CRUX CS-TJ20 Handleiding

CRUX Niet gecategoriseerd CS-TJ20

Lees hieronder de 📖 handleiding in het Nederlandse voor CRUX CS-TJ20 (5 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 61 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/5
CS-TJ20
Radio Replacement with Steering Wheel Control Retention for
LEXUS & TOYOTA Vehicles with JBL Systems
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
RADI O REPL ACEME NT
SWC RET ENTIO N
+
R
INTERFACING SOLUTIONS
PRODUCT FEATURES:
- Retains factory features in select Lexus and Toyota vehicles with JBL Harman-Becker Digital-Synthesis Amplier,
including JBL (Pioneer-made) ampliers while funconing with an aermarket radio.
- Pre-programmed to retain factory Steering Wheel Controls.
- iPhone Voice Recognion (VR) feature from SWC on select Kenwood, Pioneer, Alpine and JVC radios.
- Variable audio gain adjustment to level match the aermarket radio and factory amplier.
- Retains OEM 3.5mm Auxiliary Audio Input.
- Supports BT-HF/A2DP/AVRCP prole on select aermarket radio models.
- Supports Pick Up/End Call, Pick up and Toggle between 1st and 2nd incoming call, AVRCP Track, Seek.
- EIA color coded wiring for easy installaon.
NOTES:
1. Le-Right Balance Audio Control and Front-Rear Audio Fading is not supported.
2. Please make sure factory radio Balance and Fade opons are centered before removing the radio.
PARTS INCLUDED:
CS-TJ20 Module TY-A Harness
(For Newer Models)
TY-B Harness
(For Older Models)
3.5MM to 4-pin SWC Cables OEM Camera Retenon Harness 16 to 24 Pin Camera Adapter
1. In some Lexus/Toyota vehicles 2006 and older, the mute circuit is located in the same pin locaon as the amplier
turn-on on the OEM harness. If no audio is heard aer the installaon is complete, disconnect the BLUE/WHITE wire
on the CS-TJ20 T-Harness from the aermarket radio AMP Turn-on wire. Insulate with tape to avoid short circuits.
2. Before connecng the 3.5mm SWC Cable, thoroughly wipe it clean with the alcohol cleansing pad provided. This will
ensure a solid contact with the aermarket radio SWC circuit.
3. To retain the factory AUXILIARY INPUT opon in the vehicle, the aermarket radio must have an “Auxiliary Audio
Input” feature. Please check your aermarket radio manual for details.
IMPORTANT INSTALLATION NOTES:
rev.091719
1 of 5
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
RADI O REPL ACEME NT
SWC RET ENTIO N
+
R
INTERFACING SOLUTIONS
rev.091719
INSTALLATION DIAGRAM:
AFTERMARKET
RADIO
CS-TJ20 MODULE 1 2 3
ON
1 2 3
ON
AFTERMARKET
RADIO SELECTOR
(See Chart)
GAIN
ADJUSTMENT
+12V Constant Yellow
+12V ACC Red
Ground Black
Illumination Output Orange
Amp Turn-On Blue/ White
Antenna Turn On Blue
Vehicle Speed Sense Output Red/Black
Parking Brake Output Brown
Reverse Gear Output Red
Right Front + Gray
Right Front - Gray/Black
Left Front + White
Left Front - White/Black
Audio Input Red/White RCA
(Retains Factory AUX Input)
12-Pin Black
Connector
Cap or insulate if
not being used
BLUE / YELLOW KENWOOD / JVC SWC WIRED
3.5MM SWC CABLES (Option A or B)
Use the proper 3.5MM to 4-Pin cable for your radio.
Plug in the selected 3.5MM SWC cable to the 4-pin port
on the CS-TJ20 module.
Insulate with tape
if not being used
From CS-TJ20 Harness
To CS-TJ20 Module
CS-TJ20 Module
To Aftermarket Radio Camera Input
To 2 Pin Camera Power Connector
on CS-TJ20 Harness
CS-TJ20 OEM Camera Retention Harness
+12V Constant Yellow
+12V ACC Red
Ground Black
Illumination Output Orange
Amp Turn-On Blue/ White
Antenna Turn On Blue
Right Front + Gray
Right Front - Gray/Black
Left Front + White
Left Front - White/Black
Audio Input Red/White RCA
(Retains Factory AUX Input)
To CS-TJ20 Module
RADIO REPLACEMENT MODULE
TOYOTA
For JBL Amplied Systems
www.cruxint
erfacing.com
SWCGAIN
AFTERMARKET
RADIO
TY-B
Harness
TY-A
Harness
CS-TJ20 OEM Camera
Retention Harness
(See Below)
Yellow RCA
(To Aftermarket Radio Camera Input)
To 24-Pin OEM
Camera Harness
16 to 24 Pin Camera Adapter
The CS-TJ20 includes a camera harness with a 12V to 6V voltage converter to retain the OEM camera (if equipped).
Some older models use a16-Pin OEM camera connector. In this case, use the supplied 16 to 24-Pin Camera Adapter.
24-Pin
Option A:
Alpine, Clarion, JVC and Kenwood units
Option B:
Blaupunkt, Boss, Dual, Farenheit, Jensen, Pioneer,
Power Acoustik, Sony, Soundstream & most o-brand Radios
NOTE: Aftermarket radio rear speaker output leads are not used on both harnesses. Insulate with tape.
CS-TJ20
Radio Replacement with Steering Wheel Control Retention for
LEXUS & TOYOTA Vehicles with JBL Systems
2 of 5
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
RADI O REPL ACEME NT
SWC RET ENTIO N
+
R
INTERFACING SOLUTIONS
rev.091719
CS-TJ20
Radio Replacement with Steering Wheel Control Retention for
LEXUS & TOYOTA Vehicles with JBL Systems
SETTING THE AFTERMARKET RADIO BRAND
This step is done on the CS-TJ20 SWC Module. With the key in the o posion, set the DIP switches to the
corresponding radio listed below.
DIP SETTING dB Volts
OFF OFF OFF
OFF OFF ON
OFF ON OFF
OFF ON ON
ON OFF OFF
ON OFF ON
ON ON OFF
ON ON ON
0 dB
1.7 dB
3.5 dB
5.2 dB
7.2 dB
9.1 dB
11 db
12.9 dB
+7mV
+9mV
+10mV
+15mV
+18mV
+22mV
+27mV
Use the gain adjustment to level match the aermarket radio audio output with the OE amplier input.
GAIN ADJUSTMENTS:
1 2 3
ON
1 2 3
ON
AFTERMARKET
RADIO SELECTOR
CSTJ-20
MODULE
GAIN ADJUSTMENT
3 of 5
4-PIN SWC CABLE
Use the proper 3.5MM to 4-Pin SWC cable for the aermarket radio you are using.
OPTION A is used for ALPINE, CLARION, JVC, and KENWOOD units (Blue/Yellow wire is aached)
OPTION B is used for BLAUPUNKT, BOSS, DUAL, FARENHEIT, JENSEN, POWER ACOUSTIK, PIONEER,
SONY, SOUNDSTREAM and Most O-Brand Radios.
NOTE: Cap or insulate the 3.5mm plug or Blue/Yellow wire if not being used.
RADIO BRAND: DIP: 1 2 3
1 2 3
ON
1 2 3
ON
AFTERMARKET
RADIO SELECTOR
SWRTY-61J
Module
Dual, Fahrenheit, Jensen, Pioneer
Power Acoustik, Soundstream
Blaupunkt, Most o brand Radios
Alpine
Clarion
Kenwood
JVC
Sony, Boss
OFF ON ON
OFF ON ON
OFF ON ON
OFF OFF OFF
ON ON OFF
ON ON ON
ON OFF ON
ON OFF OFF
NOTE: For Blaupunkt, Dual, Farenheit, Power Acoustik, Soundstream, and most o-brand radios,
check the aftermarket radio’s manual to see if the SWC buttons need to be programmed.

Product specificaties

Merk: CRUX
Categorie: Niet gecategoriseerd
Model: CS-TJ20

Heb je hulp nodig?

Als je hulp nodig hebt met CRUX CS-TJ20 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd CRUX

CRUX

CRUX ACPLR-01 Handleiding

12 November 2024
CRUX

CRUX ACPMB-50W Handleiding

12 November 2024
CRUX

CRUX ACPBM-77Z Handleiding

12 November 2024
CRUX

CRUX ACPAD-81Y Handleiding

12 November 2024
CRUX

CRUX ACPAD-01 Handleiding

12 November 2024
CRUX

CRUX ACPBM-77X Handleiding

12 November 2024
CRUX

CRUX ACPLX-12XW Handleiding

12 November 2024
CRUX

CRUX ACPMB-45W Handleiding

12 November 2024
CRUX

CRUX ACPBM-77Y Handleiding

12 November 2024
CRUX

CRUX DKGM-16B Handleiding

5 November 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Kolcraft

Kolcraft MLB Chicago Cubs Handleiding

26 November 2024
Kolcraft

Kolcraft MLB New York Yankees Handleiding

26 November 2024
Kolcraft

Kolcraft MLB San Francisco Giants Handleiding

26 November 2024
Kolcraft

Kolcraft MLB St. Louis Cardinals Handleiding

26 November 2024
Nedis

Nedis POCO106 Handleiding

26 November 2024
Nedis

Nedis BTSM1GY Handleiding

26 November 2024
Turbosound

Turbosound TPOLEAJ-01 Handleiding

26 November 2024
Turbosound

Turbosound TSTAND-01 Handleiding

26 November 2024
IFM

IFM TAD981 Handleiding

26 November 2024
IFM

IFM TAD961 Handleiding

26 November 2024