Sun Joe SWJ805E Handleiding

Sun Joe Zaagmachine SWJ805E

Lees hieronder de 📖 handleiding in het Nederlandse voor Sun Joe SWJ805E (20 pagina's) in de categorie Zaagmachine. Deze handleiding was nuttig voor 38 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/20

®, LLC

A Division of Snow Joe

® , LLC Model SWJ805E Form No. SJ-SWJ805E-880E-MR2

OPERATOR’S MANUAL

ELECTRIC POLE + CHAIN SAW

8-INCH | 6-AMP | 2-IN-1 POLE + HANDHELD

IMPORTANT!

Safety Instructions

All Operators Must Read These

Instructions Before Use

Always follow these safety guidelines. Failure to do so may

result in serious bodily injury or death.

mDANGER! This indicates a hazardous situation, which,

if not followed, will result in serious injury or death.

mWARNING! This indicates a hazardous situation, which,

if not avoided, could result in serious injury or death.

mCAUTION! This indicates a hazardous situation, which,

if not avoided, could result in minor or moderate injury.

General Safety

mWARNING! When using electric yard tools, basic safety

precautions should always be followed to reduce the risk of

re, electric shock, and personal injury, including the following:

1. Keep guards in place – Protective guards should be

checked periodically to ensure they are properly tted and

in correct working order.

2. Remove adjusting keys and wrenches – Check that

adjusting wrenches are removed from the saw before

turning it on.

3. Keep work area clean and well-lit – Clear work area of

branches and limbs after each cutting session. Cluttered

areas invite accidents.

4. Do not use in dangerous environments – Do not use

power tools in damp or wet locations.

5. Do not use the electric pole + chain saw in the rain.

6. Keep bystanders and children away – All bystanders,

including children and pets, should be kept a safe

distance away from the work area.

7. Do not force the tool – It will do the job eectively and

safely if it is used at the rate for which it was designed.

8. Use the right tool – Do not force the tool or any

attachment on the tool to do a job for which they were

not designed.

9. Wear proper apparel – Do not wear loose articles of

clothing or jewelry since such items may get caught in

moving parts. Use of heavy-duty rubber gloves,

substantial non-skid footwear, and close-tting clothing is

recommended when working outdoors with power tools.

10. Wear protective hair coverings to contain long hair.

11. Always wear safety glasses and ear defenders to

provide eye and ear protection – Everyday eyeglasses

only have impact resistant lenses and do not provide the

same protection as safety glasses.

12. Wear face or dust masks – If the cutting operation is

dusty, the use of a face or dust mask specially designed

to lter out microscopic particles is recommended.

13. Do not overreach – Keep proper footing and balance

at all times.

14. Maintain tools with care – Keep tools sharp and clean

for best and safest performance. Follow instructions for

lubricating and changing accessories.

15. Disconnect tool – Disconnect the electric pole + chain

saw from the power supply when not in use, before

servicing, when transporting, or when changing the chain

or other accessories.

16. Reduce the risk of unintentional starting – Make sure

the switch is in the OFF position before plugging the tool

into a power source.

17. Use recommended accessories – Consult the owner’s

manual for recommended accessories. The use of

improper accessories may cause risk of injury.

18. Check for damaged parts – Before each use, repair, or

replace any guard or part that is damaged. In addition,

check for alignment of moving parts, binding of moving

parts, breakage of parts, and any other conditions that

may aect the tool's operation.

19. Never leave tool unattended while it is running – Turn

the power OFF by removing the power cord directly from

its socket. Do not leave the saw until the cutting bar

comes to a complete stop.

20. Avoid unintentional starting – Do not carry the electric

pole + chain saw with your nger on the switch.

21. Do not grasp the exposed cutting blade or cutting

edges when picking up or holding the saw – Be sure

to encase the cutting bar in its protective sheath when

not in use.

22. Stay alert – Watch what you are doing. Use common

sense. Do not operate the electric pole + chain saw when

you are tired.

23. Store idle tool indoors – When not in use, appliances

should be stored indoors in a dry and high or locked-up

place out of the reach of children.

Electrical Safety

1. Ground fault circuit interrupter (GFCI) protection should

be provided on the circuit(s) or outlet(s) to be used for

the electric pole + chain saw. Receptacles are available

having built-in GFCI protection and may be used for this

measure of safety.

2. To prevent electric shock, use only with an extension cord

suitable for outdoor use, such as SW-A, SOW-A, STW-A,

STOW-A, SJW-A, SJOW-A, SJTW-A, or SJTOW-A.

Before use, check that the extension cord is in good

condition. When using an extension cord, make sure to

use one heavy enough to carry the current your product

will draw. An undersized cord will cause a drop in line

voltage resulting in loss of power and overheating.

3. To reduce the risk of electric shock, this appliance has

a polarized plug (i.e. one blade is wider than the other).

Use this appliance only with a polarized UL-, CSA-, or

ETL-rated extension cord for outdoor, all-weather use.

The appliance plug will t into a polarized extension

cord only one way.

If the appliance plug does not t fully into the extension

cord, reverse the plug. If the plug still does not t, obtain

a correct polarized extension cord. A polarized extension

cord will require the use of a polarized wall outlet. The

extension cord plug will t into the polarized wall outlet

only one way. If the plug does not t fully into the wall

outlet, reverse the plug. If the plug still does not t,

contact a qualied electrician to install the proper wall

outlet. Do not modify the appliance plug, extension cord

receptacle, or extension cord plug in any way.

m WARNING! m

Electric shock may cause SEVERE INJURY or

DEATH. Heed these warnings:

• Do not allow any part of the electric pole + chain saw

to make contact with water while it is in operation. If

the appliance becomes wet while turned o, wipe dry

before starting.

• Use only a UL-, CSA-, or ETL-rated extension cord

for outdoor, all-weather use.

• Do not use an extension cord over 100 ft (30 m).

• Do not touch the appliance or its plug with wet hands

or while standing in water. Wearing rubber boots

oers some protection.

EXTENSION CORD CHART

Cord Length:

Min. Wire Gauge (A.W.G.):

Up to 50 ft

(15 m)

+50 ft - 100 ft

(+15 m - 30 m)

4. To prevent the appliance cord from disconnecting from the

extension cord during operation, make a knot with the two

cords as shown in Table 1.

5. Do not abuse the cord. Never pull the electric pole + chain

saw by the cord or yank the cord to disconnect it from the

receptacle. Keep the cord away from heat, oil, and

sharp edges.

(B) Connect plug and receptacle

Cord set Appliance cord

(A) Tie cord as shown

Table 1. Method of Securing Extension Cord

Specic Safety Rules

mWARNING! To protect yourself SHOCK HAZARD! –

from electrocution, do not operate the electric pole + chain

saw within 50 ft (15 m) of overhead wires. Failure to follow this

instruction could result in severe personal injury.

Operating Tips for Pole Chain Saws

• Note the extension cord's location relative to the tool.

While operating the pole chain saw, be careful not to trip

over the cord.

• Keep the cord away from the chain and the operator at

all times.

• Keep children, animals, and bystanders a safe distance

away from the pole chain saw and extension cord.

• Only the pole chain saw operator should be in the

work area.

• Do not use the pole chain saw to cut down trees.

• Always use two hands when operating the pole chain saw.

Grip the pole chain saw securely with one hand on the

trigger and the other hand on the pole.

• Before starting the pole chain saw, make sure that the saw

chain is not in contact with any object.

• Do not allow the pole chain saw to make contact with

grounded objects such as pipes, fences, and metal posts.

• Do not force the pole chain saw while cutting. Apply light

pressure. It will perform more eectively and safely if it is

used at the rate for which it was designed.

• Use extreme caution when cutting a limb that is under

tension. When wood tension is released, the limb could

spring back and strike the operator, causing severe injury

or death.

• Do not carry a plugged-in unit. Carry the pole chain saw

from one place to another with the unit unplugged. During

transport, hold the pole at its balance point (close to the

saw end), with the guide bar and chain facing to the rear.

When transporting or storing the pole chain saw, always t

the guide bar cover.

• Do not cut small brush and saplings with the pole chain

saw. Small branches may catch in the chain and be

whipped towards the operator, which could pull the

operator o balance.

Operating Tips for Chain Saws

• Keep all parts of the body away from the saw chain when

the chain saw is operating. Before you start the chain saw,

make sure the saw chain is not contacting anything. A

moment of inattention while operating the chain saw

may cause entanglement of your clothing or body with

the saw chain.

• Always hold the chain saw with your right hand on the rear

handle and your left hand on the front handle. Holding the

chain saw with a reversed hand conguration increases

the risk of personal injury and should never be done.

• Wear safety glasses and hearing protection. If you are

using the chain saw every day under normal conditions,

you can be exposed to a noise level of 85 dB (A) or higher.

Further protective equipment for head, hands, legs and

feet is recommended. Adequate protective clothing will

reduce personal injury by ying debris or accidental

contact with the saw chain.

• Do not operate the chain saw in a tree. Operation of a

chain saw while up in a tree may result in personal injury.

• Always keep proper footing and operate the chain saw

only when standing on a xed, secure and level surface.

Slippery or unstable surfaces such as ladders may cause

a loss of balance or control of the chain saw.

• When cutting a limb that is under tension, be cautious

of spring back. When the tension in the wood bers is

released, the spring-loaded limb may strike the operator

and/or throw the chain saw out of control.

• Use extreme caution when cutting brush and saplings.

The slender material may catch the saw chain and be

whipped toward you or pull you o balance.

• Carry the chain saw by the front handle with the chain saw

switched o and away from your body. When transporting

or storing the chain saw, always t the guide bar cover.

Proper handling of the chain saw will reduce the likelihood

of accidental contact with the moving saw chain.

• Follow instructions for lubricating, chain tensioning and

changing accessories. An improperly tensioned or poorly

lubricated chain may either break or increase the chance

for kickback.

• Keep handles dry, clean and free from oil and grease.

Greasy, oily handles are slippery and can cause loss

of control.

• Cut wood only. Do not use the chain saw for any other

purpose. For example, do not use the chain saw to cut

plastic, masonry or non-wood building materials. Using

the chain saw in these incorrect ways could result in

serious damage to you and your tool.

Product specificaties

Merk:	Sun Joe
Categorie:	Zaagmachine
Model:	SWJ805E

Heb je hulp nodig?

Als je hulp nodig hebt met Sun Joe SWJ805E stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Zaagmachine Sun Joe

Sun Joe 20VIONLTE-CS10-RM Handleiding

15 November 2024

Sun Joe SWJ802E-PRP Handleiding

15 November 2024

Sun Joe iON8PS2 Handleiding

26 Juli 2023

Sun Joe 24V-HCSWP-CT Handleiding

2 Juli 2023

Sun Joe 24V-CSSHRP-LTE-RM Handleiding

20 Juni 2023

Sun Joe SWJ803E Handleiding

17 Juni 2023

Sun Joe SWJ599E Handleiding

4 Juni 2023

Sun Joe SWJ699E-RED-RM Handleiding

10 Mei 2023

Sun Joe 24V-PS10-CT Handleiding

7 Mei 2023

Sun Joe SWJ699E-RM Handleiding

5 Mei 2023

Handleiding Zaagmachine

Nieuwste handleidingen voor Zaagmachine

Makita DJR187ZK Handleiding

2 December 2024

Fieldmann FDK 201302-E Handleiding

1 December 2024

Fieldmann FDP 200805-E Handleiding

1 December 2024

Fieldmann FZP 4216-B Handleiding

1 December 2024

Fieldmann FZP 5816-B Handleiding

1 December 2024

King Craft ZKGS 4300 UG Handleiding

30 November 2024

Global PSG 750 Handleiding

30 November 2024

Global MTS-G 400 Handleiding

30 November 2024

Global N-PSL 750 Handleiding

30 November 2024

Global PSL-G 750 Handleiding

30 November 2024