Electro Harmonix Super Space Drum Handleiding

Electro Harmonix Niet gecategoriseerd Super Space Drum

Lees hieronder de 📖 handleiding in het Nederlandse voor Electro Harmonix Super Space Drum (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 35 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/4
1
SUPER SPACE DRUM
Analog Drum Synthesizer
Congratulations on your purchase of the Super Space Drum (SSD) a faithful ,
reissue of the Electro-Harmonix Super Space Drum first released in . The 1979
Super Space Drum uses analog synthesis such as modulating an techniques ̶
oscillator followed by a gat volume amplifier to create drum sounds ranging ed ̶
from deep kicks to high toms to sci-fi drums. Trigger the SSD from the built- in
pushbutton or an external, non-MIDI, electronic drum pad. Pass external sounds
through the gated amplifier via the auxilliary input.
WARNING: Your Super Space Drum (SSD) comes equipped with an Electro-Harmonix
9.6DC-200 power supply (same as used by Boss® & Ibanez®: 9.6 Volts DC 200mA). The
SSD requires 25 at 9VDC with a center negative plug. Using the wrong adapter or a mA
plug with the wrong polarity may damage your SSD and void the warranty.
- CONTROLS -
FREQ Controls –Use the START and STOP knobs together to control the start
and end frequencies (pitch) of the synthesizer swe ’s ep:
START Knob –Sets the starting point of the frequency
sweep. Sweeps can begin anywhere from 20 Hz when fully set
counterclockwise to 4 kHz when fully clockwise. set
STOP Knob – Sets the end point of the frequency sweep.
Sweeps can end anywhere from 20 when set fully Hz
counterclockwise to 4 kHz when fully clockwise. set
TIME Knob –Controls the amount of time that the sweep will take to get from
the START frequency to the STOP frequency. As TIME is turned clockwise, the
sweep time slows down. Sweep time ranges from 40 ms to 6 seconds.
SENS Knob –Controls the sensitivity of the to external trigger As SENS SSD an .
is turned clockwise, it becomes more sensitive and less amplitude is required
from the external trigger to activate the Super Space Drum.
VOLUME Knob –Controls the volume of the output. As VOLUME is turned
clockwise, the output volume increases.
2
MOD Controls – The MOD controls consist of a MOD switch, a DEPTH Knob,
and a RATE knob. Use the MOD controls to apply an LFO modulation waveform
to the SSD’s frequency sweep for an extra layer of analog fun.
MOD Switch – Set to ON to engage modulation. OFF disables
modulation.
DEPTH Knob –Controls modulation depth or amount. This knob is
center-detented. At , the modulation depth is zero. Set the 12 o’clock
knob fully counterclockwise for the largest negative depth. Set ly ful
clockwise for the maximum positive depth. Vary the positive or negative
depth setting to taste. The positive waveform has a rising sawtooth
waveshape that produces a reverse type of modulation at lower RATE
settings. N ative depth consists of a falling sawtooth that produces eg
sharper sounding modulation at lower RATE settings.
RATE Knob – Controls the rate of modulation. Turn th knob is
clockwise to increase the modulation ra from 10 Hz to 1.5 k . Higher te Hz
RATE settings can produce ring modulated sounds.
LED –Lights up when the SSD is powered up. The LED blinks briefly upon
receiving an external trigger pulse or when you press the SSD’s white
pushbutton. If you power the SSD from a battery, the LED’s brightness
diminishes as the battery’s life nears its end.
Pushbutton Trigger –Push the white pushbutton at the center of the logo to
trigger the and create amazing sounds. SSD
3
- I/O JACKS -
OUTPUT Jack provides the audio output from the . The – This ¼” jack SSD
output impedance varies from to k . when powering from 100Ω 25 Please note:
a battery, inserting a plug into the OUTPUT jack turns on the SSD. Remove the
plug from the OUTPUT jack to prolong battery life when not using the SSD.
EXT. TRIG Jack –Connect this jack to the output of an external trigger source.
We recommend using a ¼” TS plug/cable but a TRS plug may also be used as
long as the trigger signal is present on the tip. The input impedance is 2M .
The synthesizer triggers when it receives positive-going pulses or clock SSD
signals. The acceptable trigger amplitude rang is 3V to 15V for unipolar signals e
or +/-3V to +/- for bipolar signals. Nearly all types of gate, clock, and trigger 8V
signals that fall within these voltage ranges will trigger the SSD. Some examples
of accept trigger signals include: electronic drum trigger pads; an electronic able
pulse (as produced, for example, by the EHX Clockworks); a clock generator
(such as the EHX 8 Step Program); gate signals from synthesizers such as V-
Trigger simple clock sync signals from drum machines. ;
Please note: The SSD does not respond to MIDI. Use a MIDI to CV/Gate
converter if you wish to trigger the SSD with a MIDI device.
AUX IN Jack –This ¼” jack is the input for an external sound source. The
signal present at the AUX IN gated amplifierjack connects to the SSD’s internal .
When a plug is inserted into the AUX IN jack, oscillator the SSD’s internal
synthesizer is disconnected from the output. The input impedance is 2.2M .
Use AUX IN to gate external instruments and sound sources with the SSD’s
trigger. Each time you trigger the SSD ̶ whether you use the EXT. TRIG input or
the pushbutton ̶ the AUX IN signal will be heard at the OUTPUT jack. Use the
TIME knob to set the decay time of the AUX IN signal.
9V Power Jack Although the Super Space Drum accepts 9V Batteries, EHX –
supplies your with an Electro-Harmonix 9.6DC-200 power supply. Plug the SSD
output of the AC adapter into the 9V power jack located at the top of the Super
Space Drum. The drSSD aws 25 mA at 9VDC with a center negative plug. Please
do not exceed 12VDC on the SSD’s power jack.
- CHANGING THE BATTERY -
To change your 9V battery, remove the four screws on the bottom of the Super
Space Drum Take off the bottom plate and change the battery. Do not touch the .
circuit board while the bottom plate is off or you risk damaging a component.

Product specificaties

Merk: Electro Harmonix
Categorie: Niet gecategoriseerd
Model: Super Space Drum

Heb je hulp nodig?

Als je hulp nodig hebt met Electro Harmonix Super Space Drum stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd Electro Harmonix

Electro Harmonix

Electro Harmonix Memory Boy Handleiding

16 November 2024
Electro Harmonix

Electro Harmonix Soul POG Handleiding

16 November 2024
Electro Harmonix

Electro Harmonix OD Glove Handleiding

16 November 2024
Electro Harmonix

Electro Harmonix Crayon 69 Handleiding

16 November 2024
Electro Harmonix

Electro Harmonix Good Vibes Handleiding

12 November 2024
Electro Harmonix

Electro Harmonix Cock Fight Handleiding

9 Juli 2024
Electro Harmonix

Electro Harmonix Cock Fight Plus Handleiding

9 Juli 2024
Electro Harmonix

Electro Harmonix Holy Grail Max Handleiding

9 Juli 2024
Electro Harmonix

Electro Harmonix The Worm Handleiding

17 Juni 2024
Electro Harmonix

Electro Harmonix Canyon Echo Handleiding

12 Juni 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Panasonic

Panasonic NB-W250 Handleiding

25 November 2024
Alpine

Alpine CHM-S611 Handleiding

25 November 2024
AOpen

AOpen DE3650-C Handleiding

25 November 2024
Lazer

Lazer Urbanize MIPS Handleiding

25 November 2024
Symmons

Symmons Dia 353GB-24 Handleiding

25 November 2024
SoundTube

SoundTube IPD-RS62-EZ Handleiding

25 November 2024
Moen

Moen Camerist 4905 Handleiding

25 November 2024
Lazer

Lazer Cameleon DLX Handleiding

25 November 2024
DMT

DMT DLD-85 Handleiding

25 November 2024
AOpen

AOpen AM1120T Handleiding

25 November 2024