Ampeg SVT-2PRO Handleiding

Ampeg Receiver SVT-2PRO

Lees hieronder de 📖 handleiding in het Nederlandse voor Ampeg SVT-2PRO (8 pagina's) in de categorie Receiver. Deze handleiding was nuttig voor 53 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/8

Owners Guide for the

Ampeg ® is Proudly Made in America

Bass Amplifier

-15dB PAD

MUTE PEAK /

MUTE

ULTRA LO

BRIGHT

ULTRA HI

GRAPHIC EQ

MASTERTREBLEFREQUENCYMIDRANGEBASSDRIVEGAININPUT POWERSTANDBY

-12dB

+12dB

-10dB

+8dB

40Hz 90Hz 180Hz 300Hz 500Hz 1kHz 2kHz 4kHz 10kHz LEVEL

ACTIVE / PEAK

Important Safeguards and Precautions:

All Ampeg products are designed for continuous safe operation, as long as common sense is used and steps are taken to

help avoid certain problems. Abiding by the following rules can help prevent damage to your preamp, yourself and others.

•The amplifier is equipped with a three-pronged AC power cord. To reduce the risk of electrical shock,

NEVER remove or otherwise attempt to defeat the ground pin of the power cord.

•Connect the amplifier ONLY to a properly grounded AC outlet of the proper voltage for your amp.

•Avoid sudden temperature extremes, rain and moisture. Also, avoid sudden and intense impact. (If the unit

has been subjected to any of the preceding abuses, have it looked at by an authorized service center.)

•Never set the amplifier on a support that might give out under its weight.

•When using tall or stacked speaker cabinets, use them ONLY on a level surface. NEVER set tall or stacked

cabinets on a surface with more than a five degree incline since tipping or falling could occur, possibly caus-

ing serious injuries.

•Always keep the total speaker impedance at or above the rated load.

•Unplug the amplifier before cleaning it. NEVER spray liquid cleaners onto the amp. Wipe it with a slightly

dampened, lint-free cloth to remove dirt and film.

•Don’t use the amplifier if it has sustained damage to the chassis, controls, or power cord. Refer the unit to

an authorized service center for inspection.

•Amplifiers capable of producing high volume levels are also capable of inflicting permanent hearing loss or

damage, if the exposure to such levels is prolonged. Such damage is progressive and irreversible!

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER.

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

ATTENTION

RISQUE D'ELECTROCUTION

NE PAS OUVRIR

ATTENTION: POUR REDUIRE D'ELECTROCUTION NE PAS

ENLEVER LE COUVERCLE. AUCUNE PIECE INTERNE N'EST REPRABLE

PAR L'UTILISATEUR. POUR TOUTE REPARATION, S'ADRESSER A UN

TECHNICIEN QUALIFIE.

VORSICHT

ELEKTRISCHE SCHLAGGEFAHR

NICHT OFFENEN

VORSICHT: ZUR MINIMIERUNG ELEKTRISCHER SCHLAGGEFAHR NICHT

DEN DECKEL ABENHMEN. INTERNE TEILE KONNEN NICHT VOM

BENUTZER GEWARTET WERDEN. DIE WARTUNG IS QUALIFIZIERTEM

WARTUNGSPERSONAL ZU UBERLASSEN.

THIS EQUIPMENT HAS BEEN DESIGNED AND ENGINEERED TO PROVIDE SAFE AND RELIABLE OPERATION. IN ORDER TO PROLONG THE LIFE OF THE UNIT AND PREVENT ACCIDEN-

TAL DAMAGES OR INJURY, PLEASE FOLLOW THESE PRECAUTIONARY GUIDELINES:

WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT OPEN CHASSIS; DO NOT DEFEAT OR REMOVE THE GROUND PIN OF THE POWER CORD; CONNECT ONLY TO A PROP-

ERLY GROUNDED AC POWER OUTLET.

CAUTION: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.

CAUTION: NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

CAUTION: OUR AMPLIFIERS ARE CAPABLE OF PRODUCING HIGH SOUND PRESSURE LEVELS. CONTINUED EXPOSURE TO HIGH SOUND PRESSURE LEVELS CAN CAUSE PERMANENT

HEARING IMPAIRMENT OR LOSS. USER CAUTION IS ADVISED AND EAR PROTECTION IS RECOMMENDED IF UNIT IS OPERATED AT HIGH VOLUME. The chart below shows the U.S.

Government Occupational Safety and Health Administration (OSHA) regulations which were in effect at the time of this publication for permissible noise exposure, per 29CRF1910, Table G-16.

According to OSHA, any exposure in excess of those listed above could result in some hearing loss.

"IT IS NECESSARY FOR THE USER TO REFER TO THE INSTRUCTION MANUAL"

"REFERREZ-VOUS AU MANUAL D'UTILISATION"

"UNBEDINGT IN DER BEDIENUNGSANLEITUNG NACHSCHLAGEN"

EXPLANATION OF

GRAPHICAL SYMBOLS:

"DANGEROUS VOLTAGE"

"DANGER HAUTE TENSION"

"GEFAHLICHE SPANNUNG"

SOUND LEVEL dBA DURATION PER DAY

SLOW RESPONSE IN HOURS

90 8

92 6

95 4

97 3

100 2

SOUND LEVEL dBA DURATION PER DAY

SLOW RESPONSE IN HOURS

102 1-1/2

105 1

110 1/2

115 1/4 or less

TABLE CONTENTSOF

Important Safeguards and Precautions . . . . . . . . . . . . . . .2

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3

Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3

System Block Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . .3

The Front Panel Controls and Their Use . . . . . . . . . . . . . .4

The Rear Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5

Some Suggested Settings . . . . . . . . . . . . . . . . . . . . . . . . .6

Changing the Tubes . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7

Setting Tube Bias . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7

Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . .back cover

Technical Specifications . . . . . . . . . . . . . . . . . . .back cover

SVT-2 PRO Bass Amplifier

An Introduction to your new Ampeg SVT-2 PRO Bass Amplifier

The harmonically rich sound and legendary performance of the AMPEG SVT are redefined in the SVT-2 PRO.

This dynamically powerful bass amplifier delivers a thundering 300 watts of unsurpassed quality, reliability and

tonal flexibility, offering the classic vibrancy of tubes as well as contemporary features.

All of the features and controls of your SVT-2 PRO are covered in detail within the pages of this owner’s

guide. We recommend going over them before you use the amplifier.

Features

In the world of high performance bass amps, Ampeg’s SVT amplifiers stand alone. Keeping with true Ampeg tra-

dition, the SVT-2 PRO Bass Amplifier offers you more performance and flexibility than any other amplifier in its

class. Listed below are some of the outstanding features of your new preamp - features which set it apart from the

competition! Additional information on these features can be found on the pages indicated.

• ATTENUATOR: A switchable input pad, this feature is perfect for basses with active electronics or

very “hot” pickups (page 4).

• MUTE SWITCH: Lets you cut the sound from the amp, letting you tune your bass in private (page 4).

• ULTRA LOW, ULTRA HIGH AND BRIGHT SWITCHES: Lets you tailor your sound in many different

ways “with the touch of a button” (page 4).

• 5-POSITION MIDRANGE SELECTOR: Take your pick from the five center frequency points available

to get just the right midrange voice (page 4).

• 9-BAND GRAPHIC EQ: Use as a “second channel” for bass solos, or to shape your sound to your own

exacting standards. An independent level control lets you adjust the Graphic EQ volume. Switchable at

front panel or with a footswitch (page 4).

• BIAS ADJUSTMENT CONTROLS: Let you adjust the tube bias for proper operation (pages 5,7).

• SLAVE OUT: Use for powering another amp from the SVT-2 PRO’s preamp (page 5).

System Block Diagram

SVT-2 PRO Bass Amplifier

GAIN

LEVEL

INPUT

-15dB PAD

BUFFER

TUNER

OUT

FREQUENCY

PEAK

LED

DRIVE MIDBRIGHT

EQ ON

ULTRA

LOW

BASS TREBLE

ULTRA

HIGH

IMPEDANCE 4 OHMS

2 OHMS

MUTE

PRE/POST

LEVEL

MASTER

BIAS

ADJUST

BALANCED

OUT

GRAPHIC

EFFECTS

SEND

EFFECTS

RETURN

BUFFER

PREAMP

OUT POWER AMP

PROTECTION

SLAVE

OUT

1/4" JACK

SPEAKON

JACK

SPEAKER

OUTPUTS

PWR AMP

INPUT

PWR AMP

POWER

STDBY

FAULT BIAS

INDICATORS

1- 2-

GRAPHIC

MUTE

FOOTSWITCH

SWITCHING

CIRCUIT

Product specificaties

Merk:	Ampeg
Categorie:	Receiver
Model:	SVT-2PRO
Kleur van het product:	Zwart
Ingebouwd display:	Nee
Gewicht:	31751 g
Breedte:	482 mm
Diepte:	381 mm
Hoogte:	95 mm
Aan/uitschakelaar:	Ja
Connectiviteitstechnologie:	Bedraad
Ingang stroom:	Ja
Audio-uitgangskanalen:	- kanalen
Signaal/ruis-verhouding:	80 dB
Totale harmonische vervorming (THD):	3 procent
Regeling van bass-niveau:	Ja
Treble adjustment:	Ja
Piekvermogen per kanaal:	- W
Speakers connectiviteit type:	6.35mm
RMS vermogen uitvoer per kanaal (4 Ohm):	400 W
Gain aanpassing:	Draaiknop
RMS vermogen uitvoer per kanaal (2 Ohm):	400 W
Bass boost:	-12 - 12 dB