Toolland PH360 Handleiding

Toolland Snijmachine PH360

Lees hieronder de 📖 handleiding in het Nederlandse voor Toolland PH360 (17 pagina's) in de categorie Snijmachine. Deze handleiding was nuttig voor 6 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/17

PH340/PH360

USER MANUAL 2

HANDLEIDING 4

MODE D'EMPLOI 6

MANUAL DEL USUARIO 8

BEDIENUNGSANLEITUNG 10

INSTRUKCJA OBSŁUGI 12

MANUAL DO UTILIZADOR 14

PH340/PH360

V. 01 05/12/2018 2 ©Velleman nv –

USER MANUAL

1. Introduction

Thank you for choosing Toolland. Please read the manual thoroughly before bringing this

device into service. If the device was damaged in transit, do not install or use it and contact

your dealer.

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.

2. Safety Instructions

Safety gloves are required while operating this machine.

 CAUTION The edges of cut tiles are sharp. –

 Always keep the appliance away from any crash and corrosive liquid.

 This tile-cutting machine is fitted with a replaceable circular blade. Keep the tile cutter and

blade away from children.

 After use, the appliance must be stored in a safe and dry place.

 This appliance is designed for cutting and breaking glazed tile, and shall not be used for

any other purpose.

 When using the appliance, always keep extension leads away from the machine.

 Always place the appliance on a level and firm surface.

3. Operation

1. Place the tile on the cutter bed. Set the guide to the width of the tile.

2. Position the tile-cutter wheel on the base of the tile to be cut.

Score the tile by moving the handle forward away from you while pressing down – –

lightly. K steady pressure for the full length of the tile. eep a

At the end of the score, the wheel will bump against the buffer. Make sure the anvil sits

over the score line.

3. Press down slightly applying increasing pressure until the tile snaps. Tip: Press the handle

with one hand and hold the base of the tile with the other.

PH340/PH360

V. 01 05/12/2018 3 ©Velleman nv –

4. Cleaning and Maintenance

Occasionally wipe with a damp cloth to keep free from dust. Do not use harsh chemicals,

cleaning solvents or strong detergents.

Follow the illustrations below to replace the cutting wheel.

5. Technical Specifications

length

PH340 ........................................................................................................... 400 mm

PH360 ........................................................................................................... 600 mm

max. tile thickness ................................................................................................. 12 mm

PH340 ............................................................................................................ 12 mm

PH360 ......................................................................................................... 4-12 mm

cutting wheel size ........................................................... 22 x 6 x 2 mm (order code PH341)

Use this device with original accessories only. Velleman nv cannot be held

responsible in the event of damage or injury resulting from (incorrect) use of this

device. For more info concerning this product and the latest version of this manual,

please visit our website www.toolland.eu. The information in this manual is subject

to change without prior notice.

The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.

No part of this manual may be copied, reproduced, translated or reduced to any electronic

medium or otherwise without the prior written consent of the copyright holder.

Product specificaties

Merk:	Toolland
Categorie:	Snijmachine
Model:	PH360
Kleur van het product:	Black, Stainless steel, Red
Materiaal:	Steel, Metal
Geschikt voor materialen:	Ceramic, Porcelain
Snijdikte (max):	12 mm
Snijlengte (max):	600 mm