Electro Harmonix Nano Bass Big Muff Pi Handleiding

Electro Harmonix Niet gecategoriseerd Nano Bass Big Muff Pi

Lees hieronder de πŸ“– handleiding in het Nederlandse voor Electro Harmonix Nano Bass Big Muff Pi (1 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 28 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/1
NANO BASS BIG MUFF PI
Congratulations! You have just purchased the finest harmonic distortion-
sustain device for the electric bass guitar player, now in a smaller enclosure:
the Nano Bass Big Muff! Please review this manual to learn the unique
potential of this pedal.
The Nano Bass Big Muff draws its roots from the legendary Sovtek battle-
tank green Big Muff Pi manufactured in the as well as from the original β€˜90s
Electro-Harmonix Big Muff Pi from the early 70s. These Big Mu are often β€˜ffs
employed by bass players to thicken up their sound or to give them over-
the-top low end growl. The Nano Bass Big Muff takes the best characteristics
from both of these classics and employs sonic elements that were specifically
designed for yo bass. ur
-OPERATING INSTRUCTIONS-
SUSTAIN Knob β€” adjusts the amount of sustain and distortion.
TONE Knob β€” provides a range of sounds from high treble to deep bass. As
you turn the knob clockwise, treble increases and bass decreases.
VOL Knob β€” sets e output level of the distortion effect. When the toggle th
switch is set to DRY, the volume knob has no effect on the output level of
the dry signal.
DRY Toggle Switch β€” when set to DRY mode, the original dry signal
present at the input jack is mixed with the output of the distortion circuit.
The level of the Dry signal is constant and will not change as you turn the
Volume knob up or down allowing you to set the level of the distortion effect
against your dry signal. Flip the DRY switch to the left, away om the DRY fr
label, to mute the dry signal; now you will hear only Big Muff distortion.
Footswitch & Status LED β€”When the LED is lit, the Nano Bass Big Muff
effect is active. When the LED is off, the Nano Bass Big Muff is in True
Bypass mode. The Footswitch toggles between effect and bypass modes.
INPUT Jack – Nano Bass Big MuffThis ¼” jack is the audio input to the .
The input impedance presented at this jack is 110 k . Ω
AMP Jack – Nano Bass Big Muff. This ¼” jack is the audio output from the
When the Nano Bass Big Muff is in True Bypass mode, the AMP jack is
connected directly to the INPUT jack.
9V Power Jack –The Nano Bass Big Muff Pi is powered from a 9V battery
or you can use an optional 9VDC AC Adapter capable of delivering at least
25mA to the 9V power jack, such as the EHX9.6DC-200. The AC Adapter
must have a center negative plug. The battery may be left in or taken out
when using an AC Adapter. The Nano Bass Big Muff has a current draw of
approximately 4mA at 9VDC.
We recommend the Electro-Harmonix US96DC-200BI
9.6VDC/200mA AC Adapter to power your Nano Big Muff Pi.
-CHANGING THE BATTERY-
To change the 9-Volt battery, you must remove the 4 screws on the bottom
of the Nano Bass Big Muff Pi. Once the screws are removed, you can take off
the bottom plate and change the battery. Please do not touch the circuit
board while the bottom plate is off or you risk damaging a component.
- WARRANTY INFORMATION -
Please register online at http://www.ehx.com/product-registration or complete and
return the enclosed warranty card within 10 days of purchase. Electro-Harmonix will
repair or replace, at its discretion, a product that fails to operate due to defects in
materials or workmanship for a period of one year from date of purchase. This
applies only to original purchasers who have bought their product from an authorized
Electro-Harmonix retailer. Repaired or replaced units will then be warranted for the
unexpired portion of the original warranty term. If you should need to return your
unit for service within the warranty period, please contact EHX Customer Service at
718 937- -8300 or info@ehx.com for a Return Authorization Number. Along with your
pedal, please include a brief description of the problem as well as your name,
address, telephone number, copy of your receipt, and a check or money order.
Ship to: United States - $12
Electro-Harmonix Canada - $15
C/O New Sensor Corporation Europe and outside countries - $25
55-01 2nd Street
Long Island City, NY, 11101
Attn: Service Department
Please make checks/money orders payable to New Sensor Corporation.
To hear demos on all X pedals visit us on the web at EH www.ehx.com
Email us at info@ehx.com


Product specificaties

Merk: Electro Harmonix
Categorie: Niet gecategoriseerd
Model: Nano Bass Big Muff Pi

Heb je hulp nodig?

Als je hulp nodig hebt met Electro Harmonix Nano Bass Big Muff Pi stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Electro Harmonix

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd