Astralpool Rapidpool Handleiding
Astralpool
Waterfilter
Rapidpool
Lees hieronder de đź“– handleiding in het Nederlandse voor Astralpool Rapidpool (88 pagina's) in de categorie Waterfilter. Deze handleiding was nuttig voor 78 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/88
WHAT HAPPENS TO THE WATER IN YOUR POOL?
This should be a question of prime consideration for all pool owners. In the past some pools did not use
filtering systems, the owner was faced with the problem of refilling the pool with clean water when this
became necessary. Refilling the pool was laborious, meanwhile the owner had an unsanitary pool with
unpleasant bathing owing to the poor clarity of the water. Today pool owners demand absolute hygiene,
crystal clear water and economy of effort. These objectives are achieved by effective filtration and
chemical treatment of the pool water.
After filling the pool with clean water in the summer, two basic factors can take place due to the expo-
sure of water to the sun and the air.
1.- Biological contamination. The water is contaminated by micro-organisms which may be airborne or
introduced by bathers.
These parasites reproduce rapidly in still warm water and algae may form giving a greenish appear-
ance to the pool water.
2.- Rainfall and wind may introduce dust, with leaves and seeds which muddy and pollute the pool
water.
These two factors generate in little time an unsanitary swimmingpool and unpleasant bathing.
Solutions to the problem:
1.- “CHEMICAL” TREATMENT
Maintain the correct level of sanitiser (chlorine, brom, oxygen...) in the water to combat existing
micro-organisms by its disinfecting action.
As chlorine is the more common method, it will be taken as the reference point.
2.- “PHYSICAL” TREATMENT
Provide the pool with a filtration system (filter and pump) to remove suspended particles from the
water.
PH LEVEL
The pH level is an indicator of acidity or alkalinity present in the water. The neutral value is 7.0. a pH
of 0-7 means levels of acidity whilst 7-14 gives levels of alkalinity. The pool usual readings vary between
6.8 and 8.4.
ENGLISH
-02-
WORKING PRINCIPLES
A suction is taken from the main drains ( ) on the bottom of the pool and the skimmers ( ) at the pool1 2
surface and fed via separate pipework with their corresponding valves ( ), through the pump ( ) to the3 4
sand filter (5).
After filtration, the water is returned to the pool via return inlets ( ), which are installed on the opposite6
side of the pool to the skimmers and main drains.
Once in the filter, the water is circulated downwards through silica sand and suspended particles are retained.
The filter sand needs to be washed at intervals to remove the particles it has retained backwash.
This is achieved by reversing the flow through the filter and directing the water containing the dislodged
particles to drain.
When the filter pressure reaches over 1,3 Kg/cm² means that the sandfilter needs to be backwashed.
Bearing these principles in mind, the following installation and operation instructions should not repre-
sent any problem.
ENGLISH
-04-
(6) return
multiport valve
(5) filter
(2) skimmer
(1) drain
suction inlets
(3) valves
(4) pump
INSTALLATION
The filter should be installed as close as possible to the swimming pool and preferably at a level of 0,50
metres below the surface of the water in the swimming pool. Make sure there is drainage available at
the place where the filter is to be installed.
IMPORTANT: Do not use an iron and hemp pipe for the selector valve connection, it is essen-
tial to use plastic accessories and TEFLON tape. Pipe terminals are available threaded fixing in
1 ½ “ and 2”.
Always leave enough space round the filter in order to perform the necessary examinations and
maintenance during the filter's life.
ASSEMBLY
Follow these indications for a correct assembly of the filter:
1.- Place the filter on a horizontal and clean surface.
2.- Place the filter in its final location.
3.- In case of a filter with a lateral valve, install the selector valve in the filter. Make sure that the joints
between the valve and the filter are correctly placed.
4.- Perform the three connections of the selector valve: pump piping to the valve, valve to the waste
drain and valve to the pool return. Each of these three outlets is clearly identified on the valve.
5.- Set the manometer T, the joint, the manometer and the air drainage (see exploded view). It is not
necessary to use Teflon tape, as the watertightness is guaranteed in this case by the joint. Do not
tighten the manometer T with a tool, as manually will be sufficient.
-05-
selector valve
waste return
suction
suction
waste
SAND LOAD
In order to obtain maximum efficiency from your filter, it should be filled with silica sand with a grain size
classification of 16 / 32 inches. With the quantity indicated on the plate specifying the characteristics;
proceed as follows:
1.- Load up when the filter is installed in position and the connection pipes have been joined.
2.- Take off the lid and joint.
3.- Fill the filter with water to half capacity.
4.- Pour the required quantity of sand inside the filter.
5.- Clean the seating of the lid joint.
6.- Fix the filter lid in place.
FILTRATION PROCESS
The selector valve has a handle of 6 positions that selects any of the necessary operations to obtain
the maximum efficiency from the filter.
IMPORTANT: Always switch off the pump, when changing the position of the selector valve.
ENGLISH
-06-
Assembly of the manometer (with lateral valve) Assembly of the manometer (with top valve)
Product specificaties
| Merk: | Astralpool |
| Categorie: | Waterfilter |
| Model: | Rapidpool |
Heb je hulp nodig?
Als je hulp nodig hebt met Astralpool Rapidpool stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Waterfilter Astralpool
30 November 2024
30 November 2024
30 November 2024
30 November 2024
30 November 2024
30 November 2024
30 November 2024
22 Juni 2023
22 Juni 2023
21 Juni 2023
Handleiding Waterfilter
- Waterfilter Electrolux
- Waterfilter Philips
- Waterfilter Panasonic
- Waterfilter LG
- Waterfilter JBL
- Waterfilter Tefal
- Waterfilter Zanussi
- Waterfilter Avanti
- Waterfilter Bartscher
- Waterfilter Breville
- Waterfilter Brita
- Waterfilter BWT
- Waterfilter Eden
- Waterfilter Eheim
- Waterfilter Fisher And Paykel
- Waterfilter Franke
- Waterfilter GE
- Waterfilter Grohe
- Waterfilter Haier
- Waterfilter Kent
- Waterfilter Laica
- Waterfilter Midea
- Waterfilter Smeg
- Waterfilter Solac
- Waterfilter Stiebel Eltron
- Waterfilter Sunbeam
- Waterfilter Terraillon
- Waterfilter Ufesa
- Waterfilter Verbatim
- Waterfilter Zodiac
- Waterfilter Jata
- Waterfilter Jura
- Waterfilter Juwel
- Waterfilter Oase
- Waterfilter Imetec
- Waterfilter Fluval
- Waterfilter Eldom
- Waterfilter Aarke
- Waterfilter Ecowater
- Waterfilter Flama
- Waterfilter FIAP
- Waterfilter Pontec
- Waterfilter Pureit
- Waterfilter Everpure
- Waterfilter Consul
- Waterfilter T.I.P.
- Waterfilter MSR
- Waterfilter JANDY
- Waterfilter Billi
- Waterfilter LifeStraw
- Waterfilter Baracuda
- Waterfilter Waterdrop
- Waterfilter Zip
- Waterfilter Waterco
- Waterfilter Aquasure
- Waterfilter ZeroWater
- Waterfilter Beemur
- Waterfilter Ionmax
- Waterfilter Puretec
- Waterfilter Tunze
- Waterfilter Aqua Medic
- Waterfilter PUR
- Waterfilter Sera
- Waterfilter Oliveri
- Waterfilter Hydor
- Waterfilter Heissner
- Waterfilter Aquael
- Waterfilter LARQ
- Waterfilter Platypus
- Waterfilter BTI Aqua-Solutions
Nieuwste handleidingen voor Waterfilter
31 Maart 2025
31 Maart 2025
29 Maart 2025
26 Februari 2025
20 Februari 2025
7 Februari 2025
18 December 2024
18 December 2024
18 December 2024
16 December 2024