Fellowes Powershred LX180 Handleiding

Fellowes Papiervernietiger Powershred LX180

Lees hieronder de 📖 handleiding in het Nederlandse voor Fellowes Powershred LX180 (8 pagina's) in de categorie Papiervernietiger. Deze handleiding was nuttig voor 22 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/8

Please Read These Instructions Before Use.

Veuillez Lire Ces Instructions Avant D’utiliser L’appareil.

Lea Estas Instrucciones Antes Del Uso.

WARNING IMPORTANT SAFETY INSTRUCTIONS – Read before using!

Will shred: Paper, plastic credit cards, staples and paper clips

Will not shred: Adhesive labels, continuous form paper,

transparencies, newspaper, cardboard, CD/DVDs, laminates,

le folders, X-rays or plastic other than noted above

Paper shred size: Cross-Cut, LX170 - 5/32 in x 1-1/16 in (4mm

x 27mm), LX180/LX190 - 5/32 in x 1-3/8 in (4mm x 35mm)

Maximum Sheets per pass:

LX170 - 12*, LX180 - 16*, LX190 - 20*

Maximum Paper entry width: 9 in. (230mm)

Plug in and put disconnect power

switch in ON (I) position

* 8.5 in. p2-x11 in., 20lb., (75g) paper at 120V/60 Hz, 3.75Amps (LX170), 4.58Amps (LX180), 6.25Amps (LX190); heavier paper, humidity or other than

rated voltage may reduce capacity. Maximum recommended daily usage rates: *1000 sheets per day, 25 credit cards. Fellowes SafeSense ®

shredders are designed to be operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees

Celsius) and 40 – 80% relative humidity.

CAPABILITIES

BASIC SHREDDING OPERATION

Align paper/card to center of paper

entry. Feed straight into paper entry

and release.

PAPER OR CARD

A. SafeSense®

Technology

B. Paper entry

C. See safety instructions

D. Pullout bin

E. Casters

F. Disconnect power switch

1. OFF

2. ON

G. Control Panel and LEDs

LX170

Continuous operation. Up to 10-minutes maximum.

NOTE: Shredder runs briefly after each pass to clear entry.

Continuous operation beyond 10-minutes will trigger

15-minute cool down period.

LX180

Continuous operation. Up to 20-minutes maximum.

NOTE: Shredder runs briefly after each pass to clear entry.

Continuous operation beyond 20-minutes will trigger

15-minute cool down period.

LX190

Continuous operation. Up to 30-minutes maximum.

NOTE: Shredder runs briefly after each pass to clear entry.

Continuous operation beyond 30-minutes will trigger

15-minute cool down period.

ENGLISH

ƽ 4TIVEXMSRQEMRXIRERGIERHWIVZMGIVIUYMVIQIRXW

are covered in the instruction manual. Read

the entire instruction manual before operating

shredders.

ƽ 0IITE[E]JVSQGLMPHVIRERHTIXW0IITLERHW

away from paper entry.

ƽ 0IITJSVIMKRSFNIGXWƳKPSZIWNI[IPV]GPSXLMRKLEMV

IXGƳE[E]JVSQWLVIHHIVSTIRMRKW.JSFNIGXIRXIVW

top opening, switch to Reverse ( ) to back out

SFNIGX

ƽ )4348YWIEIVSWSPTVSHYGXWTIXVSPIYQFEWIHSV

aerosol lubricants on or near shredder. DO NOT USE

“CANNED AIR” OR “AIR DUSTERS” ON SHREDDER.

Vapors from propellants and petroleum based

PYFVMGERXWQE]GSQFYWXGEYWMRKWIVMSYWMRNYV]

ƽ LEVTIHKIW)4348XSYGLI\TSWIHGYXXMRKFPEHIW

under shredder head.

ƽ )SRSXYWIMJHEQEKIHSVHIJIGXMZI)SRSX

disassemble shredder. Do not place near or over

heat source or water.

ƽ 8LMWWLVIHHIVLEWE)MWGSRRIGX5S[IV[MXGL

(F) that must be in the ON ( ) position to

operate shredder. In case of emergency, move

switch to OFF (O) position. This action will

stop shredder immediately. Always turn off or

unplug when not in use for an extended period

of time.

ƽ LVIHHIVQYWXFITPYKKIHMRXSETVSTIVP]

grounded wall outlet or socket of the voltage

and amperage designated on the label. The

grounded outlet or socket must be installed

RIEVXLIIUYMTQIRXERHIEWMP]EGGIWWMFPI

Energy converters, transformers, or extension

cords should not be used with this product.

ƽ +.7*-&>&7)Ƴ)S348WLVIHKVIIXMRKGEVHW

with sound chips or batteries.

ƽ +SVMRHSSVYWISRP]

ƽ 9RTPYKWLVIHHIVFIJSVIGPIERMRKSVWIVZMGMRK

LX /LXȦȮȉ Ȧȁȉ LXȦȟȉ

ADVANCED PRODUCT FEATURES

OILING SHREDDER

&PPGVSWWGYXWLVIHHIVWVIUYMVISMPJSVTIEOTIVJSVQERGI.JRSX

oiled, a machine may experience diminished sheet capacity,

intrusive noise when shredding and could ultimately stop

running. To avoid these problems, we recommend you oil your

shredder each time you empty your waste bin.

CLEANING AUTO-START INFRARED SENSORS

Paper detection sensors are designed for maintenance free

operation. However, on rare occasions the sensors may

become blocked by paper dust causing the motor to run

even if there is no paper present. (Note: two paper detection

sensors are located in the center of the paper entry).

PRODUCT MAINTENANCE

*Apply oil across entry

Locate Auto-

start infrared

sensor

Dip cotton

swab in

rubbing

alcohol

Using cotton

swab, wipe

away any

contamination

from the paper

sensors

2Press and hold forward ( ) >

2-3 seconds

*Only use a non-aerosol

vegetable oil in long

nozzle container such as

Fellowes 35250

TROUBLESHOOTING

Overheat Indicator: When the Overheat Indicator is

illuminated, the shredder has exceeded its maximum

operating temperature and needs to cool down. This indicator

will remain illuminated and the shredder will not operate for

the duration of the recovery time.

Bin Open: The shredder will not run if the bin is open. When

illuminated, close the bin to resume shredding.

Bin Full: When illuminated, the shredder waste bin is full and

needs to be emptied. Use Fellowes waste bag 36052 (LX170/

LX180), 36053 (LX190).

SafeSense® Indicator: If hands are too close to the paper

entry, the SafeSense® indicator will illuminate and the shredder

will stop shredding. If SafeSense

® is active for 5 seconds, the

shredder will automatically turn off and the user must open and

close the bin or toggle on/off the power switch on the rear.

Power: If the machine is not powered, ensure the power

switch is in the ON (I) position and the power cord is plugged

into both the machine and power outlet.

OVERHEAT

INDICATOR

BIN

OPEN

BIN

FULL

SAFESENSE®

INDICATOR

POWER

SWITCH

1. Run Time Indicator:

Light will turn yellow when machine is

close to the maximum runtime and switch

to red when cool down is needed

2. SafeSense® Technology:

Light will turn yellow to alert when system is

activated. Machine will turn off after 5 seconds

of hands touching the paper entry (open bin or

switch power on/o to resume shredding)

3. Reverse:

Light will turn green

4. Forward:

Light will turn green

5. Bin Open:

Light will turn red when bin is pulled out

6. Bin Full Indicator:

Light will turn yellow when nearly full and

turn red when it needs to be emptied

7. Eciency Meter:

Light will turn blue when powered on and ready.

Light will expand green and when optimal shredding

zone is reached it will pulse. Once the optimal level

is surpassed, the light will turn yellow, then red to

TVIZIRXJIIHMRKXSSQER]WLIIXW.JQEGLMRINEQW

the light will turn red and paper will auto reverse.

Ȧ ȶ ȴ ȏ ȍ Ȱ. . . . . .

Ȯ.

Energy saving feature shuts down automatically after 2 minutes

of no shredding activity. Insert paper, press forward/ reverse or

open and close the bin to resume shredding.

With 5 Responsive Features. The revolutionary fearless

shredder lineup that maximizes workplace efficiency and

keeps your day in ow.

IntelliBAR

™

Turn o

disconnect

power switch

(O) and unplug

the shredder

FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE TO CLEAN THE SENSORS

Product specificaties

Merk:	Fellowes
Categorie:	Papiervernietiger
Model:	Powershred LX180
Kleur van het product:	Zwart
Materiaal behuizing:	Acrylonitrielbutadieenstyreen (ABS)
Volume mand:	22.7 l
Werkbreedte:	230 mm
Vernietigt CD's:	Nee
Papier versnipperen:	Ja
Credit cards versnipperen:	Ja
Vernietigt tot grootte:	4 x 35 mm
Snijtype:	Dwarsversnippering
Capaciteit documentvernietiger:	16 vel
Soort vernietiger:	Kruisversnippering
Verwerkt nietjes:	Ja
Vewerkt paperclips:	Ja
Snelheid documentvernietiger:	3048 mm/min
Anti-verstoppingsmechanisme:	Ja
Uitvoerbak vol indicator:	Ja
Uittrekbak:	Ja
Automatische aan/uit-functie:	Ja
Snippers per vel:	431