Shadow SH950 Handleiding

Shadow Niet gecategoriseerd SH950

Lees hieronder de 📖 handleiding in het Nederlandse voor Shadow SH950 (1 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/1

Kupferfolie

Sensor

Fax: (561) 743 0460

eMail: jjmelch@shadow-pickups.com

Shadow Elektroakustik

Peter-Haendel Straße 2

91334 Hemhofen · Germany

Shadow Electronics of America Inc.

17791 Alexander Run

Jupiter, FL 33478 U.S.A.

Fax: +49 - 91 95 - 92 99 30

eMail: info@shadow-electronics.com

Installation Instruction for Shadow SH 950

Double Side Upright Bass Pickup

Fig. 1Fig. 1

Fig. 2Fig. 2

Content:Content:

2 Upright Bass Transducer with 6.5 mm (1/4”)

output socket and mounting adhesive,

Copper Foil Tape,

Cable Holder

2 Upright Bass Transducer with 6.5 mm (1/4”)

output socket and mounting adhesive,

Copper Foil Tape,

Cable Holder

Note:

Piezo pickups and transducers have a very high output impedance. In order to get the optimum sound output we recommend

an amplier with low impedance input.

Note:

Piezo pickups and transducers have a very high output impedance. In order to get the optimum sound output we recommend

an amplier with low impedance input.

3. Install the sensors into the bridge slots.

4. Locate the output socket in a convenient location on the instrument and attach with applied double sided adhesive.

5. Connect to appropriate amplier with instrument cable.

3. Install the sensors into the bridge slots.

4. Locate the output socket in a convenient location on the instrument and attach with applied double sided adhesive.

5. Connect to appropriate amplier with instrument cable.

1. Test t sensors into the slot between the wing and foot.

Pickup should t tightly for best output (see g 1).

1. Test t sensors into the slot between the wing and foot.

Pickup should t tightly for best output (see g 1).

2. If pickup is too loose, shim with included shim material (see fig 2 ). If pickup is too high, file the bridge slot slightly.2. If pickup is too loose, shim with included shim material (see fig 2 ). If pickup is too high, file the bridge slot slightly.