Metra LC-GMRC-LAN-10 Handleiding

Metra Niet gecategoriseerd LC-GMRC-LAN-10

Lees hieronder de 📖 handleiding in het Nederlandse voor Metra LC-GMRC-LAN-10 (8 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 15 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/8
LC-GMRC-LAN-10
I N S TA L L AT I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2019 METRA ELECTRONICS CORPORATION REV. 11/18/19 INSTLC-GMRC-LAN-10
Product Info
INTERFACE COMPONENTS
OPTIONAL ACCESSORIES (sold separately)
Extension Harness: AX-GMLAN10EXT
TABLE OF CONTENTS
Connections ............................................................2
Installation .............................................................3
Programming .........................................................3
APPLICATIONS
CHEVROLET
Colorado 2017-2019(1)
Cruze 2016-2019(2)
Cruze Hatchback 2016-2019(2)
Equinox 2019(1)
Malibu 2016-2019(2)
Silverado 2016-2019(1)
GMC
Canyon 2017-2019(1)
Sierra 2016-2019(1)
• LC-GMRC-LAN-10 interface
• LC-GMRC-LAN-10 harness
• (1) With RPO code I0B With RPO code I0A • (2)
The IOA/IOB code, if applicable, can be found in the Service Parts Identification label located:
Glovebox: Canyon/Colorado/Cruze/Equinox/Silverado/Sierra – Rear Compartment Floor: Malibu
INTERFACE FEATURES
GM Data Interface 2016-2019
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
•
Provides illumination, parking brake, reverse, and speed sense outputs
• Used in non-amplified models, or when bypassing a factory amp
• Retains the factory backup camera
• Used in models without OnStar
• Retains all warning chimes
• High level speaker input
• Retains balance and fade
• Micro-B USB updatable
TOOLS & INSTALLATION ACCESSORIES REQUIRED
• Crimping tool and connectors, or solder gun,
solder, and heat shrink • Tape • Wire cutter
• Zip ties
2
CONNECTIONS
From the LC-GMRC-LAN-10 harness to the aftermarket radio, connect the:
• wire to the ground wire.Black
• Yellow wire to the battery wire.
• wires (2) to the accessory wire.Red
• Blue/White wire to the amp turn on wire (excluding Bose). This wire must be connected to
hear sound from the factory amplifier.
• Orange wire to the illumination wire (if applicable).
• White wire to the front left positive speaker output.
• White/Black wire to the front left negative speaker output.
• wire to the front right positive speaker output.Gray
• Gray/Black wire to the front right negative speaker output.
• Green wire to the rear left positive speaker output.
• Green/Black wire to the rear left negative speaker output.
• wire to the rear right positive speaker output.Purple
• wire to the rear right negative speaker output.Purple/Black
The following (3) wires are only for multimedia/navigation radios that require these wires.
• wire to the VSS/speed sense wire.Blue/Pink
• Green/Purple wire to the reverse wire.
• Light Green wire to the parking brake wire.
• Yellow RCA jack to the backup camera input. (If the vehicle is equipped with a factory backup
camera.)
3
REV. 11/18/2019 INSTLC-GMRC-LAN-10
INSTALLATION
PROGRAMMING
With the key in the off position:
1. Locate the factory radio harness in the vehicle and complete all necessary connections to the
aftermarket radio.
2. Connect the LC-GMRC-LAN-10 harness LC-GMRC-LAN-10 interface to the , and then to the
factory radio harness in the vehicle.
Note: For the Equinox and Malibu, use part number AX-GMLAN10EXT (sold separately) to extend
the wiring harness to the right of the glovebox where the radio brain is located at.
Attention: If the interface loses power for any reason, the following steps will need to be
performed again.
1.
Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on
.
If the radio does not come on within 60 seconds, turn the key to the off position, Note:
disconnect the interface, check all connections, reconnect the interface, and then try again.
2. Cycle the key off, then back on. If the driver’s door is closed, open and close the door.
3. Test all functions of the installation for proper operation, before reassembling the dash.
Note: The vehicle must be running for the factory camera to power on.

Product specificaties

Merk: Metra
Categorie: Niet gecategoriseerd
Model: LC-GMRC-LAN-10

Heb je hulp nodig?

Als je hulp nodig hebt met Metra LC-GMRC-LAN-10 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd Metra

Metra

Metra 95-7022HG Handleiding

12 November 2024
Metra

Metra 95-7642 Handleiding

12 November 2024
Metra

Metra 71-017C Handleiding

26 September 2024
Metra

Metra AXSP-HK Handleiding

26 September 2024
Metra

Metra 109-TO7 Handleiding

24 September 2024
Metra

Metra 95-8273B Handleiding

6 September 2024
Metra

Metra 95-7822 Handleiding

6 September 2024
Metra

Metra 82-8703 Handleiding

6 September 2024
Metra

Metra 88-00-9004 Handleiding

6 September 2024
Metra

Metra 82-9101 Handleiding

6 September 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Taga Harmony

Taga Harmony TOS-600 v.2 Handleiding

26 November 2024
Trace Elliot

Trace Elliot Pro 2x12 Cabinet Handleiding

26 November 2024
Kramer

Kramer K-Bar Camera Bracket Handleiding

26 November 2024
Kramer

Kramer RK-19 Handleiding

26 November 2024
Kramer

Kramer OSP-MM1 Handleiding

26 November 2024
Kramer

Kramer ASPEN-1616UX Handleiding

26 November 2024
Korg

Korg Pitchstrap Handleiding

26 November 2024
NeoMounts

NeoMounts WL70-450BL11 Handleiding

26 November 2024
Kramer

Kramer CLS-AOCH/60 Handleiding

26 November 2024
Klauke

Klauke EKM 6022ISM Handleiding

26 November 2024