EMOS P5705 Handleiding

EMOS Deurbel P5705

Lees hieronder de 📖 handleiding in het Nederlandse voor EMOS P5705 (24 pagina's) in de categorie Deurbel. Deze handleiding was nuttig voor 5 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/24

3402005000_31-P5705_00_01_WEB 148 × 210 mm

www.emos.eu

P5705 | 98080S

GB Wireless Doorchime

CZ Bezdrátový zvonek

SK Bezdrôtový zvonček

PL Dzwonek bezprzewodowy

HU Vezeték nélküli csengő

SI Brezžični zvonec

RS|HR|BA|ME Bežično zvono

DE Drahtlose Klingel

UA Бездротовий дзвоник

RO|MD Sonerie fără r

LT Belaidis durų skambutis

LV Bezvadu durvju zvans

EE Juhtmeta uksekell

BG Безжичен звънец

FR Carillon sans l

IT Campanello senza li

ES Timbre inalámbrico

NL Draadloze deurbel

GB | Wireless Doorchime

The set consists of a push button of the chime (transmitter) and

door chime (receiver). The door chime is designed for permanent

installation to electrical network of 230 V/50 Hz voltage. Transfer

between the push button and the chime is ensured with the

help of airwaves of the frequency of 433,92 MHz andtheradius

depends on local conditions and is as much as 60 m in open area

without interference.

Please read the Operating Manual carefully for a correct

operation of the wireless chime.

Technical specications

Chime push button:

Power supply: battery 1×3 V (CR2032)

Radius: up to 60 m in open space (in urban area it can get

reduced to one fth or even less)

IP code: IP44

Chime:

Broadcast frequency: 433.92 MHz, 10 mW e.r.p. max.

Power supply: 230 V~/50 Hz

Number of chimes: 1

Pairing method: self-learning function

Possibility to pair more pushbuttons: yes (max 8)

Installation

Chime push button (transmitter)

1. Using appropriate screwdriver unscrew the little screw on

the bottom part of the button.

2. Screw down on to a wall the back cover using two screws

(not enclosed) or use double sided adhesive tape (also not

part of the package). Before starting the installation make

sure that the set works on the place you have selected in

a smooth and reliable manner. Despite the push button

being resistant against weather conditions it is better to

CR2032

2×

use appropriate position, so the button is protected e.g.

place it in a niche.

3. Open the battery box cover. Following the scheme under the

contacts insert battery 3 V, type CR2032. Pay attention to

correct polarity of inserted batteries!

4. Reassembly the push button and secure it with the screw.

5. Press the button. The press is accompanied by a gleam of

red LED diode which signalizes that the push button trans-

mitted radio signal.

6. If the red panel light on the push button does not light up

the battery is low and it is necessary to replace it. The push

button battery holds for one year of operation. The period

can vary depending on frequency andconditions of usage.

Important notice:

The push button (transmitter) can be installed on to wooden or

brick walls without any problem. However, never place the push

button directly ontometal surfaces or materials containing metal

such as plastic constructions of windows and doors with metal

frame. The transmitter may not function correctly.

Starting up

1. Connect the bell to an electric network. A green LED diode

will light upinthe front side of the bell permanently and a

chime will sound once. Then the bell is ready to be matched.

2. Push the ringing button on the pushbutton (transmitter).

A chime will sound and the pushbutton will be matched.

3. To match other pushbuttons, repeat the procedure according

to point 2.

4. -Pushbuttons can be matched within 25 seconds from insert

ing the bell into a power socket.

5. If you want to match other pushbuttons later, proceed

according to point 1 and 2.

6. You can match a maximum of 8 pushbuttons this way.

Note: If you match another pushbutton (9th and more), the

memory of the rst pushbuttons will be erased automatically

in reverse order.

7. Transmission range is 60 m in open space and with no

magnetic interference. This range is inuenced by local

conditions, such as number of walls through which the

signal must go, metal doorframes and other items that

can inuence transmission of the radio signal (presence

of other radio means working with similar frequency such

as wireless thermometers, gate operating device etc.) The

range of transmission can drop down rapidly under inuence

of these factors.

8. The door chime has a switch for three dierent modes of

operation:

a) acoustic signal only

b) light signal only (intensive ashing for approx. 5 seconds)

c) acoustic and light signal

a) b) c)

9. The chime is designed for indoor use only. It must be located

in an electric socket in a way to be always accessible and

with enough free space around the chime.

Erasing the memory of paired buttons

• Remove the rear part of the push button cover.

• Set the chime to the pairing mode – depending from the door

chime type, remove the battery and reinsert or disconnect

the chime from the 230 V socket and reconnect.

• Within 25 seconds push the S2 button on the rear of the push

button (transmitter).

• A melody will sound – the memory of all matched buttons

will be erased.

Troubleshooting

The chime does not ring:

• The chime can be out of dened range.

• Adjust the distance between the units (Push button

and Door chime), range might be inuenced by local

conditions.

• Flat battery in the push button (transmitter).

• Replace the battery and and pay attention to correct

polarity of inserted batteries.

• Door chime does not have power supply.

• Check, whether the door chime is correctly inserted in the

electrical socket or whether power is not o.

Important notice

Wireless digital door chime is sensitive electronic device and it

is necessary to observe the following precautions:

• Chime (receiver) is designed only for indoor usage in dry

areas.

• Check the function of the push button (transmitter) from time

to time andreplace the battery on due time. Use only high

standard alkaline battery of specied parameters.

• If you do not use the chime for longer period of time remove

the battery from the push button.

• Do not expose the push button and chime to excessive

vibrations andstrokes.

• Do not expose the push button and chime to excessive tem-

perature and direct sunlight or dampness.

• When cleaning the door chime it is necessary to disconnect

it from electrical network by pulling up from the socket.

• For cleaning use moderately damp cloth with a drop of

detergent, do not use aggressive cleaning agents or solvents.

• Dispose of used batteries at a place designated for waste

collection or in the shop of original purchase.

• After expiration of service life of the set deliver it either to

the shop where you purchase a new one or to place designed

for such purpose (waste collection point etc.)

This product is not to be used by persons (including children),

whose physical, sensual or mental abilities or lack of experience-

and knowledge does notensure safe use of the appliance, unless

they are supervised or unless they have been instructed about

the use of this appliance by a person in charge oftheir safety.

Supervision over children is required to prohibit them fromplaying

with the appliance.

Do not dispose with domestic waste. Use special collection

points for sorted waste. Contact local authorities for infor-

mation about collection points. If the electronic devices

would be disposed on landll, dangerous substances may reach

groundwater and subsequently food chain, where it could aect

human health.

Hereby, EMOS spol. s r. o. declares that the radio equipment type

P5705 is in compliance with Directive 2014/53/EU. The full text

of the EU declaration of conformity is available at the following

internet address: http://www.emos.eu/download.

CZ | Bezdrátový zvonek

Souprava se skládá z tlačítka zvonku (vysílače) a domácího

zvonku (přijímače). Domácí zvonek je určen k trvalému připojení

k elektrické síti o napětí 230 V/50 Hz. Přenos mezi tlačítkem

a zvonkem zabezpečují rádiové vlny na kmitočtu 433,92 MHz,

dosah závisí na místních podmínkách a je až 60m ve volném

prostoru bez rušení.

Pro správné použití bezdrátového zvonku si pečlivě prostu-

dujte návod k použití.

Technické údaje

Tlačítko zvonku:

Napájení: baterie 1×3 V (CR2032)

Dosah: až 60 m ve volném prostoru (v zastavěném prostoru

může klesnout až na pětinu a více)

Krytí: IP44

Zvonek:

Frekvence přenosu: 433,92 MHz, 10 mW e.r.p. max.

Napájení: 230 V AC/50 Hz

Počet melodií: 1

Párování zvonku s tlačítky: funkce „self-learning“

Kapacita párování: maximálně 8 tlačítek

Instalace

Tlačítko zvonku (vysílač)

1. Vhodným šroubovákem odšroubujte šroubek ve spodní

části tlačítka.

2. -Připevněte zadní kryt na zeď dvěma šroubky nebo oboustran

nou lepicí páskou (šroubky ani páska nejsou součástí

dodávky). Před montáží vyzkoušejte, zda souprava bude na

vybraném místě spolehlivě fungovat. Ikdyž jetlačítko odolné

vůči povětrnostním vlivům, je lepší využít vhodnou polohu

tak, aby tlačítko bylo chráněno, např. umístění ve výklenku.

3. Otevřete kryt bateriového prostoru. Podle nákresu pod

kontakty vložte baterii 3 V, typ CR2032. Dbejte na správnou

polaritu vkládané baterie!

4. Tlačítko opět sestavte a zabezpečte šroubkem.

5. Stiskem tlačítka zvonku (vysílače) zazvoňte. Stisk je dopro-

vázen svitem červené LED diody, která signalizuje, že tlačítko

vyslalo rádiový signál.

6. Jestliže se červená kontrolka na tlačítku nerozsvěcuje, je

baterie slabá aje nutné ji vyměnit. Baterie v tlačítku vydrží

asi jeden rok provozu. Doba semůže měnit, podle intenzity

a podmínek používání.

Důležité upozornění:

Tlačítko zvonku (vysílač) je vhodné umístit na dřevo nebo cihlové

stěny. Nikdy tlačítko neumísťujte na kovové předměty nebo

materiály, které kov obsahují, např. na umělohmotné konstrukce

oken a dveří, které obsahují kovový rám. Vysílač by nemusel

správně fungovat.

Product specificaties

Merk:	EMOS
Categorie:	Deurbel
Model:	P5705
Kleur van het product:	Wit
Connectiviteitstechnologie:	Draadloos
Maximumbereik:	60 m
Frequentie:	433 MHz
Aantal melodieën:	1