JANDY CS100 Handleiding
JANDY
Waterfilter
CS100
Lees hieronder de š handleiding in het Nederlandse voor JANDY CS100 (36 pagina's) in de categorie Waterfilter. Deze handleiding was nuttig voor 5 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/36
Single Element Cartridge Pool & Spa CS Filters
Models: CS100 CS250
CS150
CS200
Essential installation and startup instructions are included in this manual.
Additional operation and troubleshooting information is available online by
scanning the QR code with your phone or visiting jandy.com
WARNING
FOR YOUR SAFETY ā This product must be installed and serviced by a contractor who is licensed and qualiļ¬ed in pool
equipment by the jurisdiction in which the product will be installed where such state or local requirements exist. The
maintainer must be a professional with sufļ¬cient experience in pool equipment installation and maintenance so that all of
the instructions in this manual can be followed exactly. Before installing this product, read and follow all warning notices and
instructions that accompany this product. Failure to follow warning notices and instructions may result in property damage,
personal injury, or death. Improper installation and/or operation may void the warranty.
Improper installation and/or operation can create unwanted electrical hazard which may cause serious injury, property
damage, or death.
ATTENTION INSTALLER ā This manual contains important information about the installation, operation and
safe use of this product. Thisīinformation should be given to the owner/operator of this equipment.
Installation and Operation Manual
Manuel dāinstallation et dāutilisation
Manual de instalaciĆ³n y operaciĆ³n
Page 2
ENGLISH Jandy
Ā®
Single Element Cartridge Pool & Spa CS Filters | Installation & Operation Manual
Section 1. Important Safety Instructions
READ AND FOLLOW ALL INSTRUCTIONS
1.1 Important Safety Warning
WARNING
ā¢ Do not connect system to an unregulated city water system or other external source of pressurized
water producing pressures greater than 35 PSI.
ā¢ Pressurized air in system can cause product failure or also cause the ļ¬lter lid to be blown off
which can result in death, serious personal injury, or property damage. Be sure all air is out of
system before operating or testing the equipment.
MAXIMUM OPERATING PRESSURE OF THE FILTER IS 50 PSI. NEVER SUBJECT THE FILTER TO
ANY OPERATING PRESSURE EXCEEDING 50 PSI.
This ļ¬lter operates under high pressure. When any part of the circulating system, i.e., ļ¬lter, pump,
valve(s), clamp, etc. is serviced, air can enter the system and become pressurized when the system
is restarted. Pressurized air can cause product failure or also cause the ļ¬lter lid to be blown off which
can result in death, serious personal injury or property damage. To avoid this potential hazard, follow
all of the instructions in this manual.
To minimize risk of severe injury or death the ļ¬lter and/or pump should not be subjected to the piping
system pressurization test.
Local codes may require the pool piping system to be subjected to a pressure test. These
requirements are generally not intended to apply to the pool equipment such as ļ¬lters or pumps.
Jandy Pro Series pool equipment is pressure tested at the factory.
If however this WARNING cannot be followed and pressure testing of the piping system must include
the ļ¬lter and/or pump BE SURE TO COMPLY WITH THE FOLLOWING SAFETY INSTRUCTIONS:
ā¢ Check all clamps, bolts, lids, lock rings and system accessories to ensure they are properly
installed and secured before testing.
ā¢ RELEASE ALL AIR in the system before testing.
ā¢ Water pressure for test must NOT EXCEED 35 PSI.
ā¢ Water temperature for test must NOT EXCEED 100Ā°F (38Ā°C).
ā¢ Limit test to 24 hours. After test, visually check system to be sure it is ready for operation.
Notice: These parameters apply to Jandy Pro Series equipment only. For non-Jandy equipment, consult equipment manufacturer.
Table of Contents
Section 1. Important Safety Instructions 2 ....
1.1 Important Safety Warning 2 .........................
1.2 General Safety Instructions 3 ......................
Section 2. General Information 3 ....................
2.1 Introduction ............................................... 3
2.2 Description ................................................ 3
2.3 General Requirements 3 ..............................
Section 3. Installation Instructions 4 ..............
3.1 Filter Location 4 ...........................................
3.2 Filter Preparation 4 ......................................
3.3 Filter Installation 5 ........................................
3.4 Locking Ring and Tank Top Assembly
Installation 5 .................................................
Section 4. Start-Up and Operation 6 ..............
4.1 New Pool and Seasonal Start-up 6 .............
Section 5. Filter Disassembly
and Assembly 7 ..............................
5.1 Filter Element Removal 7 .............................
Section 6. Maintenance 7 ................................
6.1 General Maintenance 7 ................................
6.2 Pressure Gauge 8 ........................................
6.3 Cleaning the Filter Cartridge 8 .....................
6.4 Breather Tube Maintenance 8 ......................
Section 7. Winterizing 8 ...................................
Section 8. Troubleshooting 9 ..........................
Section 9. Parts List and Exploded View 10 ..
Jandy
Ā®
Single Element Cartridge Pool & Spa CS Filters | Installation & Operation Manual ENGLISH
Page 3
1.2 General Safety Instructions
ATTENTION INSTALLER
This manual contains important information about the installation, operation and safe use of this
product. This information should be given to the owner/operator of this equipment.
1. Use equipment only in a pool or spa installation.
2. Before repositioning valve(s) and before beginning the assembly, disassembly, or adjustment of the clamp, or any
other service of the circulating system; (A) turn the pump off and shut off any automatic controls to ensure the system
is not inadvertently started during servicing; (B) open the air release valve; (C) wait until all pressure is relieved (air will
have stopped ļ¬owing from the air release valve).
3. Whenever installing the ļ¬lter clamp follow Section 3.4 of this manual, āLocking Ring/Tank Top Assembly Installationā.
4. Once service on the circulation system is complete, follow Section 4 of this manual, āStart-up and Operationā.
5. Maintain circulation system properly. Replace worn or damaged parts immediately.
6. Be sure that the ļ¬lter is properly mounted and positioned according to these installation instructions.
7. Do not pressure test above 35 PSI. Pressure testing must be done by a trained pool professional.
SAVE THESE INSTRUCTIONS
Section 2. General Information
2.1 Introduction
This manual contains information for the proper
installation and operation of the Jandy CS Series
Cartridge Filters. Procedures in this manual must be
followed exactly. For technical assistance, contact our
Technical Support Department at 1.800.822.7933.
2.2 Description
Cartridge ļ¬lters do not require sand or diatomaceous
earth as the ļ¬lter medium. Instead they contain a ļ¬lter
cartridge element which is easily removed for cleaning
or replacement.
Dirty water ļ¬ows into the ļ¬lter tank and is directed
through the ļ¬lter cartridge. The debris is collected on
the surface of the cartridge as the water ļ¬ows through
it. The water will travel through the central ļ¬lter
core towards the bottom of the ļ¬lter into the lower
manifold. Clean water is returned to the swimming
pool through the ļ¬lter outlet port at the tankās bottom.
As debris collects in the ļ¬lter, the pressure will rise and
water ļ¬ow to the pool will diminish. The ļ¬lter cartridge
must be cleaned when the operating pressure of the
ļ¬lter rises 10 psi from the operating pressure of a
clean cartridge. See Section 6 āCleaning the Filterā.
NOTE: A ļ¬lter removes dirt and other suspended particles but
does not sanitize the pool. Pool water must be sanitized
and chemically balanced for clear water. The ļ¬ltration
system should be designed to meet local health codes. At
a minimum, the system should turnover the total volume
of water in your pool two (2) to four (4) times in a 24 hour
period.
2.3 General Requirements
1. For best overall performance place the system as
close to the pool as possible.
2. The ļ¬lter should be located on a level concrete slab
so that the orientation of the valve outlets and the
pressure gauge are convenient and accessible for
the installation and operation of the unit.
3. Protect the ļ¬lter from the weather.
4. If ļ¬tting a chlorinator and/or any other device into
the ļ¬ltration plumbing circuit, great care must be
exercised to ensure that the appliance is installed
in accordance with the Manufacturerās Instructions
and any applicable standards that may exist.
5. Use Jandy universal unions to connect each
component of the water conditioning system for
future servicing. All Jandy ļ¬lters come with these
type of ļ¬ttings.
WARNING
The maximum operating pressure for this ļ¬lter is 50 psi.
Never subject the ļ¬lter to operating pressure exceeding
50 psi. Operating pressures above 50 psi can cause
product failure or also cause the lid to be blown off,
which can result in death, serious personal injury, or
property damage.
6. When performing hydrostatic pressure tests or
when testing for external leaks of the completed
ļ¬ltration and plumbing system, ensure that
the maximum pressure the ļ¬ltration system is
subjected to does not exceed the maximum
working pressure of any of the components within
the system.
Product specificaties
| Merk: | JANDY |
| Categorie: | Waterfilter |
| Model: | CS100 |
Heb je hulp nodig?
Als je hulp nodig hebt met JANDY CS100 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Waterfilter JANDY
18 December 2024
18 December 2024
18 December 2024
Handleiding Waterfilter
- Waterfilter Electrolux
- Waterfilter Philips
- Waterfilter Panasonic
- Waterfilter LG
- Waterfilter JBL
- Waterfilter Tefal
- Waterfilter Zanussi
- Waterfilter Astralpool
- Waterfilter Avanti
- Waterfilter Bartscher
- Waterfilter Breville
- Waterfilter Brita
- Waterfilter BWT
- Waterfilter Eden
- Waterfilter Eheim
- Waterfilter Fisher And Paykel
- Waterfilter Franke
- Waterfilter GE
- Waterfilter Grohe
- Waterfilter Haier
- Waterfilter Kent
- Waterfilter Laica
- Waterfilter Midea
- Waterfilter Smeg
- Waterfilter Solac
- Waterfilter Sunbeam
- Waterfilter Terraillon
- Waterfilter Ufesa
- Waterfilter Verbatim
- Waterfilter Zodiac
- Waterfilter Jata
- Waterfilter Jura
- Waterfilter Juwel
- Waterfilter Oase
- Waterfilter Imetec
- Waterfilter Fluval
- Waterfilter Eldom
- Waterfilter Aarke
- Waterfilter Ecowater
- Waterfilter Flama
- Waterfilter FIAP
- Waterfilter Pureit
- Waterfilter Everpure
- Waterfilter Consul
- Waterfilter T.I.P.
- Waterfilter MSR
- Waterfilter Billi
- Waterfilter LifeStraw
- Waterfilter Baracuda
- Waterfilter Waterdrop
- Waterfilter Zip
- Waterfilter Waterco
- Waterfilter Aquasure
- Waterfilter ZeroWater
- Waterfilter Beemur
- Waterfilter Ionmax
- Waterfilter Puretec
- Waterfilter Tunze
- Waterfilter Aqua Medic
- Waterfilter PUR
- Waterfilter Sera
- Waterfilter Oliveri
- Waterfilter Hydor
- Waterfilter Heissner
- Waterfilter Aquael
- Waterfilter LARQ
- Waterfilter Platypus
Nieuwste handleidingen voor Waterfilter
16 December 2024
10 December 2024
10 December 2024
10 December 2024
10 December 2024
10 December 2024
10 December 2024
10 December 2024
10 December 2024
10 December 2024