Soundmaster PL875USBV2 Handleiding


Lees hieronder de πŸ“– handleiding in het Nederlandse voor Soundmaster PL875USBV2 (11 pagina's) in de categorie Platenspeler. Deze handleiding was nuttig voor 33 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/11
This symbol indicates the presence of dangerous
voltage inside the enclosure, sufficient enough to
cause electric shock.
This symbol indicates the presence of important
operating and maintenance instructions for the
device.
Safety, Environmental and Setup Instructions
x Use the device in dry indoor environments only.
x Protect the device from humidity.
x Do not open the device. RISK OF ELECTRIC SHOCK! Refer opening and servicing to qualified personnel.
x Connect this device to a properly installed and earthed wall outlet only. Make sure the mains voltage corresponds with
the specifications on the rating plate.
x Make sure the mains cable stays dry during operation. Do not pinch or damage the mains cable in any way.
x A damaged mains cable or plug must immediately be replaced by an authorized service center.
x In case of lightning, immediately disconnect the device from the mains supply.
x Children should be supervised by parents when using the device.
x Clean the device with a dry cloth only.
Do NOT use CLEANING AGENTS or ABRASIVE CLOTHS!
x Do not expose the device to direct sunlight or other heat sources.
x Install the device at a location with sufficient ventilation in order to prevent heat accumulation.
x Do not cover the ventilation openings!
x Install the device at a safe and vibration-free location.
x Install the device as far away as possible from computers and microwave units; otherwise radio reception may be
disturbed.
x Do not open or repair the enclosure. It is not safe to do so and will void your warranty. Repairs only by authorized
service/ customer center.
x The device is equipped with a β€œClass 1 Laser”. Avoid exposure to the laser beam as this could cause eye injuries.
x Only use mercury and cadmium-free batteries.
x Used batteries are hazardous waste and NOT to be disposed of with the household waste!!! Return the batteries to your
dealer or to collection points in your community.
x Keep batteries away from children. Children might swallow batteries. Contact a physician immediately if a battery was
swallowed.
x Check your batteries regularly to avoid battery leakage.
CLASS 1 LASER PRODUCT
KLASSE 1 LASER PRODUKT
LUOKAN 1 LASER LAITE
KLASS 1 LASER APPARAT
PRODUCTO LASER CLASE 1
CAUTION - INVISIBLE LASER RADIATION WHEN OPENING
THE COVER OR PRESSING THE SAFETY INTERLOCK. AVOID
EXPOSURE TO THE LASER BEAM.
ENVIRONMENTAL PROTECTION
Do not dispose of this product with the normal household waste at the end
of its life cycle. Return it to a collection point for the recycling of electrical
and electronic devices. This is indicated by the symbol on the product,
user manual or packaging.
The materials are reusable according to their markings. By reusing, recycling or
other forms of utilization of old devices you make an important contribution to
the protection of our environment.
Please contact your local authorities for details about collection points.
WARNING
Risk of electric shock
Do not o
p
en!
Caution: To reduce the risk of electric shock, do not remove the cover (or back). There
are no user serviceable parts inside. Refer servicing to qualified service personnel.
Used batteries are hazardous waste and NOT to be disposed
of with the household waste! As a consumer you are legally
obligated to return all batteries for environmentally responsible
recycling – no matter whether or not the batteries contain harmful
substances*).
Return batteries free of charge to public collection points in your
community or to shops selling batteries of the respective kind.
Only return fully discharged batteries.
*) marked Cd = cadmium, Hg = mercury, Pb = lead
E-1
LOCATION OF CONTROLS
1) DUST COVER
2 ) LCD DISPLAY
3 ) CD TRAY OPEN/CLOSE BUTTON
4 ) CD TRAY
5) 3.5MM AU IN ACKX J
6) 3.5MM HEADPHONE JACK
7 ) PANEL COVER
8 ) USB SOCKET
9 ) SD/MMC CARD SLOT
1 )0 STANDBY LED INDICATOR
11) POWER ON/STANDBY BUTTON
1 )2 FUNCTION BUTTON
1 )3 MEMORY/CLOCK-ADJUST BUTTON
1 )4 FOLDER/PRE-UP BUTTON
1 )5 RECORD BUTTON
1 ) E6 JECT BUTTON
1 ) /7 BAND PLAY/PAUSE BUTTON
1 )8 TUNING/SKIP UP /
1 )9 STOP BUTTON
20) TUNING/SKIP DOWN BUTTON
2 1) ST/MONO-PLAY MODE BUTTON
22) PRESET EQ BUTTON
23 ) VOLUME UP/DOWN BUTTON
24) REMOTE SENSOR
25) SPINDLE ADAPTOR
26 ) STROBE ILLUMINATOR
27) ALIGNMENT SCREW WITH RUBBER COVER
28) COUNTER WEIGHT
29) ANTISKATING
30) CUEING LEVER
3 1) TONE-ARM LOCK
32) TURNTABLE SPEED SELECTOR
33) PITCH AD USTMENTJ
34) SPEAKER TERMINAL (L/R)
35) LINE OUT SOCKET (L/R)
36) 75 OHM FM SOCKET
37) AC CORD
CAUTION:
USAGE OF CONTROLS OR AD USTMENTS OR J PERFORMANCE OF PROCEDURES OTHER THAN THOSE
SPECIFIED HEREIN MAY RESULTE ARDOUS RADIATION POSURE. IN HAZ XE
THIS J UNIT SHOULD NOT BE AD USTED OR REPAIRED BY ANYONE CEPT QUALIFIED SERVICE XE
PERSONNEL.
PRECAUTIONS FOR USE
INSTALLATION
β€’ UNPACK ALL PARTS AND REMOVE MATERIAL. PROTECTIVE
β€’ DO NOT CONNECT THE UNIT TO THE MAINS BEFORE CHECKING THE MAINS VOLTAGE AND BEFORE
ALL OTHER CONNECTIONS HAVE BEEN MADE.
β€’ DO NOT COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE OF SEVERAL CENTIMETERS
AROUND THE UNIT FOR VENTILATION.
INSTALLATION OF COUNTER WEIGHT
1. SLIDE IN COUNTER WEIGHT THE COMPLETELY INTO THE REAR OF THE TONE ARM UNTIL IT REACH
THE TURN ENDˈ IT CLOCKWISE UNTIL IT CLICK WITH PIT INSIDE.
2 . TWIST THE COUNTER WEIGHT CLOCKWISE & BACKWARD UNTIL IT REACH THE WHITE LINE AS FIGURE
2
3 . TWIST THE COUNTER MARKING UNTIL IT REACH β€œ 1 β€œ POSITION
4 . TWIST THE COUNTER WEIGHT ANTI-CLOCKWISE & INWARD UNTIL IT REACH THE APPROPIATE
WORKING PRESSURE.
E-2
REMARK : THE WORKING PRESSURE OF THE Y PROVIDED ST LUS IS FROM THE RANGE 4 – 6 GRAMS
ACCORDING TO THE CARTRIDGE MANUFACTURER. ALL Y ST LUS HAS IT OWN WORKING
PRESSUE AND PLEASE REFER TO THE SPECIFICATION RESPECTIVELY.
CONNECTION
1. CONNECT THE POWER CORD AC OUTLET AND CONNECT SPEAKER WIRE (37) TO THE TO THE
SPEAKER TERMINAL (34) LOCATED ON THE UNIT. REAR SIDE OF
2 . PRESS THE POWER BUTTON (11) AND STANDB IF Y LED INDICATOR (1 LIGHT OFF, IT MEAN 0 ) ’ S THE
POWER SUPPL Y IS NORMAL. NOW OUR PLA Y YS STEM IS READY TO Y THE MUSIC.
SETTING THE CLOCK
1. SET UNIT IN STANDB Y MODE.
2 . PRESS & HOLD THE 3 β€œMEM/CLK-ADJ” BUTTON (1 ), THE LCD DISPLAY ( ) WILL SHOW β€œ SET CLOCK β€œ2 AND
THEN DISPLAY β€œ 1 β€œ 2HR OR HR 24 PRESS SKIP OR SKIP BUTTON (1 SELECT 8 /20) TO THE
APPROPIATE AREA HOUR FORMAT(12HR/ HR). (124 PRESS β€œMEM/CLK-ADJ” BUTTON 3 ) AGAIN TO
CONFIRM.
3 2 . THE LCD ( ) WILL DISPLAY THE FIRST & SECOND DIGIT OF β€œ00” IS FLASHING. SKIP PRESS OR
SKIP BUTTON / ) (18 20 TO SET THE CORRECT 3 HOUR. PRESS ”MEM/CLK-ADJ” BUTTON (1 ) TO STORE
THE CORRECT HOUR.
4 . THE THIRD FOURTH DIGIT OF IS FLASHING, PRESS & β€œ00” THE SKIP OR SKIP BUTTON (18 /20) TO
SET THE CORRECT MINUTES. THEN 3 PRESS β€œMEM/CLK-AD (1J” ) TO STORE THE CORRECT MINUTE.
ΒΎ THE PRE-SET TIME WILL BE RE-SET COMPLETELY IF DIS-CONNECTING THE MAIN POWER
SUPPLY. YOU ARE RECOMMENDED SWITCH TO THE STEM INTO STANDB YS Y MODE FOR
CONVENIENCE USAGE.
LISTENING TO RADIO
MANUAL TUNING
1. PRESS (1 ) FUNCTION BUTTON 2 TO SELECT β€œ TUNER MODE. ”
2 . PRESS β€œBAND / ” BUTTON 7 (1 ) TO SELECT DESIRED BAND (MW OR FM).
3 . TUNE TO THE REQUIRED STATION PRESSING THE TUNING SKIP UP BY β€œ / 8 OR DOWN (1 /20)
BUTTON.
4 J . AD UST VOLUME CONTROL (23) TO THE DESIRED VOLUME LEVEL.
AUTO TUNING
1. PRESS FUNCTION BUTTON (1 ) 2 TO SELECT β€œ TUNER β€œ MODE
2 . PRESS β€œ BAND / ” BUTTON (17 ) AND SELECT THE DESIRED BAND (MW (AM) OR FM).
3 . PRESS AND HOLD THE β€œ SKIP / TUNING UP 8 OR DOWN (1 /20) BUTTON FOR 1- SECONDS2 AND
THEN RELEASE
4 . THE UNIT WILL START SEEKING AUTOMATICALLY AND STOP UNTIL A RADIO STATION IS REACHED.
5 . REPEAT UNTIL STEP 3 & 4 THE DESIRED RADIO STATION IS BEING REACHED.
6 J . AD UST VOLUME UP/DOWN CONTROLS (23) TO THE DESIRED VOLUME LEVEL.
PRESET STATIONS
Y OU CAN STORE UP TO TOTAL OF 40 RADIO STATIONS (30 FM,10 AM) IN THE MEMORY.
1. SET TO β€œ TUNER β€œ MODE
2 . TURN TO THE DESIRED RADIO STATION MANUAL OR β€œAUTO BY β€œβ€ ” TUNING METHOD.
3 3 . PRESS β€œ MEM / CLK-ADJ” BUTTON (1 ) TO ENABLE PROGRAM STATE.
4 . PRESS β€œ FOLDER / PRE-UP 4 (1 ) OR FOLDER / PRE-DOWN BUTTON (AT HANDSET) REMOTE TO
SELECT THE DESIRED STATION POSITION MEMORY FOR STORAGE.
5 3 . PRESS β€œMEM / CLK-ADJ ” BUTTON (1 ) AGAIN TO CONFIRM THE SETTING.
6 . REPEAT STEP 2 TO 5 TO STORE OTHER STATIONS.
7 . PRESS β€œ FOLDER / PRE-UP OR DOWN β€œ BUTTON AT REMOTE HANDSET TO SELECT THE PRESET
STATIONS IN ORDER.
8 . TO RETURN NORMAL TUNER MODE, LEAVE KE FREE. Y S


Product specificaties

Merk: Soundmaster
Categorie: Platenspeler
Model: PL875USBV2

Heb je hulp nodig?

Als je hulp nodig hebt met Soundmaster PL875USBV2 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Platenspeler Soundmaster

Handleiding Platenspeler

Nieuwste handleidingen voor Platenspeler