Electro Harmonix 5MM Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Electro Harmonix 5MM (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 51 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
5MM
Guitar Power Amplifier
Congratulations on your purchase of the 5 MM guitar amplifier! The 5 produces MM
a formidable 5 watts and small enou fit your pocket. 2. is gh to in The 5 sweet MM’s
sound and extreme portability will make it integral part an of any rig where a high-
powered amp not required. 5 was designed with the guitar mind and is The MM in
can used alone, with your favorite overdrive preamp driving the input be or or to
the 5 5 also sounds great with other instruments such bass and MM. The MM as
keyboard. Please read this manual learn the correct use the 5 to of MM.
- CONTROLS and JACKS -
VOLUME CONTROL This knob controls the volume loudness the or of
amplifier. As you turn the VOLUME knob clockwise, the output gets louder. 5MM’s
At a certain point the VOLUME travel, the output will start overdrive, in knob’s to
at this point you are beginning to exceed 2.5 Watts on your loudest notes. Turning
the VOLUME knob further clockwise will produce a more overdriven sound which
is the result pure power amp saturation. of
BRIGHT/NORM CONTROL When engaged, the BRIGHT switch adds a
subtle top boost presence your signal. When the NORM position, the top or to in
boost defeated.is
INPUT Jack Plug the output your guitar, effects pedals any other of or
instrument into the INPUT jack using a standard instrument cable. input ¼” The
impedance presented the INPUT jack 2 M . at is
8 OUTPUT Jack 16 Connect the OUTPUT jack directly a 5MM’s to
speaker cabinet. 8 onl 16 y.
WARNING: NEVER CONNECT THE OUTPUT THE 5MM OF TO THE INPUT OF
ANOTHER AMPLIFIER, AN EFFECTS PEDAL, MIXER, COMPUTER, COMPUTER
INTERFACE OTHER SIMILAR DEVICE.OR
WARNING: THE 5 A POWER AMP, NOT EFFECTS PEDAL. Do not MM IS AN
connect output 5 the input another amplifier, effects the of the MM to of
pedal, mixer, computer, computer interface other similar device. Connect or
the output the 5 8 - of MM to an 16 speaker cabinet ONLY.
SPEAKER CABLE: recommend using a between the 5 We speaker cable MM
and speaker cabinet you would with any power amplifier, though you can as get
away with using instrument cable in a pinch. impedance the speaker an if The of
cabinet must rated between 8 and ( = ohms). 8 the ideal load be 16 is
for the 5MM. Additionally the speaker cabinet must have a power rating equal to
or greater than the output power capability. recommend a speaker 5MM’s We
cabinet with least a W rating. at 10
POWER WARNING: UP Make sure the 5 output connected a speaker MM’s is to
cabinet before applyi power. ng
9 VDC/500mA POWER Jack Connect the output plug from the 5 MM’s
supplied power supply the power jack the top the unit. highly to at of We
recommend using the power supply that the 5 was supplied with. polarity MM The
of the power jack center-negative. is
- WARNINGS (PLEASE READ!!!) -
THE 5MM A POWER AMP, EFFECTS PEDAL:IS NOT AN Connect the output
of the 5MM a speaker cabinet only. THE OUTPUT to DO NOT CONNECT OF THE
5 THE INPUT ANOTHER AMPLIFIER, EFFECTS PEDAL, MIXER, MM TO OF
COMPUTER, COMPUTER INTERFACE similar device. or
SPEAKER CABINET: Only plug the output the 5 into a speaker cabinet of MM
rated for impedance the range 8 ohms); the speaker an in of to 16 (8 to 16
cabinet power rating should W greater. be 10 or
OUTPUT FIRST THEN POWER: Connect the output the 5MM a proper of to
speaker cabinet before applying power the 5 you connect the 5 a to MM. If MM to
speaker cabinet while powered up, the 5MM may automatically mute its it is
output prevent a short circuit the output jack. this situation simply to on In
remove power from the 5 wait a few seconds and then MM, re-apply power the to
5 should work normally. MM, it
- FCC COMPLIANCE -
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: This device may cause harmful interference, and device must (1) not (2) this
accept any interference received, including interference that may cause undesired operation.
If device installed and used accordance with the instructions, may cause the is not in it
harmful interference radio communications and to void the user's authority to guarantee the
equipment.
Note:
This equipment has been tested and comply with a Class B found to the limits for
digital device, pursuant part 15 FCC Rules. These designed provide to of the limits are to
reasonable protection against harmful interference a residential installation. This in
equipment generates, uses and can radiate radio frequency energy and, installed and if not
used accordance instructions, may cause harmful interference radio in with the to
communications. However, there guarantee that interference will occur a is no not in
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can determined turning equipment and user be by the off on, the is
encouraged try correct the interference more following measures: to to by one or of the
Reorient relocate the receiving antenna. or
Increase separation between the equipment and receiver. the
Connect equipment into outlet a circuit different from that which the an on to the
receiver connected. is
Consult dealer experienced radio/TV technician help the or an for .
Modifications expressly approved manufacturer could void user's authority not by the the to
operate equipment under FCC rules.the
The logo indicates that this product has been tested and shown CE to
conform with all applicable European Conformity directives.


Product specificaties

Merk: Electro Harmonix
Categorie: Niet gecategoriseerd
Model: 5MM

Heb je hulp nodig?

Als je hulp nodig hebt met Electro Harmonix 5MM stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Electro Harmonix

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd