Atdec Ultra-Slim Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Atdec Ultra-Slim (12 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 59 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
ADM-VWPS Page 1 of 12This pack contains 1 mount. Please retain this document for future reference.
REQUIRED TOOLS FOR INSTALLATION
CONTENTS
Installation Safety Notes Page 2
Interface Adaptors Page 3
Installation Instructions Page 4
Installation Options Page 9
Alternative Mounting Examples Page 10
Product Dimensions Page 11
Flathead &
Crosshead
Screwdrivers
A
Wall Mount
I
M6 x
16mm
Screw
M
M8 x
16mm
Screw
J
M6 x
25mm
Screw
N
M8 x
25mm
Screw
K
M6 x
40mm
Screw
O
M8 x
40mm
Screw
L
M6
Washer
B
Interface
Arm - Left
C
Interface
Arm - Right
D
600mm
Adaptor Arm
E
M6 x 20mm
Screw
F
M8 x 12mm
Countersunk
Screw (x4)
G
4mm Short
Allen Key
H
4mm Long
Allen Key
PencilPower
Drill
Dual-Plane
Laser Level:
Optional
Drill
Bit
Suitable for loads up to 50kg
IMPORTANT INFORMATION
! Important: Fixing screws are not included with this product.
Atdec highly recommends this product be installed by a suitably
qualified person. The installer must be satisfied that the type of
fixings used are suitable for the type of wall the product is to be
mounted to. Care must be taken as to where this product is located
as some walls are not suitable for installation. When drilling holes
knowledge must be obtained to avoid contact with any electrical
cables and/or gas and water pipes contained within the wall.
COMPONENT CHECKLIST
Display Interface
P
M8 x
5mm
Spacer
Q
M8 x
13mm
Spacer
R
M8 x
24mm
Spacer
Installation Guide
ADM-VWPS
Pop-Out Slim
Video Wall Mount
ADM-VWPS Page 2 of 12
INSTALLATION SAFETY INSTRUCTIONS
CAUTION: THIS MOUNT IS INTENDED FOR USE ONLY
WITH THE MAXIMUM WEIGHTS INDICATED. USE WITH
DISPLAYS HEAVIER THAN THE MAXIMUM INDICATED MAY
RESULT IN INSTABILITY CAUSING POSSIBLE INJURY.
Do not attempt to install this product until all
instructions and warnings have been read and
properly understood.
Please keep these instructions for future reference.
Please check carefully to make sure there are no
missing or defective parts - defective parts must
never be used.
Atdec Pty Ltd, its distributors and dealers are not
liable or responsible for damage or injury caused
by improper installation, improper use or failure to
observe these safety instructions.
In such cases, all guarantees will expire.
GENERAL
Atdec Pty Ltd recommends that a professional AV
installer or other suitably qualified person install this
product. Great care must always be taken during
installation as most AV equipment is of a fragile
nature, possibly heavy and easily damaged if dropped.
If you do not fully understand the instructions or are
not sure how to install this product safely, then please
consult a professional for advice and/or to install
this product for you. Failure to mount this product
correctly may cause serious injury or death both
during installation and at any time thereafter.
Do not mount any AV equipment that exceeds the
specific weight limit of the product you are installing.
This weight limit will be clearly stated on each
product and its packaging and will vary from product
to product.
PRODUCT LOCATION
Please pay careful attention to where this product
is located. Check load capacity of wall prior to
installation as some walls are not suitable for
installation. Designed for indoor use, this mount is
suitable for public or home installation. If located in
a public or frequently populated area ensure that the
product is out of the immediate reach of people. If
any AV equipment is to be suspended over the likely
path or location of people then great care should
be taken to secure all parts of
the installation from
falling. If you install this product on drywall it must
be securely fixed to a wooden stud, concrete block or
other permanent structure behind the drywall board.
Installing on drywall boards alone will not support
the weight of most AV equipment.
When drilling holes in walls it is essential to avoid
contact with electrical cables and water or gas
pipes contained within. Use of a good quality live
wire detector and hidden object locator is therefore
recommended.
Only drill into structures when you are sure it is safe
to do so.
FIXING HARDWARE
It is highly recommended that all wall fixing screws
be used where supplied and that the purpose of all
other fixing hardware is fully understood. In some
cases more AV equipment fixing hardware will
be supplied to accommodate different models of
equipment and set up configurations.
The installer must be satisfied that any supplied fixing
hardware is suitable for each specific installation. If
any fixing screws or included hardware are deemed
not sufficient for a safe installation then please
consult a professional or your local hardware store.
HAZARD LIMITATION
When routing cables take advantage of any built
in cable management features that the product
might provide and ensure that all cables are tidy
and secure. Check to see that any moving aspect of
product can do so unhindered by any cabling.
Some products have moving parts and the potential
to cause injury through the crushing or trapping of
fingers or other body parts.
Particular attention to the nature of moving parts is
required especially when assembling, installing and
adjusting during set up.
Immediately after installations double-check that
the work done is safe and secure. Double-check
all necessary fixings are present and are of ample
tightness.
It is recommended that periodic inspections of the
product and its fixing points are made as frequently
as possible to ensure that safety is maintained. If in
doubt consult a professional AV installer or other
suitably qualified person.
ADM-VWPS Page 3 of 12
VESA 600 X 400MM INTERFACE ADAPTORS
Mounting In Landscape
Mounting In Portrait
The interface arms (parts B & C)
can mount displays with fixing patterns
from VESA 200 x 200mm up to
400 x 400mm.
Display
Bottom
Top
C
D
B
F
D
Bottom
Top
Display
B
F
D
D
CIJKMNO
i.)
i.)
ii.)
ii.)
To mount displays with VESA 600 x 400mm
fixings use the adaptor arms (part D).


Product specificaties

Merk: Atdec
Categorie: Niet gecategoriseerd
Model: Ultra-Slim

Heb je hulp nodig?

Als je hulp nodig hebt met Atdec Ultra-Slim stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Atdec

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd