Toa YW-4500 Handleiding

Toa Tv-antenne YW-4500

Lees hieronder de 📖 handleiding in het Nederlandse voor Toa YW-4500 (20 pagina's) in de categorie Tv-antenne. Deze handleiding was nuttig voor 60 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/20

INSTRUCTION MANUAL

WALL-MOUNTED WIRELESS ANTENNA

YW-4500

Please follow the instructions in this manual to obtain the optimum results from this unit.

We also recommend that you keep this manual handy for future reference.

1. SAFETY PRECAUTIONS

• Be sure to read the instructions in this section carefully before use.

• Make sure to observe the instructions in this manual as the conventions of safety symbols and messages

regarded as very important precautions are included.

• We also recommend you keep this instruction manual handy for future reference.

Safety Symbol and Message Conventions

Safety symbols and messages described below are used in this manual to prevent bodily injury and property

damage which could result from mishandling. Before operating your product, read this manual ﬁ rst and

understand the safety symbols and messages so you are thoroughly aware of the potential safety hazards.

• Be sure to securely mount the unit on the wall or ceiling that is robust enough to stand the antenna weight.

Failure to do so may drop the antenna, causing personal injury and/or property damage.

• Do not expose the unit to rain or an environment where it may be splashed by water or other liquids, as doing

so may result in ﬁ re or electric shock.

• To prevent lightning strikes, install the unit at least ﬁ ve meters away from a lightning rod, and yet within the

protective range (angle of 45º) of the lightning conductor. Lightning strikes may cause a ﬁ re, electric shock or

personal injury.

• Since the unit is designed for in-door use, do not install it outdoors. If installed outdoors, the aging of parts

causes the unit to fall off, resulting in personal injury. Also, when it gets wet with rain, there is a danger of

electric shock.

• Use nuts and bolts that are appropriate for the ceiling's or wall's structure and composition. Failure to do so

may cause the unit to fall, resulting in material damage and possible personal injury.

• Do not touch a plug or antenna during thunder and lightning, as this may result in electric shock.

• Leave the installation of an antenna to your TOA dealer because the installation requires expert knowledge.

The falling of an antenna may cause personal injury.

• Do not place heavy objects on the unit as this may cause it to fall or break which may result in personal injury

and/or property damage. In addition, the object itself may fall off and cause injury and/or damage.

Traceability Information for Europe

Manufacturer:

TOA Corporation

7-2-1, Minatojima-Nakamachi, Chuo-ku, Kobe, Hyogo,

Japan

Authorized representative:

TOA Electronics Europe GmbH

Suederstrasse 282, 20537 Hamburg,

Germany

Indicates a potentially hazardous situation which, if mishandled, could

result in death or serious personal injury.

WARNING

Indicates a potentially hazardous situation which, if mishandled, could

result in moderate or minor personal injury, and/or property damage.

CAUTION

2. GENERAL DESCRIPTION

The TOA YW-4500 is an indoor dipole antenna designed to be used in a UHF band wireless system. A power

lamp is provided on the unit's bottom side to indicate the power supply status (it lights when power is supplied.).

Power for the YW-4500 is supplied on a coaxial cable from the antenna connector of the WT-5800, WT-5805,

WT-4820, or WD-4800.

Cable loss can be compensated for by a built-in RF signal booster.

3. INSTALLATION PRECAUTIONS

• Avoid installing the unit in humid or dusty locations, in locations exposed to the direct sunlight, near the

heaters, or in locations generating sooty smoke or steam.

• When installing the YW-4500 in a room of a tall building, be sure to position it more than 1 m apart from a

window to minimize interference caused by external noises of radio waves.

• When using a wireless microphone, keep it 3 m or more away from the YW-4500.

Doing otherwise may cause unused other channels to operate or radio interference to occur.

• When using two or more antennas, they should be spaced out 6 to 18 m apart from each other.

• Take special care when treating coaxial cable end and when connecting the cable to the antenna and

BNC connector. Incomplete cable treatment and connection deteriorate receiving sensitivity, and increase

interference caused by external noises.

• Use the coaxial cable of 75 Ω impedance.

4. NOMENCLATURE

Unit: mm

[Front]

[Side] [Bottom]

[Top]

85 105

120

126

140

116

Sets attenuation level for 0, –10, or

–20 dB positions.

(For details, refer to "7. ATTENUATOR

SWITCH SETTING.")

Lights when power is

supplied to the unit.

Attenuator switch

Power lamp

Bottom caseTop case

Step 3.

Strip coaxial cable end.

• RG-6/U

• RG-11/U

Step 2. Detach the top case from the bottom case.

• If the coaxial cable is wired over the wall from the

ceiling or floor

1. Cut the cable outlet of the frame using a pair of

cutting pliers, etc.

3. Run the coaxial cable through the cable outlet.

5. INSTALLATION

Unit: mm

• If the coaxial cable is to be drawn directly from the

wall surface

1. Drill a ø20 mm hole.

2. Run the coaxial cable through the hole and the

bottom case as well, and draw it out as shown

below.

• If the coaxial cable is installed using a recessed

electrical box (Mounting pitch: 83.5 mm)

Draw out the coaxial cable through the electrical

box and the bottom case.

Note: Be sure to use a pipe thick enough to allow

the wired coaxial cable to be easily inserted.

Step 1.

Remove 4 screws on the top case.

2. Cut the supplied rubber bushing into halves. One

half is suited for the RG-6U cable (smaller internal

diameter) and other half for the RG-11/U cable

(larger internal diameter). Run the cable through

the bushing. (Insert the bushing into the cable

entry hole after cable installation completion.)

Attenuator switch

Top case

Bottom case

Cable outlet

Rubber bushing

ø20 mm

10312Jacket

Conductor

Braided shield

Dielectric

Unknit braided shields

and bend it back.

Braided shield

Conductor

103

Product specificaties

Merk:	Toa
Categorie:	Tv-antenne
Model:	YW-4500
Kleur van het product:	Wit
Gewicht:	270 g
Breedte:	105 mm
Diepte:	126 mm
Hoogte:	140 mm
Materiaal:	ABS
Merkcompatibiliteit:	TOA
Impedantie:	75 Ohm
Stroomverbruik:	15 mA
Frequentie bereik:	550 - 932 MHz
Bedrijfstemperatuur (T-T):	-10 - 50 °C
Type product:	Antenne
Versterking:	8 dBi