Tecmate Optimate DC-DC Handleiding

Tecmate Batterij-oplader Optimate DC-DC

Lees hieronder de 📖 handleiding in het Nederlandse voor Tecmate Optimate DC-DC (30 pagina's) in de categorie Batterij-oplader. Deze handleiding was nuttig voor 13 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/30
1
INSTRUCTIONS FOR USE
IMPORTANT: Read completely
before charging
MODE D’EMPLOI
IMPORTANT: à lire avant
d’utiliser l’appareil
ANWENDUNGSVORSCHRIFTEN
WICHTIG: Vollständig vor der
Benutzung lesen
GEBRUIKSAANWIJZING
BELANGRIJK: Lees volledig
voor gebruik
MODO DE EMPLEO
IMPORTANTE: a leer antes de
utilizar el aparato
INSTRUÇÕES DE UTILIZAÇÃO
IMPORTANTE: Ler antes de
utilizar.
ISTRUZIONI PER L’USO
IMPORTANTE: da leggere prima
di utilizzare l’apparecchio
INSTRUKTIONER
VIKTIGT: läs följande fullständiga
instruktioner för användningen
innan du använder laddaren
Automatic charger for 12V lead-acid & 12.8V
LiFePO batteries • Chargeur automatique 4
pour batteries 12V plomb-acide & 12.8V
LiFePO • Automatische Ladegerät für 12V 4
Blei-Säure & 12.8V LiFePO Batterien 4
• Cargador automático para baterías 12V
plomo-ácido & 12.8V LiFePO • Caricabatterie 4
automatico per batterie 12V piombo-acido &
12.8V LiFePO • Automatische lader voor 12V 4
loodzuur & 12.8V LiFePO accu’s • Automatisk 4
laddare för 12V blybatterier & 12.8V LiFePO 4
batterier • Carregador automático para
baterias de 12V chumbo/ácido & 12.8V
LiFePO4
MODEL: TM500 (v2 2017)
INPUT DC: 12V-16VDC 2.7A max.
OUTPUT DC: 2A 12V
12V - 16V
STD / AGM-MF / GEL /
AGM CYCLIC CELL / LITHIUM
+ -
DC IN / Courant d’entrée directe /
Gelijkstroom-ingang / entrada de corriente
directa / ingresso diretto di corrente /
entrada decorrente direta / Likström ingång /
Gleichstrom-Eingang
DC DC
DC DC
L Vow olt
Start
(from 2V)
CHARGE OptiMate
DC-DC
Mai tenancn e
5 6
Charge
retention
TEST
OPTIMIZEPULSE SAVE
copyright © 2017 TecMate International – TM500DC-IN1-170426
2V
13.6V
14.4V
1 2 3 4 5 6
12V
CHARGE
SAVE
MAINTAIN
TEST - - -
BATTERY SAVING
CHARGER-MAINTAINER
LEAD-ACID LIFEPO & 4
12V
LIFEPO4LEAD-ACID
12.8V12.8V
LFP
12V
DC DC DC DC DC DC
Model: TM500 v2
OUTPUT/SORTIE/SALIDA/LEISTUNG/
USCITA/UITGANG/UTSPÄNNING/
SAIDA: 12V 2A
DC IN / Courant d'entrée directe /
Gelijkstroom-ingang / entrada de
corriente directa / ingresso diretto di
corrente /entrada decorrente direta /
Likström ingång / Gleichstrom-Eingang
12-16V 2.7A
max
DC IN
LED #1 - SOURCE BATTERY LOW (<11V)
LED #2 - Reverse polarity
LED #3 - LOW VOLT SAVE (≥ 2V)
LED #4 - CHARGE & OPTIMIZE
LED #5 - GREEN: TEST & MAINTAIN
LED #6 - RED: TEST & MAINTAIN
1
2
34
5
6
12V SOURCE BATTERY
/ DC SUPPLY
12V / 12.8V BATTERY FOR
CHARGING & MAINTENANCE
25%
50%
75%
100%
12.8V
12.6V
12.4V
12.2V
12.0V
10%
10%
30%
13.0V
13.1V
50%
75%
13.2V
13.6V
100%
LiFePO4
AGM
25%
50%
75%
100%
10%
STD
11.8V
% : VOLTS
TABLE 1
2
3
DC DC
THIS PORTION OF THE MANUAL CONTAINS IMPORTANT SAFETY INSTRUCTIONS
FOR THE OPTIMATE DC-DC 12V 2A BATTERY CHARGER. IT IS OF THE UTMOST
IMPORTANCE THAT EACH TIME, BEFORE USING THE CHARGER, YOU READ AND
EXACTLY FOLLOW THESE INSTRUCTIONS. SAVE THESE INSTRUCTIONS.
AUTOMATIC CHARGER FOR 12V LEAD-ACID OR 12.8V LIFEPO4 BATTERIES
DO NOT USE FOR NiCd, NiMH, any other Li-Ion OR NON-RECHARGEABLE BATTERIES.
1. CAUTION : 12V DC APPLIANCE. DO NOT CONNECT TO AC POWER .
2. For indoor use only. Do not expose charger to rain or snow.
3. Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock,or
injury to persons.
4. To reduce risk of damage to electric plug and cord,pull by plug rather than cord when disconnecting charger.
5. An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and
electric shock.If extension cord must be used make sure that :
a) pins on plug of extension cord are the same number, size and shape as those of plug on charger.
b) the extension cord is property wired and in good electrical condition,and
c) the conductor wire size is large enough for the DC ampere rating of the charger as specified in the table below.
DC INPUT RATING IN AMPERES
Equal to or greater than But less than
LENGTH OF CORD,
FEET (m)
AWG SIZE
OF CORD
2A 3A 25 (17.6)
50 (15.2)
100 (30.5)
18
16
14
6. Do not operate charger with damaged cord or plug - replace the cord or plug immediately.
7. Do not operate charger if it has received a sharp blow, been dropped,or otherwise damaged in any way; take it to a qualified
serviceman.
8. Do not disassemble charger; take it to a qualified serviceman when service or repair is required.
Incorrect reassembly may result in a risk of electric shock or fire.
9. To reduce risk of electric shock, unplug the charger from supply before attempting any maintenance or cleaning.
Turning off controls will not reduce this risk.Clean only with slightly moist,not wet, cloth. Do not use solvents.
10. WARNING - RISK OF EXPLOSIVE GASES.
a) WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. B ATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL
BATTERY OPERATION. FOR THIS REASON, IT IS OF UTMOST IMPORTANCE THAT YOU FOLLOW THE INSTRUCTIONS EACH TIME YOU
USE THE CHARGER.
b) To reduce risk of battery explosion,follow these instructions and those published by the battery manufacturer and manufacturer of
any equipment you intend to use in vicinity of the battery. Review cautionary marking on these products and on engine.
11. PERSONAL PRECAUTIONS.
a) Someone should be within range of your voice OR close enough to come to your aid when you work near a lead-acid battery.
b) Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.
c) Wear complete eye protection and clothing protection. Avoid touching eyes while working near battery.
d) If battery acid contacts or enters eye, flood eye with cold running water for at least 10 minutes and get medical attention
immediately. If battery acid contacts skin or clothing, wash immediately with soap & water. If acid enters an eye , immediately flood
eye with running cold water for at least 10 minutes & get medical attention immediately.
e) NEVER smoke or allow a spark or flame in vicinity of battery or engine.
f) Be extra cautious to reduce risk of dropping a metal tool onto battery. It might spark or short-circuit battery or other electrical part
that may cause explosion.
g) Remove personal metal items such as rings, bracelets ,necklaces , and watches when working with a lead-acid battery. A
lead-acid battery can produce a short-circuit current high enough to weld a ring or the like to metal, causing a severe burn.
i) NEVER charge a frozen battery.
IMPORTANT SAFETY
INSTRUCTIONS FOR CANADA &
USA
SAFETY


Product specificaties

Merk: Tecmate
Categorie: Batterij-oplader
Model: Optimate DC-DC

Heb je hulp nodig?

Als je hulp nodig hebt met Tecmate Optimate DC-DC stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Batterij-oplader Tecmate

Handleiding Batterij-oplader

Nieuwste handleidingen voor Batterij-oplader