Electro Harmonix Stereo Pulsar Handleiding

Electro Harmonix Niet gecategoriseerd Stereo Pulsar

Lees hieronder de πŸ“– handleiding in het Nederlandse voor Electro Harmonix Stereo Pulsar (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 27 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/2
Congratulations on your purchase of the Stereo Pulsar, a variable
shape tremolo and panner pedal.
Connected as a mono pedal, the Stereo Pulsar is exactly the same
as the Electro-Harmonix Pulsar that we currently manufactur: a
tremolo pedal that allows significant control over the shape of
modulating waveform. Hook up the Stereo Pulsar in stereo (each
output to a separate amp/mixer channel) and you have a panner
pedal that will send your instrument back and forth between two
amps with the same control over waveform shape. So while one
amp is fading up in volume, the other will be fading down in volume
or even more dramatic: while one amp is on, the other is off.
β€” β€” CONTROLS
SHAPE Switch Selects between Triangle Wave and Square Wave Modes. –
SHAPE Knob – Changes the shape of the waveform that modulates the Tremolo.
Triangle Wave Mode – In this mode the LFO creates a Triangle Wave
oscillation, resulting in a smooth modulation. As the SHAPE knob is turned
from the Counter-Clockwise (minimum) position to the Center (middle)
position, the waveform starts as a rising Sawtooth changing into a Triangle.
From the Center position to the Clockwise (maximum) position, the wave
changes from a Triangle to a falling Sawtooth.
Square Wave Mode – In this mode, the LFO creates a Square Wave,
resulting in a sharp, on/off modulation. As the SHAPE knob is turned from
the Counter-Clockwise (minimum) position to the Center (middle) position,
the wave starts as a Small Pulse Width Wave changing into a Square Wave.
From the Center position to the Clockwise (maximum) position, the wave
changes from a Square Wave to a Large Pulse Width Wave.
DEPTH Knob – Adjusts the amount of Tremolo that will be applied to your signal.
As the DEPTH knob is turned from the Counter-Clockwise (minimum) position to
the Clockwise (maximum) position, the amount of the effect will increase. Maximum
tremolo occurs when the DEPTH knob is set to approximately 2 o’clock. As the
DEPTH knob is turned above 2 o’clock, the tremolo begins to warp by modulating
between positive and negative phase with a rhythmic pattern. To obtain maximum
pan when using the Stereo Pulsar in stereo, the optimum setting for the DEPTH knob
is at approximately 2 o’clock.
RATE Knob – Adjusts the speed of the tremolo or pan effect. As the RATE knob is
turned from the Counter-Clockwise (minimum) position to the Clockwise
(maximum) position, the modulation rate increases.
RATE/STATUS LED If the effect is engaged, the LED will blink at the same rate –
that the effect modulates. In bypass mode, the LED is off. The footswitch
engages/disengages the effect.
INPUT Jack – Connect your instrument’s output to this ¼” mono jack. The input
impedance presented at this jack is 1 Mohm. Plugging a cable into the INPUT jack,
when running the Stereo Pulsar off of a 9V battery, turns the Stereo Pulsar on and
drains the battery.
MAIN OUT Jack –Connect this ¼” mono jack to your amplifier’s input. The
output impedance presented at this jack is 1 kohm. When using the Stereo Pulsar as a
mono device we recommend you use the MAIN OUT jack so that the parameter
labels of the SHAPE knob correspond to what your hear.
STEREO OUT Jack – Connect this ¼” mono jack to your second amplifier’s input.
The output impedance presented at this jack is 1 kohm. When using the Stereo Pulsar
as a stereo device use the STEREO OUT jack for your second channel. You can
connect only the STEREO OUT jack if you want; the tremolo effect will be the same
as from the MAIN OUT jack but the SHAPE knob labels will be reversed. For
example, when the SHAPE knob is set to its clockwise position, the tremolo will
have a falling sawtooth modulating it.
9V Power Jack –The Stereo Pulsar can run off of a 9V battery or you can connect a
9VDC battery eliminator capable of delivering at least 100mA to the 9V power jack.
The optional 9V power supply from Electro-Harmonix is (same as US9.6DC-200BI
used by Boss & Ibanez The battery eliminator must β„’ β„’) 9.6 volts/DC 200mA.
have a barrel connector with center negative. The battery may be left in or taken out
when using an eliminator.
- POWER -
Power from the internal 9-volt battery is activated by plugging into the INPUT jack. The input
cable should be removed when the unit is not in use to avoid running down the battery. If a
battery eliminator is used, the Stereo Pulsar will be powered as long as a wall-wart is
plugged into the wall.
To change the 9-volt battery, you must remove the 4 screws on the bottom of the Stereo
Pulsar. Once the screws are removed, you can take off the bottom plate and change the
battery. Please do not touch the circuit board while the bottom plate is off or you risk
damaging a component.

Product specificaties

Merk: Electro Harmonix
Categorie: Niet gecategoriseerd
Model: Stereo Pulsar

Heb je hulp nodig?

Als je hulp nodig hebt met Electro Harmonix Stereo Pulsar stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd Electro Harmonix

Electro Harmonix

Electro Harmonix Memory Boy Handleiding

16 November 2024
Electro Harmonix

Electro Harmonix Soul POG Handleiding

16 November 2024
Electro Harmonix

Electro Harmonix OD Glove Handleiding

16 November 2024
Electro Harmonix

Electro Harmonix Crayon 69 Handleiding

16 November 2024
Electro Harmonix

Electro Harmonix Good Vibes Handleiding

12 November 2024
Electro Harmonix

Electro Harmonix Cock Fight Handleiding

9 Juli 2024
Electro Harmonix

Electro Harmonix Cock Fight Plus Handleiding

9 Juli 2024
Electro Harmonix

Electro Harmonix Holy Grail Max Handleiding

9 Juli 2024
Electro Harmonix

Electro Harmonix The Worm Handleiding

17 Juni 2024
Electro Harmonix

Electro Harmonix Canyon Echo Handleiding

12 Juni 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Panasonic

Panasonic NB-W250 Handleiding

25 November 2024
Alpine

Alpine CHM-S611 Handleiding

25 November 2024
AOpen

AOpen DE3650-C Handleiding

25 November 2024
Lazer

Lazer Urbanize MIPS Handleiding

25 November 2024
Symmons

Symmons Dia 353GB-24 Handleiding

25 November 2024
SoundTube

SoundTube IPD-RS62-EZ Handleiding

25 November 2024
Moen

Moen Camerist 4905 Handleiding

25 November 2024
Lazer

Lazer Cameleon DLX Handleiding

25 November 2024
DMT

DMT DLD-85 Handleiding

25 November 2024
AOpen

AOpen AM1120T Handleiding

25 November 2024