Ozito PSDWV-500 Handleiding

Ozito Pomp PSDWV-500

Lees hieronder de 📖 handleiding in het Nederlandse voor Ozito PSDWV-500 (6 pagina's) in de categorie Pomp. Deze handleiding was nuttig voor 27 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/6
VORTEX
SUMP PUMP
500W
INSTRUCTION MANUAL
SPECIFICATIONS
Motor: 500W
Max. Flow Rate: 12,000l/h
Max. Head 8m
Max. Immersion: 5m
Min. Priming Depth:200mm
Power Cord Length: 10m
Max Particle Size: Ø15mm
Outlet: 38mm (1½”)
Water Temp.: 1°C - 35°C
Weight: 10.6kg
PSDWV-500
STANDARD EQUIPMENT
Sump Pump
IN ORDER TO MAKE A CLAIM UNDER THIS
WARRANTY YOU MUST RETURN THE PRODUCT
TO YOUR NEAREST BUNNINGS WAREHOUSE WITH
YOUR BUNNINGS REGISTER RECEIPT. PRIOR TO
RETURNING YOUR PRODUCT FOR WARRANTY
PLEASE TELEPHONE OUR CUSTOMER SERVICE
HELPLINE:
Australia 1800 069 486
New Zealand 0508 069 486
3 YEAR REPLACEMENT WARRANTY
Your product is guaranteed for a period of 36 months from the
original date of purchase and is intended for DIY (Do It Yourself)
use only. If a product is defective it will be replaced in accordance
with the terms of this warranty. Warranty excludes consumable
parts, for example: O-rings, bearing, seals, gaskets, hose adaptors.
WARNING
The following actions will result in the warranty being void.
If the tool has been operated on a supply voltage other
than that specified on the tool.
If the tool shows signs of damage or defects caused
by or resulting from abuse, accidents or alterations.
Failure to perform maintenance as set out within the
instruction manual.
If the tool is disassembled or tampered with in any way.
WARRANTY
TO ENSURE A SPEEDY RESPONSE PLEASE
HAVE THE MODEL NUMBER AND DATE OF
PURCHASE AVAILABLE. A CUSTOMER SERVICE
REPRESENTATIVE WILL TAKE YOUR CALL
AND ANSWER ANY QUESTIONS YOU MAY
HAVE RELATING TO THE WARRANTY POLICY
OR PROCEDURE.
OZITO Australia/New Zealand (Head Office) 1-23 Letcon Drive, Bangholme, Victoria, Australia 3175.
The benefits provided under this warranty are in addition
to other rights and remedies which are available to you at law.
Our goods come with guarantees that cannot be excluded
at law. You are entitled to a replacement or refund for a major
failure and for compensation for any other reasonably foreseeable
loss or damage. You are also entitled to have the goods repaired
or replaced if the goods fail to be of acceptable quality and the
failure does not amount to a major failure.
Generally you will be responsible for all costs associated with
a claim under this warranty, however, where you have suffered
any additional direct loss as a result of a defective product you
may be able to claim such expenses by contacting our customer
service helpline above.
ozito.com.au
Hose Adaptors
1119
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
1. Handle
2. Float Switch Adjustor
3. Float Switch
4. Pump Housing
5. Outlet
6. Air Bleed Valve
7. Suction Base
VORTEX SUMP PUMP
KNOW YOUR PRODUCT
1. HOSE ADAPTOR
8. Hose Adaptor 25mm (1”)
9. Hose Adaptor 32mm (1¼”)
10. Hose Adaptor 38mm (1½”)
ACCESSORIES
ASSEMBLY
1. Screw a Hose Adaptor
into the pump housing
by rotating in a clockwise
direction.
10
WARNING! ENSURE THE PUMP IS DISCONNECTED
FROM THE POWER SUPPLY BEFORE PERFORMING
ANY OF THE FOLLOWING ASSEMBLY.
2. Securely attach the
hose/tube/pipe to the
Hose Adaptor, t hose
clamps (not included)
if you are using exible
hose or tube, and tighten
well.
NOTE: The maximum pumping rate is possible only when the
largest possible line diameter; if smaller hoses or pipes are
connected, the pumping rate will be reduced.
2. FLOAT SWITCH 3. MANUAL MODE
PREPARATION
The pump is tted with a oat switch, which controls how the
pump switches on and switches off automatically. 200mm of
water is the pumps lowest starting level.
NOTE: There must be a
minimum of 100mm of cable
from the adjuster to the oat.
300
1. When the oat switch is
about 30° higher than
horizontal (start up level)
or above the handle, the
pump will turn ‘on’ and
operate (water depth of
500mm).
2. When the oat switch is 3
lower than the horizontal or
below the handle, the pump
will turn ‘off’. (water depth of
approximately 150mm).
300
3. To set the pump to switch
off at a higher water level,
adjust the oat switch cable
length in the adjuster.
4. When the oat switch cable
is extended fully the pump
will function down to a
water depth of 50mm and
automatically shut off.
100mm
minimum
WARNING! MAKE SUR THAT THE FLOAT SWITCH DOES
NOT TOUCH THE BOTTOM BEFORE SWITCHING OFF
TO AVOID THE RISK OF RUNNING DRY.
The pump oat switch can also function in manual mode
which allows the pump to continually operate regardless of
the water level.
1. When the oat switch
is held in the vertical
position the pump will run
continuously.
WARNING! TO PREVENT THE PUMP RUNNING DRY,
THIS OPERATION MODE IS ONLY ALLOWED UNDER
SUPERVISION. THE PUMP MUST BE SWITCHED OFF
AS SOON AS NO MORE WATER IS EMITTED FROM THE
DISCHARGE LINE.


Product specificaties

Merk: Ozito
Categorie: Pomp
Model: PSDWV-500

Heb je hulp nodig?

Als je hulp nodig hebt met Ozito PSDWV-500 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Pomp Ozito

Handleiding Pomp

Nieuwste handleidingen voor Pomp

Sauermann

Sauermann Omega Handleiding

13 November 2024
Sauermann

Sauermann Delta Handleiding

12 November 2024
Testo

Testo 565i Handleiding

12 November 2024
Simpson

Simpson SCP71008 Handleiding

11 November 2024
MSW

MSW -OP-56-DC Handleiding

5 November 2024
MSW

MSW -FM-N-53 Handleiding

4 November 2024
MSW

MSW -AOP40S Handleiding

15 Oktober 2024
MSW

MSW -MN34M Handleiding

15 Oktober 2024
MSW

MSW -MN34 Handleiding

15 Oktober 2024