Electro Harmonix Micro Synth Handleiding


Lees hieronder de đź“– handleiding in het Nederlandse voor Electro Harmonix Micro Synth (2 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 48 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
MICRO SYNTH
Analog Guitar Synthesizer
Congratulations on your purchase of the Electro-Harmonix XO Micro Synth for guitar. This is a
very powerful tool for musical expression. Please take a few minutes to familiarize yourself with
the Micro Synth’s controls to learn how to get the best out of this special instrument.
The can create some of the most popular synthesizer textures at a fraction of the Micro Synth
cost for such capabilities. Its four voices: GUITAR OCTAVE, SUB OCTAVE AND SQUARE ,
WAVE are completely independent and fully mixable. The can modify these MICRO SYNTH
signals with envelope control for a variety of “bowed” or “blown” sounds. In addition, a
sophisticated swept filter control allows highly variable frequency adjustments to be applied to
the overall output signal. When combined, these controls offer the user a creative capability that
is virtually limitless.
PREAMP GAIN ADJUSTMENT: The preamp gain in the Micro Synth has been set at the
factory for use with a guitar equipped with single-coil pickups. If you will be using another
instrument with higher or lower output, it may be necessary to readjust this setting. A
screwdriver or alignment tool with a tip width of no more than 1/16" is required. To access the
preamp gain adjustment, remove the bottom plate from the Micro Synth. Look for the small trim
pot in the lower left corner of the circuit board, it is labeled TRIM1 GAIN TRIM. Turning the trim
pot clockwise will increase the preamp gain. Turning it counter-clockwise will decrease preamp
gain. Please do not touch any other components when the bottom plate is removed or you risk
damaging the circuit board or the components.
OPERATION: The Micro Synth’s controls operate as described below. In all cases, high-
numbered control settings increase the level of the given effect.
FOOTSWITCH and Status LED – The Footswitch selects either effect mode or True Bypass.
When the Status LED is lit, the Micro Synthesizer is in effect mode. When the Status LED is off,
the Micro Synth is in True Bypass mode.
TRIGGER – Determines the input volume at which the filter circuits will “turn on.” It does not
affect any other circuitry. If the TRIGGER is set too high, the filter may “stutter” due to multiple
triggering. This is especially true if full chords are played. It is best to set the TRIGGER at
exactly the sensitivity needed for your playing.
WARNING:
Your
Micro Synth
comes equipped with
an Electro-Harmonix
9.6DC-200BI power
supply
(same as used by Boss & Ibanez 9.6 Volts DC 200mA). The Micro Synth requires 55mA at ™ ™
9VDC with a center negative ug. pl
The Micro Synth does not take batteries. Using the wrong
adapter may damage your unit and void the warranty.
-Power-
9V Power Jack –Connect the output plug of the supplied AC Adaptor into the 9V power jack
at the top of the Micro Synth. The Micro Synth maximum current requirement is 55mA at ’s
9VDC. The polarity of the power jack is center negative. The maximum allowable power supply
voltage is VDC. 12
- WARRANTY INFORMATION -
Please register online at http://www.ehx.com/product-registration or complete and return the
enclosed warranty card within 10 days of purchase. Elect -Harmonix will repair or replace, at ro
its discretion, a product that fails to operate due to defects in materials or workmanship for a
period of one year from date of purchase. This applies only to original purchasers who have
bought their product from an authorized Electro-Harmonix retailer. Repaired or replaced units
will then be warranted for the unexpired portion of the original warranty term.
If you should need to return your unit for service within the warranty period, please contact the
appropriate office listed below. Customers outside the regions listed below, please contact EHX
Customer Service for information on warranty repairs at info@ehx.com or +1- -937-8300. 718
USA and Canadian customers: please obtain a Return Authorization Number (RA#) from
EHX Customer Service before returning your product. Include with your returned unit: a written
description of the problem as well as your name, address, telephone number, e-mail address,
and RA#; and a copy of your receipt clearly showing the purchase date.
United States & Canada
EHX CUSTOMER SERVICE
ELECTRO-HARMONIX
c/o NEW SENSOR CORP.
47-50 33RD STREET
LONG ISLAND CITY, NY 11101
Tel: 718-937-8300
Email: info@ehx.com
Europe
JOHN WILLIAMS
ELECTRO-HARMONIX UK
13 CWMDONKIN TERRACE
SWANSEA SA2 0RQ
UNITED KINGDOM
Tel: +44 179 247 3258
Email: electroharmonixuk@virginmedia.com
This warranty gives a purchaser specific legal rights. A purchaser may have even greater rights
depending upon the laws of the jurisdiction within which the product was purchased.
To hear demos on all EHX pedals visit us on the web at www.ehx.com
Email us at info@ehx.com


Product specificaties

Merk: Electro Harmonix
Categorie: Niet gecategoriseerd
Model: Micro Synth

Heb je hulp nodig?

Als je hulp nodig hebt met Electro Harmonix Micro Synth stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Electro Harmonix

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd