Cisco Aironet 1542D Handleiding

Cisco Access point Aironet 1542D

Lees hieronder de 📖 handleiding in het Nederlandse voor Cisco Aironet 1542D (74 pagina's) in de categorie Access point. Deze handleiding was nuttig voor 43 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/74
Cisco Systems, Inc.
www.cisco.com
Cisco has more than 200 offices worldwide.
Addresses, phone numbers, and fax numbers
are listed on the Cisco website at
www.cisco.com/go/offices.
Cisco Aironet 1540 Series Outdoor Access
Points Hardware Installation Guide
Text Part Number:
THE SPECIFICATIONS AND INFORMATION REGARDING THE PRODUCTS IN THIS MANUAL ARE SUBJECT TO CHANGE WITHOUT NOTICE. ALL
STATEMENTS, INFORMATION, AND RECOMMENDATIONS IN THIS MANUAL ARE BELIEVED TO BE ACCURATE BUT ARE PRESENTED WITHOUT
WARRANTY OF ANY KIND, EXPRESS OR IMPLIED. USERS MUST TAKE FULL RESPONSIBILITY FOR THEIR APPLICATION OF ANY PRODUCTS.
THE SOFTWARE LICENSE AND LIMITED WARRANTY FOR THE ACCOMPANYING PRODUCT ARE SET FORTH IN THE INFORMATION PACKET THAT
SHIPPED WITH THE PRODUCT AND ARE INCORPORATED HEREIN BY THIS REFERENCE. IF YOU ARE UNABLE TO LOCATE THE SOFTWARE LICENSE
OR LIMITED WARRANTY, CONTACT YOUR CISCO REPRESENTATIVE FOR A COPY.
The following information is for FCC compliance of Class A devices: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case users will be required
to correct the interference at their own expense.
The following information is for FCC compliance of Class B devices: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If the equipment causes interference to radio or television reception, which can be
determined by turning the equipment off and on, users are encouraged to try to correct the interference by using one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV tech
nician for help.
Modifications to this product not authorized by Cisco could void the FCC approval and negate your authority to operate the product.
The Cisco implementation of TCP header compression is an adaptation of a program developed by the University of California, Berkeley (UCB) as part of UCB’s public
domain version of the UNIX operating system. All rights reserved. Copyright © 1981, Regents of the University of California.
NOTWITHSTANDING ANY OTHER WARRANTY HEREIN, ALL DOCUMENT FILES AND SOFTWARE OF THESE SUPPLIERS ARE PROVIDEDAS ISWITH
ALL FAULTS. CISCO AND THE ABOVE-NAMED SUPPLIERS DISCLAIM ALL WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, WITHOUT
LIMITATION, THOSE OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT OR ARISING FROM A COURSE OF
DEALING, USAGE, OR TRADE PRACTICE.
IN NO EVENT SHALL CISCO OR ITS SUPPLIERS BE LIABLE FOR ANY INDIRECT, SPECIAL, CONSEQUENTIAL, OR INCIDENTAL DAMAGES, INCLUDING,
WITHOUT LIMITATION, LOST PROFITS OR LOSS OR DAMAGE TO DATA ARISING OUT OF THE USE OR INABILITY TO USE THIS MANUAL, EVEN IF CISCO
OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this
URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership
relationship between Cisco and any other company. (1721R)
Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be actual addresses and phone
numbers. Any examples, command display
output, network topology diagrams, and other figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses or phone numbers in
illustrative content is unintentional and coincidental.
© 2017 Cisco Systems, Inc. All rights reserved.
iii
Cisco Aironet 1540 Series Outdoor Access Point Hardware Installation Guide
C O N T E N T S
Preface vii
Objectives vii
Audience vii
Organization vii
Conventions viii
Related Documents ix
Obtaining Documentation, Support, and Security Guidelines x
C H A P T E R
1Overview 1-1
About the 1540 Series Access Points 1-1
Access Point Models 1-2
Regulatory Domains 1-2
Hardware Features 1-3
Ports and Connectors 1-3
AP1542I Internal Omni Antenna 1-5
AP1542D Internal Directional Antenna 1-5
Power Sources 1-6
Ethernet (PoE) Port 1-6
Network Deployment Examples 1-7
Wireless Backhaul 1-7
Point-to-Point Bridging 1-7
Point-to-Multipoint Bridging 1-8
Point-to-Multipoint Mesh Network 1-9
Layer 3 Network Operation 1-10
C H A P T E R
2Installing the Access Point 2-1
Unpacking the Access Point 2-2
Package Contents 2-2
Optional Tools and Hardware From Cisco 2-2
Additional Tools and Hardware Required for Installation 2-3
Pre-Installation Checks and Installation Guidelines 2-3
Typical Access Point Installation Components 2-5


Product specificaties

Merk: Cisco
Categorie: Access point
Model: Aironet 1542D
Kleur van het product: Grijs
Gewicht: 1250 g
Breedte: 200 mm
Diepte: 150 mm
Hoogte: 61 mm
Internationale veiligheidscode (IP): IP67
LED-indicatoren: Ja
Plaatsing: Pole,Wall
Frequentieband: 2.412 - 2.472, 5.26 - 5.32, 5.66 - 5.7, 5.745 - 5.825 GHz
Aantal Ethernet LAN (RJ-45)-poorten: 1
Vermogensverbruik (max): 13.9 W
Certificering: UL60950\nCAN/CSA-C22.2 No. 60950\nIEC 60950\nEN 60950\nEN61000-4-5\nEN61000-4-4\nEN61000-4-3\nEN61000-4-2\nFCC\nRSS-210\nRSS-102\nAS/NZS 4268.2003\nARIB-STD 66 (Japan) \nARIB-STD T71 (Japan) \nEN 300 328\nEN 301 893\nICES-003 \nEN 301 489-1, -17
MIMO: Ja
Ethernet LAN, data-overdrachtsnelheden: 10,100,1000 Mbit/s
Netwerkstandaard: IEEE 802.11a,IEEE 802.11ac,IEEE 802.11b,IEEE 802.11g,IEEE 802.11i,IEEE 802.11n,IEEE 802.1x,IEEE 802.3af,IEEE 802.3at
Ondersteunde beveiligingsalgoritmen: AES,EAP-PEAP,EAP-SIM,EAP-TLS,EAP-TTLS,IPSec,LEAP,WPA,WPA2
Soort antenne: Intern
Antennas quantity: 2
Antenne versterkingsniveau (max): 9 dBi
Aantal gebruikers: 400 gebruiker(s)
Temperatuur bij opslag: -40 - 85 °C
Luchtvochtigheid bij opslag: 5 - 95 procent
Reset button: Ja
MAC adres filtering: Ja
MIMO-type: Multi User MIMO
Maximale overdrachtssnelheid van gegevens: 1100 Mbit/s
2,4 GHz: Ja
5 GHz: Ja
Kanaalbandbreedte: 80 MHz
Maximal-Ratio Combining (MRC): Ja
Cyclic Shift Diversity (CSD): Ja
Gegevenseenheid-aggregatie: A-MSDU, A-MPDU
Power over Ethernet (PoE): Ja
Antennefuncties: Ingebouwde antenne
Maximale overdrachtssnelheid van gegevens (5 GHz): 867 Mbit/s
Aantal kanalen: 25 kanalen
WAN-poort: Ethernet (RJ-45)
Zendvermogen: 27 dBmW
Dynamic Frequency Selection (DFS): Ja
Bedrijfstemperatuur (T-T): -40 - 65 °C
Relatieve vochtigheid in bedrijf (V-V): 5 - 95 procent
Aantal producten inbegrepen: 1 stuk(s)
Type antennerichting: Directioneel
Polarisatie: Dubbele polarisatie

Heb je hulp nodig?

Als je hulp nodig hebt met Cisco Aironet 1542D stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Access point Cisco

Handleiding Access point

Nieuwste handleidingen voor Access point