Fellowes Powershred LX170 Handleiding
Fellowes
Papiervernietiger
Powershred LX170
Lees hieronder de 📖 handleiding in het Nederlandse voor Fellowes Powershred LX170 (8 pagina's) in de categorie Papiervernietiger. Deze handleiding was nuttig voor 39 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/8
Please Read These Instructions Before Use.
Veuillez Lire Ces Instructions Avant D’utiliser L’appareil.
Lea Estas Instrucciones Antes Del Uso.
WARNING IMPORTANT SAFETY INSTRUCTIONS – Read before using!
Will shred: Paper, plastic credit cards, staples and paper clips
Will not shred: Adhesive labels, continuous form paper,
transparencies, newspaper, cardboard, CD/DVDs, laminates,
le folders, X-rays or plastic other than noted above
Paper shred size: Cross-Cut, LX170 - 5/32 in x 1-1/16 in (4mm
x 27mm), LX180/LX190 - 5/32 in x 1-3/8 in (4mm x 35mm)
Maximum Sheets per pass:
LX170 - 12*, LX180 - 16*, LX190 - 20*
Maximum Paper entry width: 9 in. (230mm)
Plug in and put disconnect power
switch in ON (I) position
* 8.5 in. p2-x11 in., 20lb., (75g) paper at 120V/60 Hz, 3.75Amps (LX170), 4.58Amps (LX180), 6.25Amps (LX190); heavier paper, humidity or other than
rated voltage may reduce capacity. Maximum recommended daily usage rates: *1000 sheets per day, 25 credit cards. Fellowes SafeSense ®
shredders are designed to be operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees
Celsius) and 40 – 80% relative humidity.
CAPABILITIES
BASIC SHREDDING OPERATION
Align paper/card to center of paper
entry. Feed straight into paper entry
and release.
2
16
PAPER OR CARD
A. SafeSense®
Technology
B. Paper entry
C. See safety instructions
D. Pullout bin
E. Casters
F. Disconnect power switch
1. OFF
2. ON
G. Control Panel and LEDs
LX170
Continuous operation. Up to 10-minutes maximum.
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 10-minutes will trigger
15-minute cool down period.
LX180
Continuous operation. Up to 20-minutes maximum.
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 20-minutes will trigger
15-minute cool down period.
LX190
Continuous operation. Up to 30-minutes maximum.
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 30-minutes will trigger
15-minute cool down period.
1
ENGLISH
ƽ 4TIVEXMSRQEMRXIRERGIERHWIVZMGIVIUYMVIQIRXW
are covered in the instruction manual. Read
the entire instruction manual before operating
shredders.
ƽ 0IITE[E]JVSQGLMPHVIRERHTIXW0IITLERHW
away from paper entry.
ƽ 0IITJSVIMKRSFNIGXWƳKPSZIWNI[IPV]GPSXLMRKLEMV
IXGƳE[E]JVSQWLVIHHIVSTIRMRKW.JSFNIGXIRXIVW
top opening, switch to Reverse ( ) to back out
SFNIGX
ƽ )4348YWIEIVSWSPTVSHYGXWTIXVSPIYQFEWIHSV
aerosol lubricants on or near shredder. DO NOT USE
“CANNED AIR” OR “AIR DUSTERS” ON SHREDDER.
Vapors from propellants and petroleum based
PYFVMGERXWQE]GSQFYWXGEYWMRKWIVMSYWMRNYV]
ƽ LEVTIHKIW)4348XSYGLI\TSWIHGYXXMRKFPEHIW
under shredder head.
ƽ )SRSXYWIMJHEQEKIHSVHIJIGXMZI)SRSX
disassemble shredder. Do not place near or over
heat source or water.
ƽ 8LMWWLVIHHIVLEWE)MWGSRRIGX5S[IV[MXGL
(F) that must be in the ON ( ) position to
operate shredder. In case of emergency, move
switch to OFF (O) position. This action will
stop shredder immediately. Always turn off or
unplug when not in use for an extended period
of time.
ƽ LVIHHIVQYWXFITPYKKIHMRXSETVSTIVP]
grounded wall outlet or socket of the voltage
and amperage designated on the label. The
grounded outlet or socket must be installed
RIEVXLIIUYMTQIRXERHIEWMP]EGGIWWMFPI
Energy converters, transformers, or extension
cords should not be used with this product.
ƽ +.7*-&>&7)Ƴ)S348WLVIHKVIIXMRKGEVHW
with sound chips or batteries.
ƽ +SVMRHSSVYWISRP]
ƽ 9RTPYKWLVIHHIVFIJSVIGPIERMRKSVWIVZMGMRK
2
LX /LXȦȮȉ Ȧȁȉ LXȦȟȉ
F.
G.
A.
B.
D.
E.
C.
F.
A.
B.
D.
E.
C.
G.
ADVANCED PRODUCT FEATURES
OILING SHREDDER
&PPGVSWWGYXWLVIHHIVWVIUYMVISMPJSVTIEOTIVJSVQERGI.JRSX
oiled, a machine may experience diminished sheet capacity,
intrusive noise when shredding and could ultimately stop
running. To avoid these problems, we recommend you oil your
shredder each time you empty your waste bin.
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free
operation. However, on rare occasions the sensors may
become blocked by paper dust causing the motor to run
even if there is no paper present. (Note: two paper detection
sensors are located in the center of the paper entry).
PRODUCT MAINTENANCE
1
16
23
14
16
*Apply oil across entry
Locate Auto-
start infrared
sensor
Dip cotton
swab in
rubbing
alcohol
Using cotton
swab, wipe
away any
contamination
from the paper
sensors
2Press and hold forward ( ) >
2-3 seconds
*Only use a non-aerosol
vegetable oil in long
nozzle container such as
Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is
illuminated, the shredder has exceeded its maximum
operating temperature and needs to cool down. This indicator
will remain illuminated and the shredder will not operate for
the duration of the recovery time.
Bin Open: The shredder will not run if the bin is open. When
illuminated, close the bin to resume shredding.
Bin Full: When illuminated, the shredder waste bin is full and
needs to be emptied. Use Fellowes waste bag 36052 (LX170/
LX180), 36053 (LX190).
SafeSense® Indicator: If hands are too close to the paper
entry, the SafeSense® indicator will illuminate and the shredder
will stop shredding. If SafeSense
® is active for 5 seconds, the
shredder will automatically turn off and the user must open and
close the bin or toggle on/off the power switch on the rear.
Power: If the machine is not powered, ensure the power
switch is in the ON (I) position and the power cord is plugged
into both the machine and power outlet.
OVERHEAT
INDICATOR
BIN
OPEN
BIN
FULL
SAFESENSE®
INDICATOR
POWER
SWITCH
1. Run Time Indicator:
Light will turn yellow when machine is
close to the maximum runtime and switch
to red when cool down is needed
2. SafeSense® Technology:
Light will turn yellow to alert when system is
activated. Machine will turn off after 5 seconds
of hands touching the paper entry (open bin or
switch power on/o to resume shredding)
3. Reverse:
Light will turn green
4. Forward:
Light will turn green
5. Bin Open:
Light will turn red when bin is pulled out
6. Bin Full Indicator:
Light will turn yellow when nearly full and
turn red when it needs to be emptied
7. Eciency Meter:
Light will turn blue when powered on and ready.
Light will expand green and when optimal shredding
zone is reached it will pulse. Once the optimal level
is surpassed, the light will turn yellow, then red to
TVIZIRXJIIHMRKXSSQER]WLIIXW.JQEGLMRINEQW
the light will turn red and paper will auto reverse.
Ȧ ȶ ȴ ȏ ȍ Ȱ. . . . . .
Ȯ.
Energy saving feature shuts down automatically after 2 minutes
of no shredding activity. Insert paper, press forward/ reverse or
open and close the bin to resume shredding.
With 5 Responsive Features. The revolutionary fearless
shredder lineup that maximizes workplace efficiency and
keeps your day in ow.
IntelliBAR
™
3
Turn o
disconnect
power switch
(O) and unplug
the shredder
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE TO CLEAN THE SENSORS
Product specificaties
Merk: | Fellowes |
Categorie: | Papiervernietiger |
Model: | Powershred LX170 |
Heb je hulp nodig?
Als je hulp nodig hebt met Fellowes Powershred LX170 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Papiervernietiger Fellowes
16 April 2024
16 April 2024
16 April 2024
16 April 2024
16 April 2024
16 April 2024
16 April 2024
16 April 2024
16 April 2024
16 April 2024
Handleiding Papiervernietiger
- Papiervernietiger Honeywell
- Papiervernietiger Acco
- Papiervernietiger Amazon
- Papiervernietiger DESQ
- Papiervernietiger Digitus
- Papiervernietiger Duronic
- Papiervernietiger Ednet
- Papiervernietiger GBC
- Papiervernietiger Hama
- Papiervernietiger Hema
- Papiervernietiger HSM
- Papiervernietiger Ideal
- Papiervernietiger Insignia
- Papiervernietiger Kensington
- Papiervernietiger Kogan
- Papiervernietiger Leitz
- Papiervernietiger Lervia
- Papiervernietiger Marquant
- Papiervernietiger Media-tech
- Papiervernietiger Monolith
- Papiervernietiger Nedis
- Papiervernietiger Primo
- Papiervernietiger Renkforce
- Papiervernietiger Royal Sovereign
- Papiervernietiger Sencor
- Papiervernietiger Suntec
- Papiervernietiger United Office
- Papiervernietiger Zipper
- Papiervernietiger Olympia
- Papiervernietiger Overmax
- Papiervernietiger Black And Decker
- Papiervernietiger Camry
- Papiervernietiger Exibel
- Papiervernietiger Conrad
- Papiervernietiger Tracer
- Papiervernietiger Deli
- Papiervernietiger Eldom
- Papiervernietiger Kobra
- Papiervernietiger Genie
- Papiervernietiger Aurora
- Papiervernietiger Q-CONNECT
- Papiervernietiger Swordfish
- Papiervernietiger Peach
- Papiervernietiger Rexel
- Papiervernietiger Acco-Rexel
- Papiervernietiger Bonsaii
- Papiervernietiger D-Mail
- Papiervernietiger Dahle
- Papiervernietiger OTTO
- Papiervernietiger Brasq
- Papiervernietiger Qoltec
Nieuwste handleidingen voor Papiervernietiger
6 December 2024
6 December 2024
5 December 2024
1 December 2024
15 November 2024
15 November 2024
15 November 2024
15 November 2024
5 November 2024
5 November 2024