Yakima HalfBack 3 Handleiding

Yakima Fietsendrager HalfBack 3

Lees hieronder de πŸ“– handleiding in het Nederlandse voor Yakima HalfBack 3 (39 pagina's) in de categorie Fietsendrager. Deze handleiding was nuttig voor 72 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/39
BOTTOM
BOTTOM
PURCHASE
SEPARATELY:
TubeTop
Required for bikes with
step-through/Ladies
frames or bikes with
slanted top tubes.
Part #8002531
1035039F-1/39
HalfBack
TM
6X
1X 1X
1X
9X
CONTENTS β€’ CONTENU β€’ CONTENIDO
1X
HalfBack (2 Bike)
35 lbs / 15.9 kg max per bike.
70 lbs / 31.75 kg total.
HalfBack (3 Bike)
30 lbs / 13.6 kg max per bike.
90 lbs / 40.8 kg total.
PURCHASE
SEPARATELY:
TubeTopTM
Required for bikes with step-
through/Ladies frames or
bikes with slanted top tubes.
Part #8002531
1
www.fitlookup.yakima.com
2
1035039F-2/39
INSTALLATION β€’ MONTAGE β€’ INSTALLATION
3
‒ Rotate the center dial
toward the unlock icon
and raise the upper
frame arm.
‒ Set its position to
the HUB SETTING you
determined in step 1.
‒ Ensure that the center
dial returns to the
aligned position.
‒ Ensure that the upper
frame arm is locked into
the correct position.
Set the hub
Clean the vehicle
HUB SETTING
FIT NOTES
HUB SETTING
4
5
1035039F-3/39
Upper Frame:
‒ The position is relative to the lower frame and will depend
on vehicle shape.
‒ Any contact with a spoiler is not acceptable
Lower Frame:
‒ LOWER SUPPORT FRAME LOCATION IS EXTREMELY
IMPORTANT IN SUPPORTING THE LOAD!
‒ A common location is just above the bumper on the
bottom edge of the trunk or hatch.
‒ Use area with the greatest support.
‒ Do not place the lower frame on glass, plastic, or thin
metal.
‒ Many vehicle trunks and liftgates have a large section of
poorly supported metal that will dent under weight.
‒ Do not place HalfBack on vehicle’s emblem.
TO AVOID DAMAGE, ALWAYS POSITION
HALFBACK WHERE DETERMINED BY
YOUR VEHICLE SPECIFIC FIT NOTES .
Position the HalfBack
DID YOUR FIT NOTES
INDICATE YOU NEED
TO USE ANCHORS FOR
THE TOP HOOKS?
YES
NO
SKIP STEP 5 AND
PROCEED TO PAGE 4.
PROCEED TO STEP 5.
PROCEED TO PAGE 5.
‒ Using your body to help support the HalfBack
attach both top strap hooks around the top
edge of the trunk lid, hatch lid or rear door.
Tighten top straps until HalfBack is held in
place.
‒ You may need to attach hooks at a wider
section of the seam and then slide them into
their recommended place on the vehicle.
‒ Straps should be parallel, and no wider than
the body of the HalfBack. Route the straps
over the HalfBack frame.
‒ Not able attach the top hook? Use the anchor
configuration. Follow Anchor installation
instructions on PAGE 4.
‒ DO NOT ATTACH THE TOP HOOKS TO
PLASTIC OR TO A SPOILER. Use the Anchor
configuration instead. Follow Anchor
installation instructions on PAGE 4.
‒ DO NOT ATTACH THE TOP HOOKS TO GLASS.
Use the Glass Hatch Hooks (sold separately -
Yakima Part Number 8002612).
‒ REMOVE HOOKS BEFORE OPENING THE
HATCH OR TRUNK! Opening the hatch
or trunk with hooks installed could cause
damage to the vehicle.
Attach top hooks


Product specificaties

Merk: Yakima
Categorie: Fietsendrager
Model: HalfBack 3

Heb je hulp nodig?

Als je hulp nodig hebt met Yakima HalfBack 3 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Fietsendrager Yakima

Handleiding Fietsendrager

Nieuwste handleidingen voor Fietsendrager