Baumr-AG HTP300 Handleiding
Baumr-AG
Heggenschaar
HTP300
Lees hieronder de 📖 handleiding in het Nederlandse voor Baumr-AG HTP300 (19 pagina's) in de categorie Heggenschaar. Deze handleiding was nuttig voor 115 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/19
User Manual
[Revision 2023 April .0 1]
READ THIS MANUAL CAREFULLY BEFORE USE FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY DAMAGE AND –
MAY VOID WARRANTY. • . • Products covered by this manual may vary in KEEP THIS MANUAL FOR FUTURE REFERENCE
appearance, assembly, inclusions, specifications, description, and packaging.
HTP300 Hedge Trimmer
E&OE © Bäumr-AG 2 2021
Safety
Safety messages are designed to alert you to possible dangers or hazards that could cause death, injury or
equipment or property damage if not understood or followed. Safety messages have the following symbols:
You WILL be KILLED or
SERIOUSLY INJURED if you do
not follow instructions.
You CAN be KILLED or
SERIOUSLY INJURED if you do
not follow instructions.
You CAN be INJURED if you do
not follow instructions or
equipment damage may occur.
It is important that you read and
understand the instruction manual before
use and keep the manual in a safe place
for future reference. Safety information
presented here is generic in nature – some
advice may not be applicable to every
piece of equipment.
All safety precautions must be observed to
reduce the risk of personal injury when
operating the equipment.
The term “equipment" refers to your
product, be it electrical mains, battery or
petrol engine powered.
IMPORTANT – Handle the equipment
safely and carefully.
BEFORE USE - If you are not familiar with
the safe operation/handling of this
equipment, or are in any way unsure of any
aspect of suitability or correct use for it
your application, you should complete
training conducted by a person or
organization qualified in safe use and
operation of this equipment, including
fuel/electrical handling and safety.
WARNINGS
• Read all safety warnings and all
instructions. Failure to follow warnings
and instructions may result in electric
shock, fire and/or serious injury.
• Never run a petrol engine in confined
areas.
• Do not operate the equipment in
flammable or explosive environments,
such as in the presence of flammable
liquids, gases or dust. Engine and
equipment may create sparks or heat
that may ignite vapours, dust etc
• Keep clear of moving parts.
• This equipment may be a potential
source of electric shock if misused.
• Do not operate the equipment if it is
damaged, malfunctioning or is in an
excessively worn state.
• Do not allow others to use the
equipment unless they have read this
manual and are adequately trained.
• When using the equipment, basic
safety precautions detailed here must
always be followed to reduce the risk
of fire, electric shock, personal injury
and material damage.
• When wiring electrically powered
equipment, follow all electrical and
safety codes.
• Ensure power sources conform to all
equipment voltage requirements and
are disconnected before connecting
equipment.
General Work Area Safety
Work areas should be clean and well it.
Do not operate the equipment if
bystanders, animals etc are within
operating range of the equipment or the
general work area.
Personal Safety
Keep packaging away from children - risk
of suffocation! Operators must use the
equipment correctly. When using the
equipment, consider conditions and pay
due care to persons and property.
Prevent unintentional starting of the
equipment - ensure equipment and power
source switches are in the OFF position
before connecting or moving the
equipment. Do not carry equipment with
hands/fingers touching any controls.
Remove any tools or other items that are
not a part of the equipment from it before
starting or switching on.
Stay alert and use common sense when
operating equipment. Do not overreach.
Keep proper footing and balance at all
times. Do not use equipment when tired or
under the influence of drugs, alcohol or
medication. This equipment is not intended
for use by persons with reduced physical,
sensory or mental capabilities.
You must wear appropriate protective
equipment when operating, servicing, or
when in the operating area of the
equipment to help protect from serious
injury, including eye injury, inhalation of
toxic fumes, burns, and hearing loss.
Always wear eye protection. Protective
equipment such as respirators, non-skid
safety shoes, hard hat, hearing protection
etc should be used for appropriate
conditions. Other people nearby should
also wear appropriate personal protective
equipment. Do not wear loose clothing or
jewellery, which can be caught in moving
parts. Keep hair and clothing away from
the equipment.
If devices are provided for the connection
of dust extraction and collection facilities,
ensure these are connected and properly
used. Use of dust collection can reduce
dust-related hazards.
General Use and Care
Do not force the equipment. Use the
correct equipment for your application. The
correct equipment will perform better and
be safer within its design parameters. Do
not use the equipment if the ON/OFF
switch malfunctions – any equipment that
cannot be controlled with the ON/OFF
switch is dangerous and must be repaired.
Use the equipment and accessories etc. in
accordance with these instructions, taking
into account working conditions and the
work to be performed. Using the equipment
for operations different from those intended
could result in hazardous situations.
Before use, inspect the equipment for
misalignment or binding of moving parts,
loose components, damage or any other
condition that may affect its operation. If
damaged, have the equipment repaired by
an authorized service centre or technician
before use.
Always keep the equipment and
accessories (cutting tools, nozzles, bits
etc) properly maintained. Keep the
equipment, controls and handles dry and
free from dirt, oil and grease.
Store the equipment out of reach of
children or untrained persons. To avoid
burns or fire hazards, let the equipment
cool completely before transporting or
storing. Never place the equipment in
places where there are flammable
materials, combustible gases or
combustible liquids etc.
The equipment is not weatherproof, and
should not be stored in direct sunlight, at
high ambient temperatures or locations
that are damp or very humid.
Hedge Trimmer Use and Care
WARNINGS
• Before use, ensure that there are no
electrical cables or unseen hazards in
the work area.
• Do not use the machine if the cutting
blades are damaged or blunt.
• Always hold the machine firmly using
both hands and machine handles.
• Do not attempt to cut through material
that is over 10mm (3/8") diameter or too
tough for the machine / cutting blades.
• Clean and lubricate the cutting blades
after every use.
• Ensure that the machine bolts are tight
before each use. If any cracks, leaks or
other damage is present, have the
machine inspected and serviced by a
qualified technician.
• Lift, carry or move the machine only
while the engine turned off or is idling
(slowest running speed). If idling,
always allow the machine to slow down
completely before lifting or moving it.
HTP300 Hedge Trimmer
E&OE © Bäumr-AG 3 2021
General Fuel Safety
Petrol/fuel/gasoline is extremely
flammable – keep clear of
naked flames or other ignition
sources.
• Do not spill fuel. If you spill fuel, wipe it
from equipment immediately – if fuel
gets on your clothing, change them
immediately
• Do not smoke near fuel.
• Always shut off the engine before
refuelling.
• Do not refuel a hot engine.
• Open the fuel cap carefully to allow
any pressure build-up in the tank to
release slowly.
• Always refuel in well ventilated areas.
• Always check for fuel leakage. If fuel
leakage is found, do not start or run the
engine until all leaks are fixed.
General Service Information
• Have the equipment serviced or
repaired at authorized service centres
by qualified personnel only.
• Replacement parts must be original
equipment manufacturer (OEM) to help
ensure that equipment safety is
maintained.
• Do not attempt any maintenance or
repair work not described in this
instruction manual.
• After use, the equipment and
components may still be hot – allow the
equipment to cool and disconnect
spark plugs and/or electrical power
sources and/or batteries from it before
making adjustments, changing
accessories or performing repair or
maintenance.
• Do not make adjustments while the
equipment is running.
• Perform all service related activities
under suitable conditions, such as a
workshop etc.
• Replace any worn, damaged or
missing warning labels immediately.
• Do not clean equipment with solvents,
flammable liquids or harsh abrasi ves.
DANGER
Running combustion engines in confined
areas CAN KILL IN MINUTES. Engine
exhaust fumes contain carbon-monoxide –
a deadly gas that you cannot smell or see.
NEVER run a combustion engine in
confined areas EVEN IF windows and
doors are open. ONLY run petrol engines
OUTDOORS and away from doors,
windows and vents.
Do not operate the equipment in hazardous locations, such
as where there may be a risk of fire or explosions from
flammable liquids, gases or dust.
Do not operate the equipment in confined areas where
exhaust gases, smoke or fumes could reach dangerous
concentrations.
Do not refuel a combustion engine while it is running, on or
hot.
Never smoke while refuelling combustion engines or
handling flammable substances.
For generators, the electrical output is potentially lethal and
must only be connected to a fixed electrical installation by
an appropriately licensed person.
Be aware that the equipment may include hazardous
components, such as blades, hot surfaces and moving
parts.
Handle any flammable substance with extreme caution.
•
•
•
•• Be aware that the equipment may include hazardous components, such as blades, hot surfaces
and moving parts.
•
•
•
•• Moving blades can cause serious injury and even death if used improperly or without sufficient
PPE.
•
•
•
•• Do not use this equipment on uneven surfaces and always maintain good balance when using
this equipment. Failure to do so may cause serious injury.
•
•
•
•• Maintain a secure grip of the trigger assembly at all times.
Product specificaties
| Merk: | Baumr-AG |
| Categorie: | Heggenschaar |
| Model: | HTP300 |
Heb je hulp nodig?
Als je hulp nodig hebt met Baumr-AG HTP300 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Heggenschaar Baumr-AG
25 April 2023
9 April 2023
4 Maart 2023
2 Februari 2023
7 Oktober 2022
Handleiding Heggenschaar
- Heggenschaar Bosch
- Heggenschaar DeWalt
- Heggenschaar Karcher
- Heggenschaar WOLF-Garten
- Heggenschaar Al-ko
- Heggenschaar Atika
- Heggenschaar Batavia
- Heggenschaar Bavaria
- Heggenschaar Black Decker
- Heggenschaar Brandson
- Heggenschaar Budget
- Heggenschaar Dolmar
- Heggenschaar Echo
- Heggenschaar Efco
- Heggenschaar Einhell
- Heggenschaar Eurogarden
- Heggenschaar Ferm
- Heggenschaar Ferrex
- Heggenschaar Florabest
- Heggenschaar Flymo
- Heggenschaar Fuxtec
- Heggenschaar Gamma
- Heggenschaar Garden Feelings
- Heggenschaar Garden Groom
- Heggenschaar Gardena
- Heggenschaar Gardenline
- Heggenschaar Gartenmeister
- Heggenschaar Greenworks
- Heggenschaar Grizzly
- Heggenschaar Gude
- Heggenschaar Hanseatic
- Heggenschaar Hikoki
- Heggenschaar Hitachi
- Heggenschaar Hoberg
- Heggenschaar Homelite
- Heggenschaar Honda
- Heggenschaar Husqvarna
- Heggenschaar Hyundai
- Heggenschaar Kaaz
- Heggenschaar Kibani
- Heggenschaar Kingcraft
- Heggenschaar Kress
- Heggenschaar Levita
- Heggenschaar Lux Tools
- Heggenschaar Makita
- Heggenschaar McCulloch
- Heggenschaar Metabo
- Heggenschaar Milwaukee
- Heggenschaar Mr Gardener
- Heggenschaar Parkside
- Heggenschaar Pattfield
- Heggenschaar Powerpeak
- Heggenschaar Powerplus
- Heggenschaar Remington
- Heggenschaar Robust
- Heggenschaar Ryobi
- Heggenschaar Scheppach
- Heggenschaar Shindaiwa
- Heggenschaar Skil
- Heggenschaar Sterwins
- Heggenschaar Stiga
- Heggenschaar Stihl
- Heggenschaar Tanaka
- Heggenschaar Tel Sell
- Heggenschaar Texas
- Heggenschaar Toledo
- Heggenschaar Topcraft
- Heggenschaar Trotec
- Heggenschaar Varo
- Heggenschaar Vonroc
- Heggenschaar Worx
- Heggenschaar Yardforce
- Heggenschaar Zipper
- Heggenschaar Ozito
- Heggenschaar Black And Decker
- Heggenschaar Cocraft
- Heggenschaar Meec Tools
- Heggenschaar Cotech
- Heggenschaar Fieldmann
- Heggenschaar McGregor
- Heggenschaar Sun Joe
- Heggenschaar Challenge
- Heggenschaar Cramer
- Heggenschaar EGO
- Heggenschaar Grouw
- Heggenschaar Gtech
- Heggenschaar Hurricane
- Heggenschaar MacAllister
- Heggenschaar Maruyama
- Heggenschaar Sovereign
- Heggenschaar Spear & Jackson
- Heggenschaar CMI
- Heggenschaar Powerworks
- Heggenschaar Craftsman
- Heggenschaar Verto
- Heggenschaar G-Technology
- Heggenschaar Jonsered
- Heggenschaar Qualcast
- Heggenschaar Bestgreen
- Heggenschaar Martha Stewart
- Heggenschaar Mac Allister
- Heggenschaar Deltafox
- Heggenschaar Anova
- Heggenschaar Palmera
- Heggenschaar Proviel
- Heggenschaar LawnMaster
- Heggenschaar Ergotools Pattfield
- Heggenschaar Maxbear
- Heggenschaar Yellow Garden Line
Nieuwste handleidingen voor Heggenschaar
19 November 2024
19 November 2024
19 November 2024
19 November 2024
17 November 2024
16 November 2024
16 November 2024
16 November 2024
16 November 2024
16 November 2024