Prem-i-air EH1442 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Prem-i-air EH1442 (8 pagina's) in de categorie Heater. Deze handleiding was nuttig voor 53 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
EH1442
2 kW Mica Column Heater
2 Heat settings
Electronic thermostat with remote control
Built-in carrying handle
Durable Castors
Safety overload cut-out
Cable storage feature
Page 1
IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the
user of the product for future reference.
BEFORE USE
You must inspect the appliance including its cable and plug for any
signs of damage. If the product is damaged, DO NOT use it, and
contact your supplier immediately.
INSTALLATION
Attaching the feet and castors.
Turn the appliance upside down and hold it steady.
Slide the foot into the base of the appliance adjacent to the
mains cable entry. A click will be heard when it is correctly
aligned.
Slide the castor and axle assembly into the base of the
appliance at the opposite end. Again, a click will be heard
when it is correctly aligned.
Return the appliance to the upright position.
OPERATION
Plug the mains lead into a 13 Amp mains socket.
If connecting via an extension lead, make sure that the lead
is rated at 13 Amps or more, and that it is fully unwound.
Switch the appliance on at the mains socket.
Turn on the rocker switch at the side of the appliance
adjacent to the mains cable entry.
The display will light briefly.
Press the button to switch the appliance ON.
Page 2
The digital display will display the
room temperature.
The up- and down-arrow buttons can
be used to select full power or half
power. This is indicated by the
segments to the right of the flame
symbol. Small segment lit = half
power. Both segments lit = full power.
To set the thermostat press the
TEMP button, then press the up- or
down-arrow buttons to change the
target temperature. The thermometer symbol will illuminate,
and the digital display will flash, showing the target
temperature. After 5 seconds the display will stop flashing
and return to displaying the room temperature.
To set the timer press the TIMER button. The clock symbol
will illuminate. Then use the up- and down-arrow buttons to
set the number of hours for which the heater is to run before
automatically switching off.
Unplug the appliance from the mains when not in use. The
cable can be wrapped around the plastic cable tidy on the
front panel.
USING THE REMOTE CONTROL
The remote control duplicates all the controls that are on the
control panel.
Page 3


Product specificaties

Merk: Prem-i-air
Categorie: Heater
Model: EH1442

Heb je hulp nodig?

Als je hulp nodig hebt met Prem-i-air EH1442 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Heater Prem-i-air

Handleiding Heater

Nieuwste handleidingen voor Heater