CRUX DKFD-60L Handleiding


Lees hieronder de đź“– handleiding in het Nederlandse voor CRUX DKFD-60L (7 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 15 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/7
R I REP LA TAD O CEM EN
S R ET T IONWC EN
+ +
R
INTERFACING SOLUTIONS
DKFD-60L
Radio Replacement Interface with Steering Wheel Control Retention
with Dash Kit for FORD, LINCOLN & MERCURY
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.091522
1 of 7
- Retains factory-installed Subwoofer.
- Retains Steering Wheel Controls via built-in, pre-programmed interface.
- Provides Accessory Power (2A MAX).
- Includes dask kit (double DIN or single DIN with pocket).
PRODUCT FEATURES:
PARTS INCLUDED:
SWRFD-60L MODULE SWRFD-60L HARNESS Antenna Adapter SWC CABLE
R I REP LA TAD O CEM EN S R ET T IONWC EN
+ +
R
INTERFACING SOLUTIONS
DKFD-60L
Radio Replacement Interface with Steering Wheel Control Retention
with Dash Kit for FORD, LINCOLN & MERCURY
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.091522
2 of 7
INSTALLATION DIAGRAM:
AFTERMARKET
RADIO
+12V Constant Yellow
+12V ACC Red
12V Ground Black
Illumination Orange
Vehicle Speed Sense Red/White (or Brown)
Subwoofer Amp Turn-on Blue/White
Antenna Turn-on Blue
Right Front (+) Gray
Right Front (-) Gray/Black
Left Front (+) White
Left Front (-) White/Black
Right Rear (+) Violet
Right Rear (-) Violet/Black
Left Rear (+) Green
Left Rear (-) Green/Black
Subwoofer
Factory Aux Input
24-Pin
Plug*
16-Pin
Plug*
8-Pin
Plug*
TO FACTORY
HARNESS
12-Pin
Connector
SWC TYPE
(Connect PINK to PINK wire)
Subwoofer
Converter
Module
*Inspect that the male pins are
properly lined up before plugging
into the factory harness.
SWRFD-60L
MODULE
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
AFTERMARKET
RADIO SELECTOR
(See Chart)
FORD
SWC SETTING
(OFF OFF OFF OFF)
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
Cap or insulate if
not being used
Kenwood/JVC (BLUE / YELLOW) Insulate with tape
if not being used
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS” section.
Blue/Yellow
(Not Used)
1. Only supports analog Steering Wheel Control type.
2. Use part number SWRFD-60 for CAN Bus Steering Wheel Control.
3. Output signal stated above may not cover all Year/Model.
4. Does not retain SYNC.
NOTES:
R I REP LA TAD O CEM EN
S R ET T IONWC EN
+ +
R
INTERFACING SOLUTIONS
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.091522
3 of 7
DKFD-60L
Radio Replacement Interface with Steering Wheel Control Retention
with Dash Kit for FORD, LINCOLN & MERCURY
ANALOG CONNECTION:
WIRE VIEW
PINK BLACK
Crux 24-Pin Connector
HOW TO DETERMINE IF THE VEHICLE HAS ANALOG SWC:
Analog Steering Wheel Control (SWC) signal vehicles will have
wires populated and line up to the PINK and BLACK wire on the
24-Pin Crux connector.
If one wire is missing then you will need to use Crux part number
SWRFD-60.
DIP SWITCH SETTINGS:
FORD STEERING WHEEL CONTROL DIP SWITCH SETTING:
AFTERMARKET RADIO DIP SWITCH SETTINGS:
RADIO BRAND: DIP: 1 2 3 4
Atoto, Dual, Farenheit, Jensen, Pioneer
Power Acoustik, Soundstream
Alpine
Clarion
Kenwood
JVC
Boss, Old Sony
New Sony
OFF OFF ON ON
OFF OFF ON ON
OFF OFF ON ON
OFF OFF OFF OFF
OFF ON ON OFF
OFF ON ON ON
OFF ON OFF ON
OFF ON OFF OFF
OFF OFF ON OFF
SWC MODULE
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
NOTE:
check the aftermarket radio’s manual to see if the SWC buttons need to be pro ammed.gr
DIP: 5 6 7 8
Ford OFF OFF OFF OFF
SWRFD-60L
SWC MODULE
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
NOTE: Insulate the Blue/Yellow and Green wires if not being used.
3.5MM SWC CABLE
Plug in the 3.5MM to 4-Pin SWC cable to the SWC module.
RED to SWC Key 1
WHITE to SWC Key 2
SHIELD to SWC Ground
connect the SWC wires as follows:
Note that there are some radios that only have
SWC1 and SWC2, in this case “shield” does not
need to be connected.


Product specificaties

Merk: CRUX
Categorie: Niet gecategoriseerd
Model: DKFD-60L

Heb je hulp nodig?

Als je hulp nodig hebt met CRUX DKFD-60L stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd CRUX

CRUX

CRUX ACPLR-01 Handleiding

12 November 2024
CRUX

CRUX ACPMB-50W Handleiding

12 November 2024
CRUX

CRUX ACPBM-77Z Handleiding

12 November 2024
CRUX

CRUX ACPAD-81Y Handleiding

12 November 2024
CRUX

CRUX ACPAD-01 Handleiding

12 November 2024
CRUX

CRUX ACPBM-77X Handleiding

12 November 2024
CRUX

CRUX ACPLX-12XW Handleiding

12 November 2024
CRUX

CRUX ACPMB-45W Handleiding

12 November 2024
CRUX

CRUX ACPBM-77Y Handleiding

12 November 2024
CRUX

CRUX DKGM-16B Handleiding

5 November 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd