Losi 1/18 Mini-Desert Truck RTR Handleiding

Losi Radiografisch bestuurbaar speelgoed 1/18 Mini-Desert Truck RTR

Lees hieronder de 📖 handleiding in het Nederlandse voor Losi 1/18 Mini-Desert Truck RTR (8 pagina's) in de categorie Radiografisch bestuurbaar speelgoed. Deze handleiding was nuttig voor 55 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/8

Operation Manual

Thank you for choosing the Mini-DT from Losi®. This

guide contains the basic instructions for operating

your new Mini-DT. While the Mini-DT is great for rst-

time RC drivers, it does require some mechanical

experience and/or parental supervision for drivers

under 12. It is critical that you read all of the

instructions in order to operate your model correctly

and avoid unnecessary damage. Please take a

moment to look over all the printed materials before

operating your new Mini-DT.

Mini-DT Manual―Page 2

Safety Precautions

This is a sophisticated radio controlled model that must be operated with caution and common sense. Failure to

operate your Mini-DT in a safe and responsible manner could result in damage to the model and property. The

Mini-DT is not intended for use by children without direct adult supervision. Losi and Horizon Hobby shall not be liable

for any loss or damages, whether direct, indirect, special, incidental, or consequential, arising from the use, misuse, or

abuse of this product or any product required to operate it.

• This model is controlled by a radio signal subject to interference from many sources outside your control. This

interference may cause momentary loss of control so it is advisable to always keep some distance in all directions

around your model as a safety margin to avoid collisions.

• Always operate your model in an open area away from cars, trafc and people.

• Avoid running your model in the street where damage can occur.

• Never run your Mini-DT with low transmitter batteries.

• Carefully follow the directions and warnings for this and any optional

support equipment.

• Keep all chemicals, small parts and anything electrical out of the

reach of children.

Warning

This model may only be powered by the stock 6-cell 7.2-volt NiMH battery pack

(LOSB1202) or a 2-cell 7.4-volt LiPo battery pack (LOSB0871). The use of higher

voltage battery packs will cause ESC damage and void any warranty. To use

brushless or 3-cell LiPo batteries you must change the electronics. Consult your

local hobby dealer or check www.losi.com.

Tools and Items You Will Find Handy

• Soft bristle brush for cleaning

• 5.5mm nut driver for the wheel nuts

• #0 or #1 Phillips screwdriver

• LOSA99100 .050” Allen Wrench

Note: Use only Losi tools or other high-quality tools. Use of inexpensive tools

can cause damage to the small screws and parts used on this type of model.

The Radio System

The following is an overview of the various functions and adjustments found on your Losi/Mini-DT radio system. Since

the Mini-DT operates on a radio signal, it is important for you to read and understand about all of these functions

before driving the model.

The Receiver

1. : Controls Power to the Receiver/ESC.On/Off Switch

2. : Where the steering servo plugs in (note polarity on case).Servo Port/Plug

3. : Receives the radio signal from your transmitter.Antenna Wire

4. : Connects to the battery lead for power.Receiver/ESC Power Lead

5. Frequency Crystal: Determines the frequency/channel you are operating on.

6. : Connects the ESC to the motor.Motor Lead

7. : Connects the motor battery to the ESC.Battery Leads

8. : Enters ESC into setup mode.Setup Button

Mini-DT Manual―Page 3

Changing Frequencies/Channels

The Mini-DT radio operates on 27MHz AM and has 6 different frequencies/channels available. Simply put, a frequency

is like a TV channel. The transmitter you hold in your hand is like the TV station and the model with the matching

crystal is like your TV tuned exclusively to the channel of that station. The Mini-DT radio is equipped with changeable

crystals that allow you to change the frequency/channel you operate on. This is especially useful when you want to run

a group of Losi Mini-DT’s at the same time. When changing crystals/channels, you must always replace the crystals

as a matched set with one each going in both the transmitter and the receiver in the truck. Each of the 6 different

channels are numbered and color-coded. Each set includes a unique crystal for the receiver marked (Rx) and one

from the transmitter marked (Tx). The crystals are changed by gently pulling them out, then lining up the two pins of

each new crystal with its socket and carefully pushing them into place. DO NOT force them as damage can occur. If

they do not slide into the socket easily check for bent or misaligned pins.

Channel 1 Brown 26.995MHz (LOSB1094)

Channel 2 Red 27.045MHz (LOSB1095)

Channel 3 Orange 27.095MHz (LOSB1096)

Channel 4 Yellow 27.145MHz (LOSB1097)

Channel 5 Green 27.195MHz (LOSB1098)

Channel 6 Blue 27.255MHz (LOSB1099)

The Transmitter

1. : Controls direction (left/right) of the Steering Wheel

model.

2. Throttle Trigger: Controls speed and direction (forward/

reverse) of the model.

3. : Transmits signal to the model.Antenna

4. : Turns the power on/off for the On/Off Switch

transmitter.

5. : Green (right) light indicates adequate Indicator Lights

battery power. Red (left) indicates signal strength.

6. ST. Trim: Adjusts the “hands off” direction of the model.

7. TH. Trim: Adjusts the motor speed to stop at neutral.

8. Steering Rate: Adjusts amount front wheels move when

the steering wheel is turned left and right.

9. ST. REV: Reverses the function of the steering when the

wheel is turned left or right.

10. : Reverses the function of the speed control TH. REV

when pulled back or pushed forward.

11. : Covers and holds the batteries that Bottom Cover

power the transmitter.

12. Transmitter Crystal: Determines frequency/channel

you transmit on. The receiver must have a matching

frequency/channel to operate.

Product specificaties

Merk:	Losi
Categorie:	Radiografisch bestuurbaar speelgoed
Model:	1/18 Mini-Desert Truck RTR
Gewicht:	571 g
Breedte:	177.8 mm
Frequentieband:	0.027 GHz
Batterijtechnologie:	Nikkel-Metaalhydride (NiMH)