

Wmf Perfection 660 Handleiding

7 Oktober 2024

Gastroback 42705 Design Coffee Aroma Pro Handleiding

21 September 2024

Gastroback 42640 DESIGN ESPRESSO ADVANCED PROFESSIONAL Handleiding

21 September 2024