Atdec AW-FB Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Atdec AW-FB (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 3 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
Ora Bolt Through Fixing
Installation Guide
AW-FB
COMPONENT CHECKLIST
Clamp Plate (x1)
Clamp Bar (x1)
Arm Spigot (x1)
M8 Stud Bolt (x1)
M8 Flange Nut (x1)
No portion of this document or any artwork contained herein should be
reproduced in any way without the express written consent of Atdec Pty
Ltd. Due to continuing product development, the manufacturer reserves
the right to alter specifications without notice. ©20231006
WARRANTY
10 Years Limited
TOOLS REQUIRED
4mm Hex Key (supplied with Ora arm)
8.5mm (or 11/32”) drill bit
Power Drill
13mm Spanner
Phillips head screwdriver
CAPACITY
2 - 8kg (4.4 - 17.6lb)
Up to 35” (curved or flat)
(Larger monitors within the weight
capacity may be compatible, please
contact Atdec for advice).
Weight:
Display Size:
IMPORTANT INFORMATION
Install Ora Accessories as per these installation
instructions.
The manufacturer accepts no responsibility for
incorrect installation.
The product is compatible with grommet hole sizes
up to 80mm (3.15”)
The product is compatible with desk thicknesses
from 0-55mm (0-2.2”).
Do not over-tighten screws and adjustment points
on product.
This product is not suitable for outdoor use.
Do not use this product for mobile applications.
Please ensure desk structure and mounting surface
are of sufficient strength to support this product and
mounted equipment.
1 For bolt through installations,
drill hole in the work surface
Drill the hole using a suitable drill bit. Ensure the
hole is drilled perpendicular to the work surface
and the edges of the clamp are positioned fully
on the desk.
1.2
Mark out hole
position on the
work surface.
Use Clamp Plate
as a template.
1.1
USER
40mm (1 ”)
minimum
8.5 mm ( ”)1⅓2
Desk
Thickness
18 - 40mm
(¾ ½ - 1 ”)
TIP
When positioning the desk clamp, offset the
clamp to the left or right of the seating position.
The monitor will then be centred for the user.
100mm
(4”)
2 Attach Arm Spigot to
Clamp Plate
Hold Arm Spigot and Clamp
Plate together, locating the
dimple in the slot, before
hand tightening the screw
into the spigot.
HINT!
Screw M8 Stud Bolt through Clamp Plate into
Arm Spigot.
Tighten firmly with 4mm
Hex Key supplied with Arm.
2.2
3 Attach plate assembly to desk
TIP
Support plate while tightening to maintain the
correct orientation on the work surface.
Place Clamp Bar over M8 Stud Bolt under the desk
as illustrated and secure Flange Nut with spanner.


Product specificaties

Merk: Atdec
Categorie: Niet gecategoriseerd
Model: AW-FB

Heb je hulp nodig?

Als je hulp nodig hebt met Atdec AW-FB stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Atdec

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd