Yakima ForkLift Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Yakima ForkLift (24 pagina's) in de categorie Fietsendrager. Deze handleiding was nuttig voor 61 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/24
1033615D-1/24
IT IS CRITICAL THAT ALL YAKIMA RACKS AND ACCESSORIES BE PROPERLY AND SECURELY ATTACHED TO YOUR VEHICLE. IMPROPER
ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH TO YOU OR
TO OTHERS. YOU ARE RESPONSIBLE FOR SECURING THE RACKS AND ACCESSORIES TO YOUR CAR, CHECKING THE ATTACHMENTS
PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU MUST READ AND
UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS SUPPLIED WITH YOUR YAKIMA PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU
DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY
FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER.
FORKLIFT (1X)
LOCKING SKEWER (1X)
END CAP (1X)
VINYL CAP (1X)
CROSSBAR SPREAD
*CROSSBAR SPREAD
Your crossbar
spread is
the distance
between the
crossbars.
DO NOT EXCEED RACK WEIGHT LIMITS!
Forks with
Safety Tabs
DESIGNED FOR
FORKS WITH
SAFETY TABS.
Round
Bar
Load
Min. and
Max.
Crossbar
Spread* Limits
StreamLine
Bar
Type of
Rack
Square
Bar
16" - 42"
41cm - 107cm
1 or more
bikes
16” spread =
35 lbs. / bike
41cm spread
15.9Kg / bike
18" - 42"
46cm - 107cm
3 or more
bikes
18” spread =
40 lbs. / bike
46cm spread
15.9Kg / bike
90°
1033615D-2/24
Open jaws.
Attach ForkLift jaw to front crossbar.
Close jaws around crossbar.
Pass the t-bolt through the opening in lower
jaw. Rotate t-bolt to rest in slot.
Tighten the knob, but don’t tighten all the
way. Final tightening will occur after rear
clamp has been installed.
Open slider.
Use caution to avoid hardware damaging
roof’s ïŹnish. A towel placed on the roof prior
to installation can help avoid scratches.
Loosen knob.
Open locking slider, loosen knob, open jaw.
For low clearance crossbars:
Hold ForkLift at an angle
while positioning jaw around
crossbar to avoid any contact
with your vehicle’s roof.
For factory bars choose the best
position for most secure grip.
Adjust jaw if necessary.
(Upper notch for round
and square bars.)
If you don’t get a secure grip with
your factory bars adjust jaw.
A
B
C
90°
1033615D-3/24
Upper notch for round
and square bars.
For factory bars
choose the best
position for most
secure grip.
Close rear clamp
around crossbar.
Pass the t-bolt through the opening in bail.
Rotate t-bolt to rest in slot in bail.
Secure rear clamp.
Adjust clamp if necessary. If you don’t get a secure grip with
your factory bars adjust your clamp.
The rear clamp is conïŹgured for typical installations. In some situations adjustment may be
necessary if the wheel makes contact with the rear knob, or if the wheeltray cannot reach the wheel.
Wheel ahead of rear crossbar.
Wheel behind rear crossbar.
See next page for how-to.
OPTION A OPTION B
If changing the orientation of the rear
clamp still results in the rear wheel
contacting the knob, please contact our
customer service team (888-925-4621)
for a free, corrective adapter.


Product specificaties

Merk: Yakima
Categorie: Fietsendrager
Model: ForkLift

Heb je hulp nodig?

Als je hulp nodig hebt met Yakima ForkLift stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Fietsendrager Yakima

Handleiding Fietsendrager

Nieuwste handleidingen voor Fietsendrager