Tripp Lite SK2UTRAVAM Handleiding

Tripp Lite Contactdoos SK2UTRAVAM

Lees hieronder de 📖 handleiding in het Nederlandse voor Tripp Lite SK2UTRAVAM (12 pagina's) in de categorie Contactdoos. Deze handleiding was nuttig voor 39 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/12

Owner’s Manual

Protect It!®

Surge Protectors

Important Safety Instructions 2

Installation 2

Warranty and Product Registration 3

Ultimate Lifetime Insurance Policy 4

Español 5

Français 9

1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support

® is a trademark of Tripp Lite.

PROTECT YOUR INVESTMENT!

and ultimate peace of mind.

You could also win an

ISOBAR6ULTRA surge protector—

a $100 value!

www.tripplite.com/warranty

18-08-292-932666.indb 1 9/12/2018 9:32:14 AM

SAVE THESE INSTRUCTIONS

CAUTION! DO NOT connect to an ungrounded outlet. DO NOT use with 2-wire extension

cords or adapters. This surge protector is designed for indoor use only. Install the

surge protector away from heat-emitting appliances such as radiators or heat

registers. Do not install where excessive moisture is present. Do not plug extension

cords into it. Never install electrical, telephone, network or coaxial wiring during a

lightning storm. Do not drill into any part of the housing or open the housing for any

reason. There are no user-serviceable parts inside.

Important Safety Instructions

Installation

• Use of this equipment in life support applications where failure of this equipment can

reasonably be expected to cause the failure of the life support equipment or to significantly

affect its safety or effectiveness is not recommended.

Mount Your Surge Protector (Optional Installation. Available on Select Models Only): If

desired, mount your surge protector on a wall or other sturdy, vertical surface. However, you

must mount the surge protector prior to connecting your equipment. Place a sheet of paper over

the surge protector’s mounting holes and mark their centers with a push pin. Next, place this

template over the desired area and mark with the push pins. Install screws (user supplied) into

the marks until ¼ in. (0.6 cm) of the screw heads are exposed. Mount the surge protector over

the screw heads and slide into place.

Connect Your Surge Protector to the AC Power Line: Plug the surge protector’s power cord

into a standard 3-wire grounded 120V AC outlet.

Turn Your Surge Protector ON: Press the surge protector’s power switch to “ON” or “RESET”

(depending on model). Select models feature an illuminated switch.

Check Your Surge Protector’s Diagnostic Indicator Lights (Available on Select Models

Only): If your surge protector features diagnostic LEDs, check them prior to connecting your

equipment. They will indicate various operating conditions when the surge protector is plugged

into a live 120V AC outlet and the surge protector’s power switch is on.

“PROTECTED” LED: Indicates the surge suppression components are intact and providing

complete protection against surges. If this LED does not illuminate, some of the surge

suppression components are not functioning, and the unit should be replaced.

Visit www.tripplite.com/support.

“GROUNDED” LED: Indicates wall outlet is grounded and surge protection can properly

function. If this light DOES NOT illuminate and power is present, consult a qualified electrician

to examine your outlet’s wiring.

“LINE OK” LED (select models): Indicates 120V AC power is present with no wiring faults

detected.

Connect Your Equipment to the Surge Protector’s AC Outlets: Plug your equipment’s power

cords (including 2-wire devices) into the surge protector’s AC outlets. Select models feature

integrated safety covers which cover the outlets when not in use. Other models feature special

widely-spaced outlets to accommodate transformers without covering other outlets. DO NOT plug

in extension cords. DO NOT OVERLOAD the surge protector’s outlets. The surge protector can

accommodate a total equipment load of up to 15 amps (whether plugged into a single outlet or

spread out over multiple outlets). If the load on the surge protector exceeds 15 amps, the circuit

breaker* will trip and the outlets will stop providing power. If the circuit breaker trips, reduce the

load by unplugging some devices. Depress the circuit breaker to reset.

* Circuit breakers are integrated into the power switch on select models and offered as a separate feature on other models.

18-08-292-932666.indb 2 9/12/2018 9:32:14 AM

Installation

USB Charging Ports: USB charging ports are capable of delivering ample power to even the

most demanding devices, including smartphones, tablets, MP3 players, etc. Total USB charging

output varies by model.

Connect Your Equipment to the Surge Protector’s Phone Jacks (Optional Installation.

Available on Select Models Only): Connect a phone cable from the wall jack directly to the

surge protector’s RJ-style phone jack labeled “IN.” Connect a phone cable from the surge

protector’s RJ-style phone jack labeled “OUT” directly to the device to be protected. Select

models feature two “OUT” jacks; either one or both of the jacks may be used, but protection is

for a device or devices sharing a single line only. All models with phone line surge protection,

except the TLP810NET, protect devices on a single line only. TLP810NET models feature a single

set of RJ-style phone jacks which protect devices on two lines. The surge protector must always

be the first item connected in line from the wall jack. The surge protector must be plugged into

a 3-wire grounded AC outlet for phone line surge protection to work.

Connect Your Equipment to the Surge Protector’s Network Jacks* (Optional Installation.

Available on Select Models Only): Connect a data cord from the wall jack or cable/DSL

modem directly to the surge protector’s network jack labeled “IN.” Connect a data cord from the

surge protector’s network jack labeled “OUT” directly to the device to be protected (typically a

computer’s network interface card).

The surge protector must always be the first item connected in line from the Ethernet source

(typically a wall jack). The surge protector must be plugged into a 3-wire grounded AC outlet for

network line surge protection to work.

Connect Your Equipment to the Surge Protector’s Coaxial Jacks (Optional Installation.

Available on Select Models Only): Connect a coaxial cable from the wall jack directly to the

surge protector’s “F” style coaxial jack labeled “IN.” Connect a coaxial cable from the surge

protector’s “F” style coaxial jack labeled “OUT” directly to the device to be protected. Select

models include a second set of coaxial jacks for simultaneous connection and protection of

devices on two separate lines (cable, antenna or satellite). The surge protector must always be

the first item connected in line from the coaxial wall jack. The surge protector must be plugged

into a 3-wire grounded AC outlet for coaxial line surge protection to work.

* 10/100 BaseT/TX, Token Ring. Not compatible with PoE (Power Over Ethernet) applications.

Warranty and Product Registration

Lifetime Limited Warranty

Seller warrants this product, if used in accordance with all applicable instructions, to be free from original defects in material and

workmanship for its lifetime. If the product should prove defective in material or workmanship within that period, Seller will repair

or replace the product, in its sole discretion. Service under this Warranty can only be obtained by your delivering or shipping the

product (with all shipping or delivery charges prepaid) to: Tripp Lite, 1111 W. 35th St., Chicago, IL 60609. Seller will pay return

shipping charges.

The warranties of all TRIPP LITE surge protectors are null and void if they have been connected to the output of any UPS system.

The warranties of all TRIPP LITE UPS Systems are null and void if a surge protector has been connected to its output receptacles.

THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT, MISUSE, ABUSE OR

NEGLECT. SELLER MAKES NO EXPRESS WARRANTIES OTHER THAN THE WARRANTY EXPRESSLY SET FORTH HEREIN. EXCEPT TO

THE EXTENT PROHIBITED BY APPLICABLE LAW, ALL IMPLIED WARRANTIES, INCLUDING ALL WARRANTIES OF MERCHANTABILITY

OR FITNESS, ARE LIMITED IN DURATION TO THE WARRANTY PERIOD SET FORTH ABOVE; AND THIS WARRANTY EXPRESSLY

EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL DAMAGES. (Some states do not allow limitations on how long an implied

warranty lasts, and some states do not allow the exclusion or limitation of incidental or consequential damages, so the above

limitations or exclusions may not apply to you. This Warranty gives you specific legal rights, and you may have other rights which

vary from jurisdiction to jurisdiction.)

WARNING: The individual user should take care to determine prior to use whether this device is suitable, adequate or safe for the

use intended. Since individual applications are subject to great variation, the manufacturer makes no representation or warranty

as to the suitability or fitness of these devices for any specific application.

Product Registration

Visit www.tripplite.com/warranty today to register your new Tripp Lite product. You'll be automatically entered into a drawing for a

chance to win a FREE Tripp Lite product!*

* No purchase necessary. Void where prohibited. Some restrictions apply. See website for details.

18-08-292-932666.indb 3 9/12/2018 9:32:14 AM

Product specificaties

Merk:	Tripp Lite
Categorie:	Contactdoos
Model:	SK2UTRAVAM
Kleur van het product:	Zwart
Gewicht:	10 g
Breedte:	71.1 mm
Diepte:	33 mm
Hoogte:	88.9 mm
Type stekker:	Type B
Gewicht verpakking:	300 g
Breedte verpakking:	94 mm
Diepte verpakking:	59.9 mm
Hoogte verpakking:	175.3 mm
Gebruikershandleiding:	Ja
LED-indicatoren:	Ja
Stroom:	10 A
Type stroombron:	AC
Land van herkomst:	China
Aantal USB 2.0-poorten:	2
Certificering:	CAN/CSA-C22.2 No. 60950-1:2007 (2nd Ed) + A1:2011+A2:2014, UL 60950 - 1:2007 (2nd Ed) +a1 + A2 R10.14
Materiaal:	Kunststof
Duurzaamheidscertificaten:	REACH, RoHS
Aantal per verpakking:	1 stuk(s)
Ingangsspanning:	110 - 240 V
Frequentie:	60 Hz
Naleving van duurzaamheid:	Ja
Automatische uitschakeling:	Ja
Maximaal vermogen:	1250 W
USB Power Delivery:	Ja
USB Power Delivery tot max.:	17 W
Type oplader:	Binnen
Lader compatibiliteit:	Universeel
(Buitenste) hoofdverpakking hoogte:	273 mm
(Buitenste) hoofdverpakking breedte:	206.4 mm
(Buitenste) hoofdverpakking brutogewicht:	3290 g
(Buitenste) hoofdverpakking lengte:	196.8 mm
Hoeveelheid per (buitenste) hoofdverpakking:	10 stuk(s)
GTIN (EAN/UPC)-nummer (buitenste) hoofdverpakking:	10037332265767
Stopcontact type:	Type B
Aantal stopcontacten:	2
Poort 1 uitgangsstroom:	3.4 A
Poort 2 uitgangsstroom:	3.4 A