PAC LCGM24 Handleiding


Lees hieronder de đź“– handleiding in het Nederlandse voor PAC LCGM24 (1 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 44 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/1
LCGM24
Radio Replacement Interface for General Motors Vehicles
Paciî‚żc Accessory Corporation
® | Santa Ana, California 92705 | Ph. 866-931-8021 | support@pac-audio.com
©2013 Pacic Accessory Corporation
www.pac-audio.com
Rev. 050213
P ifi A C ti
P ifi A C ti
The LCGM24 allows the replacement of a factory radio in select General Motors vehicles with Class II radios. Using this interface
will retain factory features such as warning chimes and provides a data-bus generated 12-volt retained accessory power output
(RAP). RAP keeps the radio powered after key-off, just like the factory system. The LCGM24 also issues data commands that
maintain a “healthy” system status to other vehicle systems.
Introduction & Features
Installation Steps
PLEASE NOTE: This Interface is intended
for use in vehicles without OnStar® or
Bose® or when OnStar® or Bose® does
not need to be retained.
1. Wire your aftermarket radio to the LCGM24’s
harness according to the wiring connections chart.
The red accessory wire will support up to 10 amps
of current draw.
2. Remove the factory radio and plug in the LCGM24’s
24-pin harness into the factory vehicle harness.
Using the supplied length of wire, mount the
interface within the dash of the vehicle with double
sided tape or wire ties. There are no adjustments
to make, just mount your aftermarket radio and re-
install your factory dash panels and you’re done!
1. Turn the ignition on. The LED on the interface will turn on & the +12v accessory wire will turn on.
2. Turn on the radio & check balance & fade.
3. Turn off vehicle & remove key. RAP will be active & keep the radio on for 10 minutes or until the drivers door is opened.
4. The LED & radio will turn off when RAP turns off or the drivers door is opened.
Testing & Veriî‚żcation
Illustration / Schematic
Yellow Battery +12v
Black Ground
Red Accessory +12v
(10A)
Blue Antenna On Input
White Front L + input
White / Black Front L - input
Grey Front R + input
Grey / Black Front R - input
Green Rear L + input
Green / Black Rear L - input
Purple Rear R + input
Purple / Black Rear R - input
Wiring Connections
Aftermarket Radio
Connections
To Vehicle
Connector


Product specificaties

Merk: PAC
Categorie: Niet gecategoriseerd
Model: LCGM24

Heb je hulp nodig?

Als je hulp nodig hebt met PAC LCGM24 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd PAC

PAC

PAC RP4-GM31 Handleiding

31 Augustus 2024
PAC

PAC NU-GM51 Handleiding

28 Augustus 2024
PAC

PAC NAV-1129 Handleiding

28 Augustus 2024
PAC

PAC LP7-2R Handleiding

28 Augustus 2024
PAC

PAC LP7-4 Handleiding

28 Augustus 2024
PAC

PAC GMK367B Handleiding

28 Augustus 2024
PAC

PAC CP1-FRD1 Handleiding

28 Augustus 2024
PAC

PAC C2A-CHY5 Handleiding

28 Augustus 2024
PAC

PAC NU-GM3 Handleiding

28 Augustus 2024
PAC

PAC CP1-TSL1 Handleiding

28 Augustus 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd