Viking K-1700-3 Handleiding

Viking Intercomsysteem K-1700-3

Lees hieronder de 📖 handleiding in het Nederlandse voor Viking K-1700-3 (8 pagina's) in de categorie Intercomsysteem. Deze handleiding was nuttig voor 34 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/8

Vandal Resistant Handsfree

Entry Phones with Built-In Keypad

Features

The K-1700-3 Series entry phones provide a tough and

attractive handsfree phone for apartment, and residential door

entry or applications requiring a vandal resistant speaker

phone. The K-1700-3 Series entry phones are available in

two attractive finishes: “brushed stainless steel” and “oil

rubbed bronze”.

When the “Call” button is pressed, the returns dialK-1700-3

tone. The keypad may then be used to dial any number. If

no Touch Tone is entered within 8 seconds, CPC is detected,

a busy signal is detected, or the programmable maximum call

time has elapsed, the will automatically disconnect.K-1700-3

Alternatively, the may be disconnected by pressingK-1700-3

the “Call” button again. The comes complete withK-1700-3

a standard, flush mount, rough-in box. In addition, an optional

VE-6x7 weather resistant, surface mount box is available (see

DOD 424).

The K-1700-3-EWP K-1700 shares all of the features of the -3

in addition to Enhanced Weather Protection (EWP) for outdoor

• Apartment entry phone when used with the Apartment Entry Dialer K-1900-3

or Apartment/Office Entry Controller or C-4000 C-3000 Apartment Entry

Controller

• Use with a ( ) to control 1 or 2 (expandable to 8) Viking C-500 DOD 177

K-1700-3’s and door/gate control on a single phone line

• Use with a to control 1 to 4 s and door/gate control Viking C-2000B K-1700’

on a single phone line ( ) DOD 156

• Courtesy and customer assistance phone

• Automated teller (ATM) phone

• Security or emergency phone

• Hot-Line phone when used with the Hot-Line Dialer ( ) K-1900-5 DOD 317

Note: When installing a line powered phone on a low voltage and/or low loop

current phone system extension, a Talk Battery Booster may be TBB-1B

required ( ). DOD 632

• Kiosk phone with (100 number speed dialing) when used with the K-1900-9

Multi-Number Dialer ( )DOD 321

Power: Telephone line powered 20V DC/20mA minimum

Dimensions: Overall: 5.5” x 6.5” x 2.6” (140mm x 165mm

x 66mm) , Rough-in box: 4.5” x 5.5” x 2.5” (114mm x

140mm x 64mm)

Shipping Weight: 3.5 lbs (1.6 kg)

Environmental: -30°F to 150°F (-34°C to 65°C)

Humidity - K-1700-3: 5% to 95% non-condensing

Humidity - K-1700-3-EWP: Up to 100% condensing

Speaker Volume: Approximately 70 db maximum @1m

CPC Disconnect Time: 500ms minimum

REN #: 0.5 A

Connections: Gel-filled tip and ring connectors

Applications

Specifications

www.VikingElectronics.com

Information: 715-386-8861

• Vandal Resistant Features: 14 gauge louvered 316 stainless

steel faceplate with permanent laser etched graphics, stainless

steel “Call” button, heavy duty metal keypad and T-10 Torx

security mounting screws, scratch resistant powder coating

(model K-1700-BN)

• Marine grade 316 stainless steel Weather Resistant Features:

faceplate, screws and and push button switch. Switch internally

sealed per IP67. Mylar speaker. Self-draining mic mount.

Faceplate, mic and speaker gaskets. Weather resisant powder

paint (K-1700-3-BN)

• is designed to meet IP66 Ingress Protection K-1700-3-EWP

Rating (see for more information) DOD 859

• Available in 2 standard faceplate finishes: 316 brushed stainless

steel or oil rubbed bronze

• Blue “in use” LED

• Telephone line powered

• Volume adjustments for microphone and speaker

• Advanced call progress detection: disconnects on busy signal,

return to dial tone, CPC, reorder tone, maximum call time out and

40 second silence time out

• Selectable auto-answer feature for monitoring

• Selectable push button disconnect

• Zinc plated steel rough-in box with (2) 3/4” conduit knockouts

• Optional Surface Mount Box available VE-6x7

• Selectable VOX switching speed

K-1700-3

“Brushed 316 Stainless Steel”

(similar to brushed nickel)

K-1700-3-BN

“Oil Rubbed Bronze”

(satin dark brown powder paint

with fine copper metallic)

installations where the unit is exposed to precipitation or

condensation. EWP products feature foam rubber gaskets

and boots, sealed connections, gel-filled butt connectors, as

well as urethane or thermal plastic potted circuit boards with

internally sealed, field-adjustable trim pots and DIP switches

for easy on-site programming. For more information on

Enhanced Weather Protection, see . DOD 859

DESIGNED, MANUFACTURED AND SUPPORTED IN THE USA

K-1700-3 Series

Handsfree Entry

Phones with Keypads

September 29, 2023

PRODUCT

MANUAL

SECURITY & COMMUNICATION

VIKING

(1) .74”

diameter

Rear View of the Optional

VE-6x7 Surface Mount Box

3.0” 3.3”

3.0”

2.25”

Condensation

Drain Hole

5.64”

6.72” 3.25”

(2) 0.2 x 0.43 slots

(4) 0.38” diameter

4.5”

2.5”

3/4” Conduit

Knockouts

5.5”

Rough-In

Box

(included)

Call

ABC

DEF

JK L

MNO

TU V

WXY

OPER

Mounting Screws: (4) 6-32 X 3/4”

Marine grade 316 stainless steel,

flat head, T-10 Torx security

screws and drive bit (included)

Optional VE-6x7

Surface Mount Box

(not included)

The optional VE-6x7 Surface Mount Box (above) is designed

to be surface mounted to a single gang box, double gang box,

or VE-GNP Gooseneck Pedestal (shown right). For more

information on the VE-6x7 VE-GNPand , see DOD 424.

K-1700-3-EWP

shown with VE-6x7

Surface Mount Box

and VE-GNP

Gooseneck

Pedestal

(not included)

Peel paper liner and adhere gasket to back of

panel, centering over mounting holes.

Caution: For rough surfaces (ie: brick, stucco,

etc.) additional caulking may be required.

Features Overview

Earth Ground: To increase surge

protection, loosen the screw labeled

(as shown) and fasten a wire with

spade terminal (included) from the

mounting screw to Earth Ground

(grounding rod, water pipe, etc.)

Speaker Volume

Microphone Volume

DIP Switches (see page 3)

Faceplate Gasket: 1/8" thick closed

cell PVC to provide a water-tight seal.

VIKING

Mode l: K-1700- 3

26110 2-1

Seria l No:

REN: 1.0B

XXXXXXXX

Viking Elect ron ics, Inc. (715) 386-8861

1531 Indu stri al S t., H udso n, WI 54016

P/N: DEV:

Co mplie s wit h FCC Part 15 and 68 Reg. No: A H3USA- 32531-T E-E

RoHS

Push Button Switch: Push to initiate

call, push again to disconnect. Solid

316 stainless steel, internally sealed

per IP67.

Speaker Screen: Speaker screen

with 0.018" wide slots to prevent

punctures from paperclips, etc.

Faceplate Material: 14 gauge (0.075”

thick) 316 stainless steel. The SS

model has a #4 brushed finish, the BN

model has a powder painted finish.

Speaker: Mylar speaker with rubber

gasket to maintain water-tight seal

and eliminate water deterioration.

Blue LED: Lights blue for “in-use”

indication.

Microphone: An omni-directional

microphone with a water-resistant

cloth for protection.

Call

VIKING

Condensation Drain Hole

Mounting Screws: (4) 6-32 X 3/4”

Marine grade 316 stainless steel, flat

head, T-10 Torx security screws and

drive bit (included).

Laser Etched Graphics: For long

lasting easy to read graphics. Copper

metallic on “oil rubbed bronze” model

K-1700-3-BN.

ABC

JKL

TUV

OPER

GHI

PRS

DEF

MNO

WXY

Installation

A. Mounting

Microphone Volume

(see section B)

Speaker Volume

(see section B)

ON OFF

DIP Switches

(shown in default

positions)

OFFOFF

Rear View of

the K-1700-3

IKIN

odel

-1700-3

261102-

Serial No

REN: 1 .0B

XXXXXX

ikin

Electronics, Inc.

(

715

)

386-886

531 Industri al St., Hudson, WI 5401

Complies with FCC Part 15 and 68 R e

. No: AH3USA-32531-TE-

RoH

Programming

A. DIP Switches

Switch 1 Switch 2 Maximum Call Time

OFF OFF Disabled

ON OFF 1 Minute

OFF ON 3 Minutes (default)

ON ON 9 Minutes

Switch 5 Switch 6 Audio Detection

ON ON Normal audio detection

OFF OFF

Increase audio detect sensitivity for

low level lines. Useful in applications

in which voice or busy signals have

trouble breaking over the speaker.

Switch 3 Disconnect on Dial Tone

OFF Off

ON On (default)

Switch 4 VOX Switching Speed

OFF Fast, 0.2 sec. (default)

ON Slow, 0.7 seconds

Switch 7 Auto Answer Position

OFF Automatic answer disabled

ON Automatic answer enabled (default)

Switch 8 Push Button Feature

OFF Connects calls only

ON Connects/disconnects calls (default)

VIKING

Mode l:

K-1700-3

261102- 1

Se rial No :

REN: 1.0B

XXXXXXXX

Viking Electronics, Inc. (715) 386-8 861

1531 Industrial St., Hudson, WI 54016

P/N: DE V:

Complies with FCC Part 15 a nd 68 Re g. No: AH3US A-3253 1-T E-E

RoHS

5.5”

4.04”

6.5”

5.12”

* C.O. Line or Analog

PABX/KSU Station

Spade

Terminal

(included)

*** Earth

Ground

(optional)

Red

(Ring)

Green

(Tip)

Rear View of

the K-1700-3

** Gel-Filled

Connectors

(included)

B. Wiring the K-1700-3

** Note: The gel-filled (water-tight) butt connectors are designed for insulation displacement on 19-26 gauge

wire with a maximum insulation of 0.082 inches. Cut off stripped wire ends prior to terminating.

*** Note: To increase surge protection, loosen the PCB

mounting screw labeled (shown right) and fasten a wire

with spade terminal (included) from the mounting screw to

Earth Ground (grounding rod, water pipe, etc.)

* Note: When installing a line powered phone on a low

voltage and/or low loop current phone system extension, a

TBB-1B Talk Battery Booster may be required ( .DOD# 632)

Model DOD# Description

C-500 177 Advanced 2 Door Controller (see page 5)

C-2000B 156 Advanced Door/Gate Controller (see page 6)

C-3000 162 Multi-Tenant Entry System (see page 7)

C-4000 164 Apartment/Office Entry Controller (page 7)

K-1900-3 312 Door Entry Dialer (see page 6)

To Optional Viking Entry Controllers (not included)

Product specificaties

Merk:	Viking
Categorie:	Intercomsysteem
Model:	K-1700-3
Kleur van het product:	Geborsteld staal
Gewicht:	1600 g
Breedte:	165 mm
Diepte:	66 mm
Hoogte:	140 mm
Geluidsniveau:	70 dB
Materiaal behuizing:	Roestvrijstaal
Internationale veiligheidscode (IP):	IP67
Plaatsing:	Muur
Connectiviteitstechnologie:	Bedraad
Aantal luidsprekers:	1
Certificering:	FCC Part 68\nFCC Part 15
Aantal knoppen:	13
Gemakkelijk te installeren:	Ja
Bedrijfstemperatuur (T-T):	-29 - 54 °C