Unimac ACM-150s Handleiding

Unimac Compressor ACM-150s

Lees hieronder de 📖 handleiding in het Nederlandse voor Unimac ACM-150s (17 pagina's) in de categorie Compressor. Deze handleiding was nuttig voor 45 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/17

ACM- 150s Oil Free Air Compressor

User Manual

[Revision February 20241.0 ]

READ THIS MANUAL CAREFULLY BEFORE USE FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY DAMAGE AND –

MAY VOID WARRANTY. • . • Products covered by this manual may vary in KEEP THIS MANUAL FOR FUTURE REFERENCE

appearance, assembly, inclusions, specifications, and packaging.description,

ACM- 150s Oil Free Air Compressor

E&OE © 2 2024 Unimac

Safety

Safety messages are designed to alert you to possible dangers or hazards that could cause death, injury or

equipment or property damage if not understood or followed. Safety messages have the following symbols:

You WILL be KILLED or

SERIOUSLY INJURED if you do

not follow instructions.

You CAN be KILLED or

SERIOUSLY INJURED if you do

not follow instructions.

You CAN be INJURED if you do

not follow instructions or equipment

damage may occur.

It is vital that you read and understand this

user manual before using the product,

including safety warnings, and any assembly

and operating instructions. Keep the manual

for future reference.

Safety precautions and recommendations

detailed here must be fully understood and

followed to reduce the risk of injury, fire,

explosion, electrical hazard, and/or property

damage.

Safety information presented here is generic

in nature – some advice may not be

applicable to every product. The term

"equipment" refers to the product, be it

electrical mains powered, battery powered or

combustion engine powered.

• - If you are not familiar with the Before Use

safe operation/handling of the equipment or

are in any way unsure of any aspect of

suitability or correct use for your

application, you should complete training

conducted by a person or organization

qualified in safe use and operation of this

equipment, including fuel/electrical handling

and safety.

• Do NOT operate the equipment in

flammable or explosive environments, such

as in the presence of flammable liquids,

gases, or dust. The equipment may create

sparks or heat that may ignite flammable

substances.

• Keep clear of moving parts.

• Equipment may be a potential source of

electric shock or injury if misused.

• Do NOT operate the equipment if it is

damaged, malfunctioning or is in an

excessively worn state.

• Do NOT allow others to use the equipment

unless they have read this manual and are

adequately trained.

• Keep packaging away from children - risk

of suffocation! Operators must use the

equipment correctly. When using the

equipment, consider conditions and pay

due care to persons and property.

General Work Area Safety

• Work areas should be clean and well it.

• Do not operate the equipment if

bystanders, animals etc are within

operating range of the equipment or the

general work area.

• If devices are provided for connecting dust

extraction / collection facilities, ensure

these are connected and used properly.

Dust collection can reduce dust-related

hazards.

General Personal Safety

• Wear appropriate protective equipment

when operating, servicing, or when in the

operating area of the equipment to help

protect from eye and ear injury, poisoning,

burns, cutting and crush injuries. Protective

equipment such as safety goggles,

respirators, non-slip safety footwear, hard

hat, hearing protection etc should be used

for appropriate equipment / conditions.

Other people nearby should also wear

appropriate personal protective equipment.

Do not wear loose clothing or jewellery,

which can be caught in moving parts. Keep

hair and clothing away from the equipment.

• Stay alert and use common sense when

operating the equipment. Do not over-

reach. Always maintain secure footing and

balance.

• Do not use the equipment if tired or under

the influence of drugs, alcohol, or

medication.

• This equipment is not intended for use by

persons with reduced physical, sensory, or

mental capabilities.

General Fuel Safety

• Petrol/fuel/gasoline is extremely flammable

– keep clear of naked flames or other

ignition sources.

• Do not spill fuel. If you spill fuel, wipe it off

the equipment immediately – if fuel gets on

your clothing, change clothing.

• Do NOT smoke near fuel or when

refuelling.

• Always shut off the engine before

refuelling.

• Do NOT refuel a hot engine.

• Open the fuel cap carefully to allow any

pressure build-up in the tank to release

slowly.

• Always refuel in well-ventilated areas.

• Always check for fuel leakage. If fuel

leakage is found, do not start, or run the

engine until all leaks are fixed.

General Carbon-Monoxide Safety

• Using a combustion engine indoors CAN

KILL IN MINUTES. Engine exhaust

contains carbon-monoxide – a poison you

cannot smell or see.

• Use combustion engines OUTSIDE only,

and far away from windows, doors, and

vents.

General Equipment Use and Care

• The equipment is designed for domestic

use only.

• Handle the equipment safely and carefully.

• Before use, inspect the equipment for

misalignment or binding of moving parts,

loose components, damage, or any other

condition that may affect its operation. If

damaged, have the equipment repaired by

an authorised service centre or technician

before use.

• Prevent unintentional starting of the

equipment - ensure equipment and power

switches are in the OFF position before

connecting or moving equipment. Do not

carry equipment with hands or fingers

touching any controls. Remove any tools or

other items that are not a part of the

equipment from it before starting or

switching on.

• Do not force the equipment. Use the

correct equipment for your application.

Equipment will perform better and be safer

when used within its design and usage

parameters.

• Use the equipment and accessories etc. in

accordance with these instructions,

considering working conditions and the

work to be performed. Using the equipment

for operations different from those intended

could result in hazardous situations.

• Always keep equipment components

(engines, hoses, handles, controls, frames,

housings, guards etc) and accessories

(cutting tools, nozzles, bits etc) properly

maintained. Keep the equipment clean and,

where applicable, properly lubricated.

• Store the equipment out of reach of

children or untrained persons. To avoid

burns or fire hazards, let the equipment

cool completely before transporting or

storing. Never place or store the equipment

near flammable materials, combustible

gases, or liquids etc.

• The equipment is not weather-proof, and

should not be stored in direct sunlight, at

high ambient temperatures or locations that

are damp or humid.

• Do not clean equipment with solvents,

flammable or harsh abrasives. liquids,

• For specific equipment safety use and care,

see Equipment Safety.

ACM- 150s Oil Free Air Compressor

E&OE © 3 2024 Unimac

General Electrical Safety

• Inspect electrical equipment, extension

cords, power bars, and electrical fittings for

damage or wear before each use. Repair or

replace damaged equipment immediately.

• Ensure all power sources conform to

equipment voltage requirements and are

disconnected before connecting or

disconnecting equipment.

• When wiring electrically powered

equipment, follow all electrical and safety

codes.

• Always use a Residual Current Device

(RCD) (GFCI) / Earth Leakage Circuit

Breaker / Safety Switch when operating this

item (electrical items only).

• High voltage / high current power lines may

be present. Use extreme caution to avoid

contact or interference with power lines.

Electrical shock can be fatal.

General Electrical Safety

• Electrically grounded equipment must have

an approved cord and plug and be

connected to a grounded electrical outlet.

• Do NOT bypass the ON/OFF switch and

operate equipment by connecting and

disconnecting the electrical cord.

• Do NOT use equipment that has exposed

wiring, damaged switches, covers or

guards.

• Do NOT use electrical equipment in wet

conditions or in damp locations.

• Do NOT use electrical cords to lift, move or

carry equipment.

• Do NOT coil or knot electrical cords, and

ensure electrical cords are not trip hazards.

General Service Information

• The equipment must be serviced or

repaired at authorised service centres by

qualified personnel only.

• Replacement parts must be original

equipment manufacturer (OEM) to ensure

equipment safety is maintained.

• Do NOT attempt any maintenance or repair

work not described in this manual.

• After use, the equipment and components

may still be hot – allow the equipment to

cool and disconnect spark plugs and/or

electrical power sources and/or batteries

from it before adjusting, changing

accessories, or performing repair or

maintenance.

• Do NOT adjust while the equipment is

running.

• Perform -related service activities in suitable

conditions, such as a workshop.

• Replace worn, damaged or missing

warning/safety labels immediately.

Child Choking Hazard!

• WARNING: CHOKING HAZARD - CHILDREN UNDER 8 YRS. CAN CHOKE OR SUFFOCATE ON SMALL PARTS. ADULT

SUPERVISION REQUIRED.

• Carefully inspect anything a baby or child could gain access to, including this product & packaging.

• Dangers include anything of a size that could become stuck or lodged in a baby or child's airway.

• Dangers include things like raw, hard fruit and vegetable pieces, large pieces of meat, bones or sausage skins, popcorn, nuts,

hard lollies and corn chips, small magnets and batteries, coins, beads, marbles and small uninflated balloons, broken toys and smaller toys,

buttons, and coins. But there are also many more. keys,

• Pay particular attention to accessories, nuts, bolts, screws, washers, caps, covers, loose parts, parts that could be removed or break off, pieces

of packaging, staples, tape etc.

• In the case of any doubt, secure the item of concern in an appropriate manner, or completely remove the possibility of access by a baby or child.

General Safety Instructions

• READ THIS MANUAL BEFORE USING THIS PRODUCT. FAILURE TO FOLLOW THE INSTRUCTIONS AND SAFETY PRECAUTIONS IN

THIS MANUAL CAN RESULT IN SERIOUS INJURY OR DEATH. KEEP THIS MANUAL FOR FUTURE REFERENCE.

• Your safety and the safety of others depend on you thoroughly reading and understanding this manual. Most tool-related incidents are caused by

failure to observe basic safety rules or precautions. You must be alert to potential hazards. You must have the necessary training, skills, and tools

to perform these functions. Manufacturer cannot anticipate every possible circumstance that might involve a potential hazard. Therefore, the

warnings in this manual are not all inclusive. If a tool, procedure, work method or operating technique that is not specifically recommended by

Manufacturer is used, you must satisfy yourself that it is safe for you and for others. You should also ensure that the product will not be damaged

or be made unsafe by the operation, lubrication, maintenance, or repair procedures that you choose.

• WARNING: THIS PRODUCT OR ITS POWER CORD MAY CONTAIN CHEMICALS KNOWN TO CAUSE CANCER AND BIRTH DEFECTS OR

OTHER REPRODUCTIVE HARM. WASH HANDS AFTER HANDLING.

• WARNING: YOU CAN CREATE DUST WHEN YOU CUT, SAND, DRILL, OR GRIND MATERIALS SUCH AS WOOD, PAINT, METAL,

CONCRETE, CEMENT, OR OTHER MASONRY. THIS DUST OFTEN CONTAINS CHEMICALS KNOWN TO CAUSE CANCER, BIRTH

DEFECTS, OR OTHER REPRODUCTIVE HARM. WEAR PROTECTIVE GEAR.

Important Safety Information

• PLEASE READ AND SAVE THESE INSTRUCTIONS. READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE,

OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION.

FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! RETAIN

INSTRUCTIONS FOR FUTURE REFERENCE.

• This manual contains important safety, operational and maintenance information. If you have any questions, please visit an authorised service

centre, or contact the manufacturer.

• Since the air compressor and other components used (material pump, spray guns, filters, lubricators, hoses, etc.) make up a high-pressure

pumping system, the following safety precautions must be observed at all times:

• Read all manuals included with this product carefully. Be thoroughly familiar with the controls and the proper use of the equipment.

• Follow all local electrical and safety codes in your area.

• Only persons well acquainted with these rules of safe operation should be allowed to use the compressor.

• Keep visitors away and keep out of reach of children.

• Wear safety glasses and use hearing protection when operating the unit.

• Do not stand on or use the unit as a handhold.

Product specificaties

Merk:	Unimac
Categorie:	Compressor
Model:	ACM-150s

Heb je hulp nodig?

Als je hulp nodig hebt met Unimac ACM-150s stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Compressor Unimac

Unimac ACM-200s Handleiding

9 April 2024

Unimac ACM-150s Handleiding

9 April 2024

Unimac ACM-160s Handleiding

9 April 2024

Unimac ACM-240s Handleiding

9 April 2024

Unimac UMVC-15S Handleiding

15 Juni 2023

Unimac ACM-1000s Handleiding

3 Juni 2023

Unimac UMC-12P Handleiding

8 Mei 2023

Unimac ACM-500s Handleiding

2 Mei 2023

Unimac ACM-400s Handleiding

2 Mei 2023

Unimac ACM-250s Handleiding

1 Mei 2023

Handleiding Compressor

Nieuwste handleidingen voor Compressor

Total TACLI2002 Handleiding

16 December 2024

Bavaria BAC 200/200F Handleiding

5 December 2024

Einhell YPL 206 Handleiding

4 December 2024

Einhell BT-AC 160/6 OF Handleiding

4 December 2024

Einhell TE-AC 400/100/10 D Handleiding

4 December 2024

Einhell TE-AC 300/50/10 Handleiding

4 December 2024

Einhell BT-AC 190/10 Handleiding

4 December 2024

Einhell BT-AC 140/24 OF Handleiding

4 December 2024

Einhell BT-AC 190/24 Handleiding

4 December 2024

Einhell EURO 4300 V Handleiding

4 December 2024