SkyRC E6 Handleiding

SkyRC Batterij-oplader E6

Lees hieronder de 📖 handleiding in het Nederlandse voor SkyRC E6 (5 pagina's) in de categorie Batterij-oplader. Deze handleiding was nuttig voor 34 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/5

Thank you for your choice of the SKYRC e6, 100-240V AC balance charger. This unit is simple to use but

its operation does require some knowledge on the part of the user. Please read this entire operating

manual completely and attentively before using this product, as it covers a wide range of information on

operating and safety.

SKYRC e6 Charger is an economic, high quality 100-240V AC balance charger, designed for charging

LiPo and LiFe batteries from 2-6 cells in balance mode. The circuit power is 50W and max charge current

can reach to 5A. There are four kinds of charge current 1A/2A/4A/5A that can be selected. You could

select the proper charge current according to battery capacity.

INSTRUCTION MANUAL

INTRODUCTION

CHARGE PROCEDURES

SKYRC e6 comes with the built in power supply. You can connect the AC power cord to the AC socket

(100-240V AC) directly.

Note: This charger can charge LiPo and LiFe batteries ONLY in balance mode. In this case, you must use

balance board to connect the charger with the battery.

Insert the AC power cord into the charger.

Insert the AC cord into a wall socket (100-240V). All LEDS will light for 1 second and the charge

status LED will flash green which indicates the charger is ready to charge.

Select the battery type LiPo/LiFe by the toggle switch.

Select the proper charging current 1A/2A/4A/5A by the toggle switch.

Connect the battery to the charger main battery lead to battery socket and balance wires to balance

socket.

The charger starts charging. The charge status LED and the cell status LED will glow constant red. If

the battery pack is 2-cell, Cell 1 and Cell 2 LEDs will glow constant red; if the battery pack is 3-cell,

Cell 1, Cell 2 and Cell 3 LEDs will glow constant red; and so on.

During the charging progress, when the charge

status LED glows constant red, the charger is

charging in CC mode; when the charge status

LED glows constant orange, the charger is

charging in CV mode;

When the cell LED is flashing, this cell is

discharging for balancing.

When the battery is fully charged, the charge

status LED will glow constant green.

Unplug the battery from the charger and the

charge status LED will flash green which

indicates the charger is ready to charge

another battery.

Please refer to following steps to charge the battery,

EXPLANATION OF LED STATUS

If the charger encounters a problem, all LEDs will flash red in sequence to alert you to the errors. In this

case, please disconnect the power cord from the wall socket and unplug the battery from the charger.

* Error Message

- - - -1 2



SPECIFICATION

AC Input

Battery Type

Cell Count

Charge Current

Circuit Power

Current Drain for Balancing

Dimension

Weight

Charger/Cell Status

100-240V

LiPo/LiFe

2-6 cells

1A/2A/4A/5A ± 10%

50W

200mA

82.7x140.5x45.7mm

310g

SK-100052

This diagram shows the correct way to connect your

battery to the e6 charger while charging in balance

mode.

Failure to connect as shown in this diagram will

damage this charger.

The main battery leads must be connected along with

the balance lead connector as shown before charging

your battery.

CAUTION:

LED flashes green

LED glows constant red

LED glows constant orange

LED glows constant green.

LED glows constant red.

LED flashes red

The charger is ready to charge.

The charger is charging in CC mode.

The charger is charging in CV mode.

The charging process finishes.

The cell is charging.

The cell is discharging.

Charge Status LED

Cell Status LED

CONNECTION DIAGRAM

Battery Type Switch

Cell 3 LED Indicator

Cell 2 LED Indicator

Cell 1 LED Indicator

Cell 6 LED Indicator

Cell 5 LED Indicator

Cell 4 LED Indicator

Charge Current Switch

Charge Status LED Indicator

Battery Socket

Balance Socket

100-240V

Power Jack

Charger

Balance

Adaptor

Battery

10)

7504-0253-02

Manufactured by

SKYRC TECHNOLOGY CO ., LTD.

www skyrc com. .

- - - -3 4

THE SET CONTAINS WARNING AND SAFETY NOTES

SKYRC e6 is suitable for charging rechargeable LiPo/LiFe batteries. Do not attempt to recharge dry

cells. Charging other types of batteries may cause fire or explosion.

Never leave the charger unattended when it is connected to its power supply.

The allowable AC input voltage is 100-240V AC. Never connect it to any other voltage.

Protect charger from dust, dirt and damp.

Never place the charger and batteries connected to it on any form of flammable surface. Never

operate the charger in the vicinity of inflammable material or gas.

Ensure that there is an unrestricted airflow to and from the charger's cooling slots. Never place the

charger on a carpet or similar surface.

Take great care to maintain correct battery polarity, and avoid shot-circuit. Read the battery

manufacturer's instructions and adhere to them strictly.

WARRANTY AND SERVICE

We guarantee this product to be free of manufacturing and assembly defects for a period of one year

from the time of purchase. The warranty only applies to material or operational defects, which are present

at t he time of purchase. During that period, we will repair or replace free of service charge for products

deemed defective due to those causes.

You will be required to produce proof of purchase (invoice or receipt). This warranty is not valid for any

damage or subsequent damage arising as a result of misuse, modification or as a result of failure to

observe the procedures outlined in this manual.

LIABILITY EXCLUSION

This charger is designed and approved exclusively for use with the types of battery stated in these

Instruction Manual. SKYRC accepts no liability of any kind if the charger is used for any purpose other

than that stated. We are unable to ensure that you follow the instructions supplied with the charger, and

we have no control over the methods you employ for using, operating and maintaining the device. For this

reason we are obliged to deny all liability for loss, damage or costs which are incurred due to the

incompetent or incorrect use and operation of our products, or which are connected with such operation

in any way. Unless otherwise prescribed by law, our obligation to pay compensation, regardless of the

legal argument employed, is limited to the invoice value of those SKYRC products which were

immediately and directly involved in the event in which the damage occurred.

CONFORMITY DECLARATION

SKYRC e6 satisfies all relevant and mandatory EC directives and FCC Part 15 Subpart B: 2008.

The product has been tested to meet the following technical standards:

Conform

CE-LVD

CE-EMC

EN60335

FCC-VOC FCC Part 15B

This symbol means that you must dispose of electrical devices from the general household

waste when it reaches the end of its useful life. Take your charger to your local waste

collection point or recycling centre. This applies to all countries of the European Union, and to

other European countries with a separate waste collection system.

Electromagnetic compatibility (EMC) -- Part 6-3:

Genericstandards - Emission standard for residential,

commercial andlight-industrial environments.

Electromagnetic compatibility (EMC) -- Part 6-1: Generic

standards - Immunity for residential, commercial and

light-industrial environments.

Electromagnetic compatibility-Requirements for

household appliances,electric tools and Similar

apparaturs - Part 2: Immunity-Product family standard

Electromagnetic compatibility-Requirements for

household appliances,electric tools and Similar

apparaturs - Part 1: Emission

EN 55014-1:2006

EN55014-2:1997

+A1:2001

EN61000-6-1(2007)

EN61000-6-3(2007)

Test Standards Title Result

For safety of household and similar electrical appliances.

Electromagnetic compatibility (EMC), Conduction Emission

& Radiation Emission.

Conform

RECOMMENDED ACCESSORIES

SkyRC e6 Charger

AC Power Cord

18AWG Wire Charging Cable

Balance Adaptor

HP/PQ AdaptorXH AdaptorEH Adaptor TP/FP Adaptor

SK-600014-01 SK-600020-04 SK-600018-02 SK-600016-03

Tamiya charging cable

5201-0030-01

TRAXXAS charging cable

Glow charging cable EC3 charging cable Crocodile clip

charging cable

5201-0033-01 5201-0045-01 5201-0034-01

5201-0031-01

Dean charging cable

5201-0012-01

Futaba RX charging cable

JST/BEC charging cable

5201-0044-015201-0043-01

Product specificaties

Merk:	SkyRC
Categorie:	Batterij-oplader
Model:	E6
Kleur van het product:	Zwart
Gewicht:	310 g
Breedte:	82.7 mm
Diepte:	140.5 mm
Hoogte:	45.7 mm
Soort:	Batterijlader voor binnengebruik
Aantal per verpakking:	1 stuk(s)
Ingangsspanning:	100-240 V
Frequentie:	50/60 Hz
Compatibele batterij technologiën:	Lithium-Polymeer (LiPo)
Aantal batterijcellen:	6
Oplaadstroom:	1A, 2A, 4A, 5A
Uitvoer:	50W