PAC LCGM51 Handleiding

PAC Niet gecategoriseerd LCGM51

Lees hieronder de đź“– handleiding in het Nederlandse voor PAC LCGM51 (1 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 231 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/1
LCGM51
Radio Replacement Interface for General Motors Vehicles
Paciî‚żc Accessory Corporation
® | Clearwater, Florida 33760 | Ph. 866-931-8021 | support@pac-audio.com
©2015 Pacic Accessory Corporation
www.pac-audio.com
Rev. 012915
P ifi A C ti
P ifi A C ti
The LCGM51 allows the replacement of a factory radio in select General Motors vehicles with 29-bit v2 GMLAN radios. Using this
interface will retain factory features such as warning chimes and provides a data-bus generated 12-volt retained accessory power
output (RAP). RAP keeps the radio powered after key-off, just like the factory system. The LCGM51 also issues data commands
that maintain a “healthy” system status to other vehicle systems.
Introduction & Features
Installation Steps
PLEASE NOTE: This Interface is intended
for use in vehicles without OnStar® or
Bose® or when OnStar® or Bose® does
not need to be retained.
1. Wire your aftermarket radio to the LCGM51 harness
according to the wiring connections chart. The
red accessory wire will support up to 10 amps of
current draw.
2. Remove the factory radio and plug in the LCGM51’s
14/16-pin harness into the factory vehicle harness.
Using the supplied length of wire, mount the
interface within the dash of the vehicle with double
sided tape or wire ties. There are no adjustments
to make, just mount your aftermarket radio and re-
install your factory dash panels and you’re done!
1. Turn the ignition on. The LED on the interface will turn on & the +12v accessory wire will turn on.
2. Turn on the radio & check balance & fade.
3. Turn off vehicle & remove key. RAP will be active & keep the radio on for 10 minutes or until the drivers door is opened.
4. The LED & radio will turn off when RAP turns off or the drivers door is opened.
Testing & Veriî‚żcation
Illustration / Schematic
Yellow Battery +12v
Black Ground
Red Accessory +12v
(10A)
White Front L + input
White / Black Front L - input
Grey Front R + input
Grey / Black Front R - input
Green Rear L + input
Green / Black Rear L - input
Purple Rear R + input
Purple / Black Rear R - input
Wiring Connections
Aftermarket Radio
Connections
To Vehicle
Connector
Connect to
LCGM51 module
Acc On
LED
LCGM51

Product specificaties

Merk: PAC
Categorie: Niet gecategoriseerd
Model: LCGM51

Heb je hulp nodig?

Als je hulp nodig hebt met PAC LCGM51 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd PAC

PAC

PAC RP4-GM31 Handleiding

31 Augustus 2024
PAC

PAC NU-GM51 Handleiding

28 Augustus 2024
PAC

PAC NAV-1129 Handleiding

28 Augustus 2024
PAC

PAC LP7-2R Handleiding

28 Augustus 2024
PAC

PAC LP7-4 Handleiding

28 Augustus 2024
PAC

PAC GMK367B Handleiding

28 Augustus 2024
PAC

PAC CP1-FRD1 Handleiding

28 Augustus 2024
PAC

PAC C2A-CHY5 Handleiding

28 Augustus 2024
PAC

PAC NU-GM3 Handleiding

28 Augustus 2024
PAC

PAC CP1-TSL1 Handleiding

28 Augustus 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Taga Harmony

Taga Harmony TOS-600 v.2 Handleiding

26 November 2024
Trace Elliot

Trace Elliot Pro 2x12 Cabinet Handleiding

26 November 2024
Kramer

Kramer K-Bar Camera Bracket Handleiding

26 November 2024
Kramer

Kramer RK-19 Handleiding

26 November 2024
Kramer

Kramer OSP-MM1 Handleiding

26 November 2024
Kramer

Kramer ASPEN-1616UX Handleiding

26 November 2024
Korg

Korg Pitchstrap Handleiding

26 November 2024
NeoMounts

NeoMounts WL70-450BL11 Handleiding

26 November 2024
Kramer

Kramer CLS-AOCH/60 Handleiding

26 November 2024
Klauke

Klauke EKM 6022ISM Handleiding

26 November 2024