Unimac UMC-15P Handleiding

Unimac Compressor UMC-15P

Lees hieronder de 📖 handleiding in het Nederlandse voor Unimac UMC-15P (14 pagina's) in de categorie Compressor. Deze handleiding was nuttig voor 50 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/14

UMC- -15P Petrol Powered

Air Compressor

User Manual

[Revision November 20221.0 ]

READ THIS MANUAL CAREFULLY BEFORE USE FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY DAMAGE AND –

MAY VOID WARRANTY. • . • Products covered by this manual may vary in KEEP THIS MANUAL FOR FUTURE REFERENCE

appearance, assembly, inclusions, specifications, description and packaging.

The product is NOT supplied with engine oil, although traces of oil from the manufacturing process may be present. It is essential to

add adequate engine oil of the correct type to the engine before use. Failure to add engine oil will void the product warranty.

Petrol-Powered Air Compressors

E&OE © 2 2022 Unimac

Safety

Safety messages are designed to alert you to possible dangers or hazards that could cause death, injury or

equipment or property damage if not understood or followed. Safety messages have the following symbols:

You WILL be KILLED or

SERIOUSLY INJURED if you do

not follow instructions.

You CAN be KILLED or

SERIOUSLY INJURED if you do

not follow instructions.

You CAN be INJURED if you do

not follow instructions or equipment

damage may occur.

It is vital that you read and understand this

user manual before using the product,

including safety warnings, and any assembly

and operating instructions. Keep the manual

for future reference.

Safety precautions and recommendations

detailed here must be fully understood and

followed to reduce the risk of injury, fire,

explosion, electrical hazard, and/or property

damage.

Safety information presented here is generic

in nature – some advice may not be

applicable to every product. The term

"equipment" refers to the product, be it

electrical mains powered, battery powered or

combustion engine powered.

• - If you are not familiar with the Before Use

safe operation/handling of the equipment or

are in any way unsure of any aspect of

suitability or correct use for your

application, you should complete training

conducted by a person or organization

qualified in safe use and operation of this

equipment, including fuel/electrical handling

and safety.

• Do NOT operate the equipment in

flammable or explosive environments, such

as in the presence of flammable liquids,

gases or dust. The equipment may create

sparks or heat that may ignite flammable

substances.

• Keep clear of moving parts.

• Equipment may be a potential source of

electric shock or injury if misused.

• Do NOT operate the equipment if it is

damaged, malfunctioning or is in an

excessively worn state.

• Do NOT allow others to use the equipment

unless they have read this manual and are

adequately trained.

• Keep packaging away from children - risk

of suffocation! Operators must use the

equipment correctly. When using the

equipment, consider conditions and pay

due care to persons and property.

General Work Area Safety

• Work areas should be clean and well it.

• Do not operate the equipment if

bystanders, animals etc are within

operating range of the equipment or the

general work area.

• If devices are provided for connecting dust

extraction / collection facilities, ensure

these are connected and used properly.

Dust collection can reduce dust-related

hazards.

General Personal Safety

• Wear appropriate protective equipment

when operating, servicing, or when in the

operating area of the equipment to help

protect from eye and ear injury, poisoning,

burns, cutting and crush injuries. Protective

equipment such as safety goggles,

respirators, non-slip safety footwear, hard

hat, hearing protection etc should be used

for appropriate equipment / conditions.

Other people nearby should also wear

appropriate personal protective equipment.

Do not wear loose clothing or jewellery,

which can be caught in moving parts. Keep

hair and clothing away from the equipment.

• Stay alert and use common sense when

operating the equipment. Do not over-

reach. Always maintain secure footing and

balance.

• Do not use the equipment if tired or under

the influence of drugs, alcohol or

medication.

• This equipment is not intended for use by

persons with reduced physical, sensory or

mental capabilities.

General Fuel Safety

• Petrol/fuel/gasoline is extremely flammable

– keep clear of naked flames or other

ignition sources.

• Do not spill fuel. If you spill fuel, wipe it off

the equipment immediately – if fuel gets on

your clothing, change clothing.

• Do NOT smoke near fuel or when

refuelling.

• Always shut off the engine before

refuelling.

• Do NOT refuel a hot engine.

• Open the fuel cap carefully to allow any

pressure build-up in the tank to release

slowly.

• Always refuel in well ventilated areas.

• Always check for fuel leakage. If fuel

leakage is found, do not start or run the

engine until all leaks are fixed.

General Carbon-Monoxide Safety

• Using a combustion engine indoors CAN

KILL IN MINUTES. Engine exhaust

contains carbon-monoxide – a poison you

cannot smell or see.

• Use combustion engines OUTSIDE only,

and far away from windows, doors and

vents.

General Equipment Use and Care

• The equipment is designed for domestic

use only.

• Handle the equipment safely and carefully.

• Before use, inspect the equipment for

misalignment or binding of moving parts,

loose components, damage or any other

condition that may affect its operation. If

damaged, have the equipment repaired by

an authorised service centre or technician

before use.

• Prevent unintentional starting of the

equipment - ensure equipment and power

switches are in the OFF position before

connecting or moving equipment. Do not

carry equipment with hands or fingers

touching any controls. Remove any tools or

other items that are not a part of the

equipment from it before starting or

switching on.

• Do not force the equipment. Use the

correct equipment for your application.

Equipment will perform better and be safer

when used within its design and usage

parameters.

• Use the equipment and accessories etc. in

accordance with these instructions,

considering working conditions and the

work to be performed. Using the equipment

for operations different from those intended

could result in hazardous situations.

• Always keep equipment components

(engines, hoses, handles, controls, frames,

housings, guards etc) and accessories

(cutting tools, nozzles, bits etc) properly

maintained. Keep the equipment clean and,

where applicable, properly lubricated.

• Store the equipment out of reach of

children or untrained persons. To avoid

burns or fire hazards, let the equipment

cool completely before transporting or

storing. Never place or store the equipment

near flammable materials, combustible

gases or liquids etc.

• The equipment is not weather-proof, and

should not be stored in direct sunlight, at

high ambient temperatures or locations that

are damp or humid.

• Do not clean equipment with solvents,

flammable liquids or harsh abrasives.

• For specific equipment safety use and care,

see Equipment Safety.

Petrol-Powered Air Compressors

E&OE © 3 2022 Unimac

General Electrical Safety

• Inspect electrical equipment, extension

cords, power bars, and electrical fittings for

damage or wear before each use. Repair or

replace damaged equipment immediately.

• Ensure all power sources conform to

equipment voltage requirements and are

disconnected before connecting or

disconnecting equipment.

• When wiring electrically powered

equipment, follow all electrical and safety

codes.

• Wherever possible, use a residual current

device (RCD).

• High voltage / high current power lines may

be present. Use extreme caution to avoid

contact or interference with power lines.

Electrical shock can be fatal.

General Electrical Safety

• Electrically grounded equipment must have

an approved cord and plug and be

connected to a grounded electrical outlet.

• Do NOT bypass the ON/OFF switch and

operate equipment by connecting and

disconnecting the electrical cord.

• Do NOT use equipment that has exposed

wiring, damaged switches, covers or

guards.

• Do NOT use electrical equipment in wet

conditions or in damp locations.

• Do NOT use electrical cords to lift, move or

carry equipment.

• Do NOT coil or knot electrical cords, and

ensure electrical cords are not trip hazards.

General Service Information

• The equipment must be serviced or

repaired at authorised service centres by

qualified personnel only.

• Replacement parts must be original

equipment manufacturer (OEM) to ensure

equipment safety is maintained.

• Do NOT attempt any maintenance or repair

work not described in this manual.

• After use, the equipment and components

may still be hot – allow the equipment to

cool and disconnect spark plugs and/or

electrical power sources and/or batteries

from it before adjusting, changing

accessories or performing repair or

maintenance.

• Do NOT adjust while the equipment is

running.

• Perform service related activities in suitable

conditions, such as a workshop.

• Replace worn, damaged or missing

warning/safety labels immediately.

Air Compressor Safety

• IMPORTANT! This compressor may arrive with no oil or insufficient oil. Ensure you confirm the oil level prior to starting. Fill the unit

with oil -30W e you SAE 20 to the top of the sight glass. The engine on this compressor may arrive with no oil or insufficient oil. Ensur

confirm the oil level prior to starting. Fill the unit with 10W 50 engine oil. Failure to check oil in both components -30 or 15W-40 or 20W-

will cause irreparable damage and will not be covered by warranty.

• Read and understand all the operating instructions, safety precautions and warnings in the Instruction before operating or maintaining this

compressor.

• Most accidents that result from compressor operation and maintenance are caused by the failure to observe basic safety rules or precautions.

• An accident can often be avoided by recognizing a potential hazardous situation before it occurs, and by observing appropriate safety

procedures.

• Basic safety precautions are outlined in the “SAFETY” section of this User Manual and in the sections that contain the operation and

maintenance instructions.

• Hazards that must be avoided to prevent bodily injury or machine damage are identified by WARNINGS on the compressor and in this Instruction

Manual.

• Never use this compressor in a manner

• that has not been specifically recommended by manufacturer, unless you first confirm that the planned use will be safe for you and others.

• WARNING: DEATH OR SERIOUS BODILY INJURY COULD RESULT FROM IMPROPER OR UNSAFE USE OF COMPRESSOR. TO AVOID

THESE RISKS, FOLLOW THESE BASIC SAFETY INSTRUCTIONS.

• . Never place your hands, fingers or other body parts near the compressor’s moving parts. NEVER TOUCH MOVING PARTS

• . Never operate this compressor without all guards or safety features in place and in NEVER OPERATE WITHOUT ALL GUARDS IN PLACE

proper working order. If maintenance or servicing requires the removal of a guard or safety features, be sure to replace the guards or safety

feature before resuming operation of the compressor.

• . Always wear safety goggles or equivalent eye protection. Compressed air must never be aimed at anyone ALWAYS WEAR EYE PROTECTION

or any part of the body.

• . Prevent body contact with grounded surfaces such as pipes, radiators, ranges and PROTECT YOURSELF AGAINST ELECTRIC SHOCK

refrigeration enclosures. Never operate the compressor in damp or wet locations.

• . Always disconnect the compressor from the power source and remove the compressed air from the air DISCONNECT THE COMPRESSOR

tank before inspecting, maintaining, cleaning, replacing or checking any parts.

• . Do not carry the compressor while it is connected to its power source or when the air tank is filled with AVOID UNINTENTIONAL STARTING

compressed air. Be sure the knob of the pressure switch in the “OFF” position before connecting the compressor to its powe r source.

• . When not in use, the compressor should be stored in dry place. Keep out of reach of children. Lock-out STORE COMPRESSOR PROPERLY

the storage area.

• . Cluttered areas invite injury. Clear all work areas of unnecessary tools, debris, furniture, etc. KEEP WORK AREA CLEAN

• . Do not let visitors contact compressor extension cord. All visitors should be kept safely away from work area. KEEP CHILDREN AWAY

• . Do not wear loose clothing or jewellery. They can be caught in moving parts. Wear protective hair covering to contain long DRESS PROPERLY

hair.

• . Never yank it to disconnect from receptacle. Keep cord from heated oil and sharp edges. DON’T ABUSE CORD

• . Follow instructions for lubricating. Inspect cords periodically and if damaged, have repaired by MAINTAIN COMPRESSOR WITH CARE

authorised service facility. Inspect extension cords periodically and replace if damaged.

• . When compressor is used outdoors, use only extension cords intended for use outdoors and so marked. OUTDOOR USE EXTENSION CORDS

• . Watch what you are doing. Use common sense. Do not operate compressor when you are tired. Compressor should never be STAY ALERT

used if you are under the influence of alcohol, drugs or medication that makes you drowsy.

Product specificaties

Merk:	Unimac
Categorie:	Compressor
Model:	UMC-15P

Heb je hulp nodig?

Als je hulp nodig hebt met Unimac UMC-15P stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Compressor Unimac

Unimac ACM-200s Handleiding

9 April 2024

Unimac ACM-150s Handleiding

9 April 2024

Unimac ACM-160s Handleiding

9 April 2024

Unimac ACM-240s Handleiding

9 April 2024

Unimac UMVC-15S Handleiding

15 Juni 2023

Unimac ACM-1000s Handleiding

3 Juni 2023

Unimac UMC-12P Handleiding

8 Mei 2023

Unimac ACM-500s Handleiding

2 Mei 2023

Unimac ACM-400s Handleiding

2 Mei 2023

Unimac ACM-250s Handleiding

1 Mei 2023

Handleiding Compressor

Nieuwste handleidingen voor Compressor

Workzone WZK 182 Handleiding

14 November 2024

Hyundai HY3200S Handleiding

20 Oktober 2024

MSW -UVRSRI Handleiding

15 Oktober 2024

MSW -SPS-24 Handleiding

15 Oktober 2024

Einhell BT-AC 180/6 Kit Handleiding

6 September 2024

Einhell N-KS 210/8/24 Set Handleiding

6 September 2024

Anova CA30S Handleiding

5 September 2024

Anova CA50S Handleiding

5 September 2024

DeWalt D55154 Handleiding

29 Augustus 2024

DeWalt DCC2520 Handleiding

27 Augustus 2024