Sunbeam Safety Glide 3891 Handleiding

Sunbeam Strijkijzer Safety Glide 3891

Lees hieronder de 📖 handleiding in het Nederlandse voor Sunbeam Safety Glide 3891 (40 pagina's) in de categorie Strijkijzer. Deze handleiding was nuttig voor 35 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/40
always be followed, including the following:
lRead all instructions before use.
lUse iron only for its intended use.
lTo protect against risk of electric shock, do
immerse the iron in water or other liquids.
lThe iron should always be turned to “OFF”
before plugging or unplugging from outlet.
Never yank cord to disconnect from outlet;
instead, grasp plug and pull to disconnect.
lDo not allow cord to touch hot surfaces. Let
iron cool completely before putting away. Loop
cord loosely around iron when storing.
lAlways disconnect iron from electrical outlet
when filling with water or emptying and when
not in use.
lDo not operate iron with a damaged cord or if
the iron has been dropped or damaged. To avoid
the risk of electric shock, do not disassemble the
iron. Take it to an authorized service center for
examination and/or repair. Incorrect reassembly
can cause a risk of electric shock when the iron
is used.
lClose supervision is necessary for any appliance
being used by or near children. Do leave
iron unattended while connected or on an
ironing board.
lBurns can occur from touching hot metal parts,
hot water or steam. Use caution when you turn
a steam iron upside down there may be hot
water in the reservoir.
lIf the iron is not operating normally, disconnect
from the power supply and have the iron
serviced by an authorized service center.
heel rest. Do not leave the iron unattended. Do
not set the iron on an unprotected surface, even
if it is on its heel rest.
Special instructions
lThis is a 1200 watt appliance.” To avoid a
circuit overload, do not operate another high
wattage appliance on the same circuit.
lIf an extension cord is absolutely necessary, a
lo-ampere cord should be used. Cords rated for
less amperage may overheat. Care should be
taken to arrange the cord so that it cannot be
pulled or tripped over.
For products purchased in the United States
and Canada only
To reduce the risk of electrical shock, this appliance
has a polarized plug (one blade is wider than the
other). This plug fits a polarized outlet only one
way; if the plug does not fit fully into the outlet,
reverse the plug. If it still does not fit, contact a
qualified electrician. Do not attempt to defeat this
safety feature.
“In Mexico, the iron runs at 127 volts, 1350 watts. If an
extension cord is necessary, a cord should be used.
INSTRUCTIONS


Product specificaties

Merk: Sunbeam
Categorie: Strijkijzer
Model: Safety Glide 3891

Heb je hulp nodig?

Als je hulp nodig hebt met Sunbeam Safety Glide 3891 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Strijkijzer Sunbeam

Handleiding Strijkijzer

Nieuwste handleidingen voor Strijkijzer