Astralpool NanoFiber Handleiding


Lees hieronder de šŸ“– handleiding in het Nederlandse voor Astralpool NanoFiber (56 pagina's) in de categorie Waterfilter. Deze handleiding was nuttig voor 50 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/56
NanoFiber Filter Auto
Filtre NanoFiber Auto
Filtro NanoFiber Auto
Filtro NanoFiber Auto
NanoFiber-Filter Auto
Filtro NanoFiber Auto
INSTALLATION AND MAINTENANCE MANUAL
MANUEL Dā€™INSTALLATION ET Dā€™ENTRETIEN
MANUAL DE INSTALACIƓN Y MANTENIMIENTO
MANUALE DI INSTALAZIONE E MANUTENZIONE
EINBAU-UND BETRIEBSANLEITUNG
MANUAL DE INSTRUƇƕES E MANUTENƇƃO
67355 67356 67357
67509
2
To achieve optimum performance of the Nanoļ¬ber Filter Auto follow the instructions provided below:
General safety prescriptions:
These symbols indicate the possibility of danger as the consequence of not respecting
the corresponding prescriptions.
DANGER. Risk of electrocution. The lack of warning of this prescription involves a risk of
electrocution.
DANGER. The lack of warning of this prescription involves a risk of personal injury or material
damages.
WARNING. The lack of warning of this prescription involves a risk of damage to the ļ¬lter or the
installation.
GENERAL SAFETY REGULATIONS.
The ļ¬lter described in this manual has been specially designed to provide
correct water ļ¬ltration in the swimming pool.
It has been designed to work with clean water at temperatures not exceeding
35ĀŗC.
The installation must be carried out in accordance with the speciļ¬ c instruc-
tions for each particular implementation.
Current in-force regulations for the prevention of accidents must be observed.
Any modiļ¬ cation to the ļ¬lterā€™s electronic module requires the prior authori-
sation from the manufacturer. Original spare parts and accessories authori-
sed by the manufacturer will guarantee greater safety. The manufacturer of
this ļ¬lter is exempt from all responsibility for any damage caused by non-
authorised spare parts or accessories.
During operation, the ļ¬lterā€™s electric and electronic parts have electric power
connected to them.
Any work to the ļ¬lter and any equipment connected to it, must only be ca-
rried out when the start-up devices have been disconnected.
The user must ensure that installation and maintenance work is carried out
by adequately qualiļ¬ ed and authorised personnel, and these have previously
carefully read the installation and service instructions.
Filter operational safety is only guaranteed by full compliance and respect of
the installation and service instructions.
The appliance is not to be used by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction. Children being super-
vised not to play with the appliance.
ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures
to be implemented for installation and start-up. Therefore, the installer as well as the user must read the
instructions before beginning installation and start-up. Keep this manual for future reference.
3
ADVICE DURING INSTALLATION AND ASSEMBLY OPERATIONS.
During the connection operations of the electrical wiring to the ļ¬lter modules, great attention must be
given to polarity, and it must be veriļ¬ ed that pieces of wiring are not left inside after closing.
Make all connections by following the instructions in this manual.
It should be veriļ¬ed that the electrical wiring connections to the electronic card are ļ¬ rmly made.
The seal on the moduleā€™s box should be checked for correct positioning to prevent the entry of water, it
should also be checked that the compression gland is also correctly located.
Particular attention should be paid, so that, under no circumstances, is it possible for water to enter
the electronic module. In the case where the intended use is not that for which the valve was designed,
adaptation and supplementary technical regulations may be necessary.
ADVICE FOR WHEN PUTTING INTO SERVICE.
Before putting the into service, it is necessary to verify the calibration of the electrical protection ļ¬lter
devices in the operations cabinet and that they are correctly positioned and ļ¬ xed in place.
The maximum voltage values must never be exceeded under any circumstances.
In the case of incorrect operation or a fault, please contact the closest manufacturerā€™s representative
or technical assistance service.
NOTE: It is recommended that the bathing facilities are not used while the ļ¬ ltration
equipment is in operation.
ADVICE DURING INSTALLATION AND MAINTENANCE WORK.
National installation regulations must be taken into account when assembling and installing the ļ¬lter.
Extra care must be taken so that it is not possible, under any circumstances, for water to enter the ļ¬lter
electronic circuit.
All contact, including accidental, must be avoided at all times with the moving parts in the during ļ¬lter
operation and/or before complete shutdown.
Before carrying out any maintenance or any other electrical or electronic work, it must be ensured that
switch-on devices are locked.
It is recommended that the following steps be taken before performing any maintenance on the ļ¬lter:
1- Remove electrical power to the ļ¬lter.
2- Lock the switch-on devices.
3- Verify that there is no electrical power being applied to the circuits, including auxiliary and
supplementary services.
This list must be considered indicative and not binding with respect to safety, there may
be other speciļ¬ c safety standards in particular regulations.
IMPORTANT: due to the complexity of the situations covered, the instructions for installation, use
and maintenance contained in this manual, do not make any attempt to cover all possible service and
maintenance cases. If additional instructions are necessary or speciļ¬ c problems arise, please do not
hesitate in contacting the distributor or the ļ¬lter manufacturer directly.
Our ļ¬lters may only be installed in swimming or other pools which fully comply with the HD 384.7.702
standard. When any doubt exists a specialist should be consulted.
1. CONTENT OF 67355-67356-67357:
Inside the box, you will ļ¬nd:
- Nanoļ¬ber ļ¬lter
- Nanoļ¬ber ļ¬lter cartridge (inside the ļ¬lter)
- Bag of components:
Pressure gauge
Connections
Additional cable gland
Operating Instructions
2. CONTENT OF 67509 KIT:
If you have purchased the 67509 KIT you must
begin the installation in step nĀŗ7. Inside the box,
you will ļ¬nd:
- Cover assembly
- Bag of components:
Pressure gauge
Additional cable gland
Operating Instructions


Product specificaties

Merk: Astralpool
Categorie: Waterfilter
Model: NanoFiber

Heb je hulp nodig?

Als je hulp nodig hebt met Astralpool NanoFiber stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Waterfilter Astralpool

Handleiding Waterfilter

Nieuwste handleidingen voor Waterfilter

JANDY

JANDY CS250 Handleiding

18 December 2024
JANDY

JANDY CS150 Handleiding

18 December 2024
JANDY

JANDY CS100 Handleiding

18 December 2024
Heissner

Heissner HLF6000 Handleiding

16 December 2024
Haier

Haier HRO4H85-3 Handleiding

10 December 2024
Haier

Haier HRO6H85-3 Handleiding

10 December 2024
Haier

Haier HBWS-S15 Handleiding

10 December 2024
Haier

Haier HBCF-S3002 Handleiding

10 December 2024
Haier

Haier HBP-V40 Handleiding

10 December 2024