Celestron ExploraScope Handleiding

Celestron Niet gecategoriseerd ExploraScope

Lees hieronder de 📖 handleiding in het Nederlandse voor Celestron ExploraScope (40 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 35 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/40
INSTRUCTION MANUAL
EXPLORASCOPE 60AZ
Model #22100
EXPLORASCOPE 80AZ
Model #22102
EXPLORASCOPE 70AZ
Model #22101
EXPLORASCOPE 114AZ
Model #22103
ENGLISH
2 | ENGLISH
Lens Cap Lens Cap
Telescope Tube Telescope Tube
Star Pointer Finderscope Star Pointer Finderscope
20 mm Eyepiece
20 mm Eyepiece
Erect Image Diagonal
Tripod Tripod
Accesory Tray Accesory Tray
INCLUDED BUT NOT PICTURED.
(1) 4 mm Eyepiece
(1) 3x Barlow Lens
(1) Bonus Astronomy Software download
SOLAR WARNING
Never look directly at the Sun with the naked eye or with a telescope unless you have the proper solar filter. Permanent and irreversible eye damage may result.
Never use your telescope to project an image of the Sun onto any surface. Internal heat build-up can damage the telescope and any accessories attached to it.
Never use an eyepiece solar filter or a Herschel wedge. Internal heat build-up inside the telescope can cause these devices to crack or break, allowing unfiltered
sunlight to pass through to the eye.
Do not leave the telescope unsupervised, especially when children or adults unfamiliar with the correct operating procedures of your telescope are present.
We recommend saving your telescope box so it can be used to store the telescope when it is not in use. Unpack the
box carefully as some parts are small. Use the parts list below to verify that all parts and accessories are present.
PARTS LIST
WHAT’S IN THE BOX
EXPLORASCOPE 60AZ, 70AZ, and 80AZ EXPLORASCOPE 114AZ
ENGLISH | 3
ASSEMBLING YOUR TELESCOPE
Fig. 4
THE MOUNT
The ExploraScope mount and tripod come fully assembled, so setting it up is easy.
1. Remove the tripod and mount from the box.
2. Loosen the hand knobs at the bottom of each leg and extend the inner section of
the leg to the desired length. Tighten the knobs to secure the legs, being careful
not to over tighten.
3. Stand the tripod upright and pull the tripod legs apart until the center brace snaps
into place.
4. Place the threaded post on the bottom of the accessory tray over the hole in the
middle of the leg support bracket and turn the entire tray clockwise until the tray sits firmly against the leg brace (Fig. 1).
5. Make sure the leg hinge bolts are secure by snugging down the black thumbnuts at the top of each leg.
THE TELESCOPE TUBE
To attach the telescope tube to your tripod and mount:
1. Locate the slow motion rod guide on the side of the U-shaped mount.
Loosen the set screw in the guide until the hole through the guide is
unobstructed.
2. Holding the telescope tube above the mount, slide the slow motion
rod through the guide on the mount and gently lower the hinges
on the sides of the telescope tube into the cradles at the top of the
U-shaped mount (Fig. 2).
3. Tighten the set screw on the guide to hold the telescope
in place
4. Insert the two telescope tube mounting bolts through the tops of
the U-shaped mount and into the hinges on the sides of the telescope
tube. Do not over tighten (Fig. 3).
NOTE: The 70mm refractor is shown, but the 114 mm Newtonian attaches to the mount in the same exact way.
THE STAR DIAGONAL
(FOR 60 MM, 70 MM AND 80 MM REFRACTORS ONLY)
The star diagonal attaches to the back of a refracting telescope that contains a small mirror that reflects the light at a 90°
angle, providing a more comfortable viewing position. It also gives you a 100% correctly oriented image allowing you to
easily use this telescope for daytime terrestrial observing.
1. Remove the caps from both sides of the diagonal.
2. Loosen the setscrews on the back of the focuser and pull out
the small dust cap.
3. Insert the smaller tube on the diagonal into the back of the
focuser and secure it by tightening the setscrews (Fig. 4).
You can rotate the diagonal to any position by loosening the setscrews.
Fig. 3
Fig. 2
Fig. 1

Product specificaties

Merk: Celestron
Categorie: Niet gecategoriseerd
Model: ExploraScope

Heb je hulp nodig?

Als je hulp nodig hebt met Celestron ExploraScope stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd Celestron

Celestron

Celestron Smart DewHeater and Controller 2x Handleiding

30 Juli 2024
Celestron

Celestron Thermistor 94037 Handleiding

30 Juli 2024
Celestron

Celestron StarPointer Finderscope Handleiding

23 Juni 2024
Celestron

Celestron OMNI AZ 102 Handleiding

5 Juli 2023
Celestron

Celestron StarSense Explorer 10 Handleiding

2 Juli 2023
Celestron

Celestron PowerTank 18763 Handleiding

17 Juni 2023
Celestron

Celestron EclipSmart Handleiding

15 Juni 2023
Celestron

Celestron PowerSeeker Handleiding

25 Mei 2023
Celestron

Celestron CGX Equatorial 1100 HD Handleiding

23 Mei 2023
Celestron

Celestron Popular Sience Travel Scope 70 Handleiding

30 April 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Protector

Protector AS-5030.3 V2 Handleiding

21 December 2024
Sabrent

Sabrent AU-MMCW Handleiding

21 December 2024
Sabrent

Sabrent AU-2X35 Handleiding

21 December 2024
Sabrent

Sabrent CB-RS232 Handleiding

21 December 2024
Owon

Owon 500W Handleiding

21 December 2024
Owon

Owon 300W Handleiding

21 December 2024
Sabrent

Sabrent SB-RKTQ4-1TB Handleiding

21 December 2024
Sabrent

Sabrent SB-RKTQ-1TB Handleiding

21 December 2024
Sabrent

Sabrent SB-ROCKET-1TB Handleiding

21 December 2024
Sabrent

Sabrent SB-HTSS Handleiding

21 December 2024