Honeywell RDWL311A2000 Handleiding

Honeywell Deurbel RDWL311A2000

Lees hieronder de đź“– handleiding in het Nederlandse voor Honeywell RDWL311A2000 (24 pagina's) in de categorie Deurbel. Deze handleiding was nuttig voor 53 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/24
RDWL311A2000
Read before installing
Installation and Operation Guide
Portable Wireless Doorbell
Preparation
Doorbell
Push
Button
Wall
Anchor
Round Head
Screw
Flat Head
Screws
Phillips Screwdriver
Standard Screwdriver
Drill and 1/4 in. (6.3 mm) drill bit
4 AA alkaline batteries
Push Button Mounting
Bracket
and Adhesive Pad
To install you will needIn the box you will find
The push button supplied with this kit is pre-programmed to operate with the doorbell.
If it is not, see “Connect a Push Button” on page 4.
CR2032
Battery
2
Overview
Just follow these simple steps:
1. Install batteries.
2. Set up the doorbell and your preferences.
3. Install the doorbell and the push button.
Safety
Before proceeding with the installation, please note the following safety
warnings:
• Always follow the manufacturer’s advice when using power tools and wear
suitable protective equipment (e.g. safety goggles) when drilling holes, etc.
• Before drilling holes in walls, check for hidden electricity cables and water
pipes. The use of a cable/pipe locator is advisable if in doubt.
Install Batteries
1. Open the battery cover and install 4
AA alkaline batteries.
2. Open the battery cover and install the
CR2032 battery.
+
Change the Tune
Press the Music button to change the doorbell tune.
Every time you press the Music button,
the tune will change. Stop pressing the
Music button when you hear the tune you
want:
Ding Dong
Westminster
Soft Alert
Smart Sax
Setup and Operation
Press the push button to test whether it is paired with the doorbell. The
doorbell will ring. If it does not, see “Connect a Push Button” on page 4.
3
Install Doorbell
If you are not mounting the doorbell to the wall,
place it where you want it.
1. Mount the screw on to the wall using the
supplied anchor if necessary. Leave 2mm of
the screw sticking out from the wall.
Drill 1/4 inch (6.3 mm) holes for the anchor.
2. Hang the doorbell on the screw.
Installation
Choose a location that is not near a heat source or on something that moves
(like a door). For non-mounting locations, choose a place where the doorbell
will be easy to hear.
Install Push Button
1. Mount the push button bracket
in the desired location.
Use the screws
–OR–
Use the adhesive backing. If
using the adhesive backing,
clean the surface first.
2. Snap the push button onto the
mounting bracket.
–OR–
Note: If you need to remove the push button, use a small
screwdriver to release the tab.


Product specificaties

Merk: Honeywell
Categorie: Deurbel
Model: RDWL311A2000

Heb je hulp nodig?

Als je hulp nodig hebt met Honeywell RDWL311A2000 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Deurbel Honeywell

Handleiding Deurbel

Nieuwste handleidingen voor Deurbel