STI -6404 Handleiding

STI Rookmelder -6404

Lees hieronder de 📖 handleiding in het Nederlandse voor STI -6404 (9 pagina's) in de categorie Rookmelder. Deze handleiding was nuttig voor 65 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/9

Description:

This system contains a STI-6400 with a DPDT key switch

to be mounted on one side of a door or wall; and a

similar looking housing, also with a DPDT key switch,

but without an alarm for the opposite side of the door.

An authorized person with a key can disable the alarm

on either side of the door. When disabled, and LED will

illuminate, and the door can be opened without setting

off the alarm. After passing through the door, the

alarm can be armed again from the opposite side.

Installation:

1. Follow STI-6400 mounting instructions and set

switches to the desired positions for alarm timing

and volume.

2. For straight through door or wall installation, mark

the center of the 5/16 inch hole in the mounted

base, then remove the base from the door or wall.

3. Drill a 5/16 inch diameter hole through the door or

wall at the marked location.

4. Align the same diameter hole in the secondary unit

base to the back side of the door or wall and

mount.

5. Route the wire from the STI-6400 unit through the

hole and into the secondary unit.

6. Attach the 6 wires to the terminal block pins 2 thru

7 matching wire colors on the terminal block label.

7. Seal the hole around the wires with an effective

fire stop material, if required.

8. Attach the battery in the secondary unit and install

the cover.

9. Cycle the key switch to be sure the LED’s turn “ON”

and “OFF”. Leave the LED’s “ON” until ready to test

the alarm.

10. Attach the battery to the STI-6400 and install the

cover.

11. Close the door and test.

Operation:

1. With the door closed, turn either key switch to arm

the alarm. The LED’s on both sides of the door

should turn “OFF”.

2. If the door is opened while the LED’s are “OFF”,

then the alarm will sound according to the switch

settings of the STI-6400.

3. To reset the alarm, turn either key to the opposite

position (the LED’s will turn “ON”), close the door

and turn either key switch again (the LED’s will turn

“OFF”).

4. When the system is armed, authorized passage can

be accomplished by turning either key switch until

the LED’s turn “ON”, and remove key. The door can

now be opened without sounding the alarm. When

passage is complete, close the door, turn the key

switch (the LED’s will turn “OFF”). The door alarm

is once again armed.

Addendum for STI-6406 with Dual Access Control

Schematic Diagram:

13 February 2017

- 1 -

Exit Stopper®

STI-6400 Series

Features

· Alarm helps prevent unauthorized exits/entries through doors.

· Easy to install.

· Select volume, alarm duration and delay settings.

· May be mounted on top, right, left or next to almost any door.

· User can select on-site whether to use an alarm or annunciator.

· Less expensive than heavy horizontal bar type units and practical for all

emergency doors.

· Contact STI for custom applications.

We protect the things that protect you.®

- 2 -

Table of Contents

· Warnings and Cautions Page 2 ...........................................................................................

· Warranty Information Page 2 ...............................................................................................

· Speciﬁcations ......................................................................................................... Page 3

1. Dimensions Page 3 .........................................................................................................

2. Polycarbonate Page 3 .....................................................................................................

3. Electronics Page 3 ..........................................................................................................

4. Remote Horn Page 3 ......................................................................................................

· Circuit Board Set-Up Page 4 ...............................................................................................

· Terminal Strip Layout Page 4 ...............................................................................................

· Switch Settings Page 4 .......................................................................................................

· Alarm Feature Description Page 5 .......................................................................................

· Installation Instructions All Units / STI-6400 Page 5 .............................................................

· Mounting Options Page 6 ...................................................................................................

· STI-6402 Double Door additional install notes Page 6 .......................................................

· STI-6403 Remote Horn additional install notes Page 6 ......................................................

· STI-6404 Double Door with Remote Horn additional install notes Page 6 ..........................

· STI-6405 Exit Stopper with Momentary Reset Page 6 .......................................................

Warnings

All units are recommended for indoor use, not for outdoor use. Unit must be tested periodically

to verify the life of battery. STI recommends you change the 9 Volt battery twice a year. Installer

may need to purchase a simple audio-meter, typically available at your local electronics store,

to measure the sound in areas where the alarm is expected to be heard during normal noise

environment. Results from this test may prove it beneﬁcial to purchase additional exit stopper

units. When purchasing a remote unit (STI-6403 or STI-6404) you will need to periodically test

the connections to make sure audibles function at a sound level to alert staff. Maximum of

three remote alarms may be used in parallel.

All speciﬁcations and information shown are current as of publication and subject to change

without notice.

Warranty Information

· Three year guarantee against breakage of polycarbonate in normal use (one year on electro

mechanical and electronic components).

· Electronic warranty form at www.sti-usa.com/wc14

Product specificaties

Merk:	STI
Categorie:	Rookmelder
Model:	-6404
Type stroombron:	DC
Koolmonoxidemelder:	Nee
Hoorbaar alarmtype:	Brandhoorn/-sirene
AC-ingangsspanning:	9 V
Brandmeldcentrale:	Nee
Rookmelders:	Nee
Alarm decibels:	105 dB
Hittedetector:	Nee
Geluidsalarmeenheid voor noodgevallen:	Nee