Cisco AIR-CAP702I-S-K9 Handleiding

Cisco Access point AIR-CAP702I-S-K9

Lees hieronder de 📖 handleiding in het Nederlandse voor Cisco AIR-CAP702I-S-K9 (26 pagina's) in de categorie Access point. Deze handleiding was nuttig voor 15 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/26

G ETTING S GTARTED UIDE

Cisco Aironet 700 Series Access Points

First Published: June 2013

Last Updated: September 2014

1About this Guide

2Introduction to the Access Point

3Safety Instructions

4Unpacking

5Configurations

6Access Point Ports and Connectors

7Configuring the Access Point

8Mounting the Access Point

9Deploying the Access Point on the Wireless Network

10 Troubleshooting

11 Declarations of Conformity and Regulatory Information

12 Configuring DHCP Option 43 and DHCP Option 60

13 Access Point Specifications

1 About this Guide

This Guide provides instructions on how to install and configure your Cisco Aironet 700 Series Access Point. The 700 Series

Access Point is referred to as the 700 series or the access point in this document.

2 Introduction to the Access Point

The 700 series supports high-performing two spatial stream rates over a deployable distance with high reliability when serving

clients. The 700 series provides high reliability and overall wireless performance.

The 700 series offers dual-band radios (2.4 GHz and 5 GHz) with integrated internal antennas. The access point supports full

inter-operability with leading 802.11n clients.

The 700 series access point is available in the controller-based and autonomous configurations and supports:

•Simultaneous dual-band (2.4 GHz/5 GHz) radios

•Integrated antennas on 702I access point models (AIR-CAP702I-x-K9)

Note The ‘x’ in the model numbers represents the regulatory domain. Refer to “Regulatory Domains” section on page 4

for a list of supported regulatory domains.

The features of the 700 series are:

•Processing sub-systems for controller-based models (including CPUs and memory) and radio hardware which supports:

–

Unified

–

FlexConnect

–

Monitor-mode

Note Enhanced Local Mode (ELM) is not supported.

•The following processor features:

–

128 MB NAND flash size

–

1 MB NOR flash size

–

128 MB DDR2 memory bus, x32

•2.4 GHz and 5 GHz 802.11n radios with the following features:

–

802.11n standard compliant

–

A-MPDU TX

–

HT Duplicate Mode

–

2TX x 2RX

–

2-spatial streams, 300 Mbps PHY rate

–

Maximal ratio combining (MRC)

–

Cyclic Shift Diversity (CSD)

–

MCS0-MCS15; Short or Long Guard Intervals

–

DFS for UNII-2 and UNII-2 Extended channels, including 0.5us radar pulse detection

3 Safety Instructions

Translated versions of the following safety warnings are provided in the translated safety warnings document that is shipped

with your access point. The translated warnings are also in the Translated Safety Warnings for Cisco Aironet Access Points,

which is available on Cisco.com.

Warning

IMPORTANT SAFETY INSTRUCTIONS

This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any

equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for

preventing accidents. Use the statement number provided at the end of each warning to locate its translation in

the translated safety warnings that accompanied this device.

Statement 1071

SAVE THESE INSTRUCTIONS

Warning

Read the installation instructions before you connect the system to its power source.

Statement 1004

Warning

Installation of the equipment must comply with local and national electrical codes.

Statement 1074

Warning

This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that the

protective device is rated not greater than:

20A.

Statement 1005

Warning

Do not operate your wireless network device near unshielded blasting caps or in an explosive environment unless

the device has been modified to be especially qualified for such use.

Statement 245B

Warning

In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a minimum of 7.9

inches (20 cm) or more from the body of all persons.

Statement 332

Caution The fasteners you use to mount an access point on a ceiling must be capable of maintaining a minimum pullout

force of 20 lbs (9 kg) and must use all 4 holes on the mounting bracket.

Caution This product and all interconnected equipment must be installed indoors within the same building, including the

associated LAN connections as defined by Environment A of the IEEE 802.af Standard.

Note The access point is suitable for use in environmental air space in accordance with section 300.22.C of the National

Electrical Code and sections 2-128, 12-010(3), and 12-100 of the Canadian Electrical Code, Part 1, C22.1. You should

not install the power supply or power injector in air handling spaces.

Note Use only with listed ITE equipment.

Product specificaties

Merk:	Cisco
Categorie:	Access point
Model:	AIR-CAP702I-S-K9
Kleur van het product:	Wit
Gewicht:	480 g
Breedte:	177.6 mm
Diepte:	177.6 mm
Hoogte:	50.4 mm
LED-indicatoren:	Ja
Frequentieband:	2.4, 5 GHz
Aantal Ethernet LAN (RJ-45)-poorten:	1
Certificering:	UL, CAN/CSA, IEC, EN, FCC, RSS-210, ARIB-STD, AS/NZS, EMI, ICES-003, VCCI, SRRC
Aansluiting voor netstroomadapter:	Ja
Intern geheugen:	128 MB
Meegeleverde software:	Unified Wireless Network
Ethernet LAN, data-overdrachtsnelheden:	10,100,1000 Mbit/s
Netwerkstandaard:	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.11h, IEEE 802.11i, IEEE 802.11n, IEEE 802.1x, IEEE 802.3, IEEE 802.3ab, IEEE 802.3af, IEEE 802.3i
Ondersteunde beveiligingsalgoritmen:	802.1x RADIUS, AES, EAP, EAP-FAST, EAP-SIM, EAP-TLS, EAP-TTLS, MSCHAPv2, PEAP, TKIP, WPA, WPA2
Antennas quantity:	2
Antenne versterkingsniveau (max):	5 dBi
Aantal gebruikers:	- gebruiker(s)
Temperatuur bij opslag:	-30 - 70 °C
Intern:	Nee
Draadloos LAN data-overdrachtsnelheid (max):	300 Mbit/s
Web-gebaseerd management:	Nee
Flash memory:	128 MB
Hoogte, in bedrijf:	0 - 3000 m
Hoogte bij opslag:	0 - 4572 m
Maximale overdrachtssnelheid van gegevens:	300 Mbit/s
2,4 GHz:	Ja
5 GHz:	Ja
Power over Ethernet (PoE):	Ja
Antennefuncties:	Ingebouwde antenne
Aantal kanalen:	37 kanalen
Zendvermogen:	20 dBmW
AC-ingangsspanning:	100 - 240 V
AC-ingangsfrequentie:	50 - 60 Hz
Stroomverbruik (typisch):	9.5 W
Bedrijfstemperatuur (T-T):	0 - 40 °C
Relatieve vochtigheid in bedrijf (V-V):	10 - 90 procent