Andrews Double Cool Handleiding

Andrews Airconditioner Double Cool

Lees hieronder de 📖 handleiding in het Nederlandse voor Andrews Double Cool (3 pagina's) in de categorie Airconditioner. Deze handleiding was nuttig voor 40 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/3
Click www.andrews-sykes.com
or Call Us Free 0800 211 611
Double Cool
Portable Air Conditioning
Operating Instructions
& Safety Guide
Do not lay electrical cables in wet / damp areas.
Do not move equipment whilst operating.
Do not pull equipment by its cable.
Cleaning and Maintenance
The Andrews Sykes range of evaporative air conditioners are designed to give
many years of trouble free operation. It is however important that the simple
regular maintenance described in this section is carried out.
Note: Isolate the unit from the power supply before carrying out any form of
maintenance.
At the end of each week
Clean side and back cooling pads and removed dust particles wit a vacuum
cleaner. Clean the outside body with a damp cloth.
At the end of each month
Place a sterilising tablet or a capful of sterilising liquid into a full reservoir and
operate the pump to circulate the sterilised water through the whole system. Drain
the water tank and clean any build up with a dam cloth. To gain access to the
water tank you will need to remove on or more panels.
At the end of summer season
Before storing the unit, drain the water tank and wipe down with a sterilising agent.
Remove the cooling pads and wash using a gentle spray. Then allow them to
completely dry before replacing.
General Safety
Keep children and animals away from air conditioning units. Never leave them
alone in a room where the units in use.
This equipment should only be used by a competent person who has read
and understood these instructions.
Never operate this equipment if you are ill, feeling tired or under the influence
of alcohol or drugs.
Keep the Air Conditioning vents clear of all obstructions.
Never put anything on top of the unit or block the air outlets.
Make sure equipment is switched off and unplugged after use. Never leave
switched on or unattended.
Located unit as to protect against accidental or malicious damage
Check condition of equipment before use. If unit is showing signs of damage
contact your supplier immediately.
Electrical Safety
Requires a standard earthed power supply 230v. An extension cable (a
minimum of 1.5mm three core earthed lead) may be used.
Extension leads must be fully uncoiled when being used.
Extension leads must be protected from any possibility or interference or
damage.
Andrews Sykes recommends the use of a power supply that is protected by
an RCD ( residual current operated device). This provides extra safety. Always
inspect the power supply cable and plug for damage before use.
Damaged plugs and powers supply cables must only be replaced by and
authorised repair agent.
Andrews evaporative air conditions are fitted with thermal cutouts which stop
the unit if a pump or fan motor overheats. The cut-out automatically resets
once the motor has cooled.
This unit requires a 230 volt electrical supply. It plugs into a standard BS1363
domestic socket.
Always inspect plugs and leads for damage before plugging into the supply -
DO NOT USE IF ANY DAMAGE IS FOUND
Ensure cables are run as not to cause a hazard.
If an extension lead is used, ensure it is of the correct standard , and fully
uncoiled when being used.
Operating Instructions - Double Cool
Click www.andrews-sykes.com 0800 211 611or Call Us Free
Care of your Double Cool Dx
Do not add any chemicals, bleaches or agents to the water tank other than
sterilising tablets.
Do not place anything on top of the unit and don’t obstruct the air vents.
Do not remove the repositions the unit with water in the tank.
Do not remove any access panels when the unit is switched ON.
Always operate, transport and store the Double Cool Dx in an upright position.
Always inspect the unit before and use at regular intervals. If the unit is
damaged, do not use it. Have all necessary repairs carried out by an
authorised repair agent.
When not in use, store the unit with all controls set to OFF and with the water
thank fully drained, cleaned and sterilised
Setting up your Double Cool Dx
The DOUBLE COOL Dx model is designed to be placed on the base trolley
supplied and must be kept level to prevent over spill from the water tank. Place the
DOUBLE COOL Dx squarely onto the base trolley. Please note that the trolley is not
attached to the unit
To cool a room efficiently the DOUBLE COOL Dx requires a continuous supply of
fresh air and therefore should be positioned close to an open window or door to the
outside. It is also important to have another window or a door open for the warm
air to exit. Once positioned in the room, lock the casters to prevent the unit from
moving. Decide upon which method is best suited for filling the water tank.
There are two options, either direct filling by connections to a main water supply or
by manual filling via the manual water fill inlet.
Direct Filling
Attach a suitable hose to the auto fill water inlet connector using a worm drive clip.
Double check for sign of water leakage from the connection before connecting the
unit to the power supply. If in doubt, consult a qualified plumber.
There is a float valve inside the water tank, which controls the water flow as
necessary.
Manual Filling
CAUTION. Always switch OFF the unit and unplug from the power supply before
manually filling this machine. Mop up all the spillages before switching ON again.
Never handle plugs and electrical switches with wet hands.
To fill the water tank, open the manual water fill inlet and our up to 45 liters of fresh
clean water into the the tank.
The level of water in the tank is displayed on the water level indicator. During use,
the water level should be checked on a regular basis and topped up as necessary.
Never overfill this machine. DOUBLE COOL Dx is now ready to use.
Controls
With the unit in position and the water tank either filled manually or connected
to a main water supply, plug the unit into a suitable power supply and switch
the supply ON.
The unit can be operated as a cooler or simply as a fan.
To operate as a fan, full raise the water flow lever then turn the ON/OFF/FAN
switch to the required fan speed setting.
There are three fan speeds available Low, Medium or High. When first
switching ON, select Low and wait for the fan to reach normal running speed.
There are two controls for the direction of airflow.
The air ow up/ down control lever is a manual control which directs the air
flow vertically.
The air deflector control is a powered deflectors, which oscillates Horizontally
(side to side). When switched ON the deflectors move from left to right in a
sweeping motion, distributing air to a wider area.
If the air flow is required in one direction only, switch the vertical louver swing
control to ON and when the air ow is the right direction, switch the vertical
louver swing control OFF.
To run the unit in cool mode, operated the unit as described above and then
depres the water flow lever.
When switching the unit OFF, full press down the water flow lever and allow
the fan to run for approximately 10 minutes.
This enables the cooling pads to dry and will help eliminate the possibility of a
musty odor from the unit when next used.
1. Water flow knob (Cool Knob)
2. Air flow up / down control knob
3. Ar outlet grill
4. Power supply cable
5. ON/OFF and Fan speed control
6. Vertical Louver swing control
7. Auto fill water inlet (Float valve)
8. Water level indicator
9. Manual water fill inlet
10. Stand
11. Water tank reservoir
12. Drain plug
13. Holder pad
14. Power Indicator


Product specificaties

Merk: Andrews
Categorie: Airconditioner
Model: Double Cool

Heb je hulp nodig?

Als je hulp nodig hebt met Andrews Double Cool stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Airconditioner Andrews

Handleiding Airconditioner

Nieuwste handleidingen voor Airconditioner