SkyRC e4 Handleiding

SkyRC Batterij-oplader e4

Lees hieronder de 📖 handleiding in het Nederlandse voor SkyRC e4 (4 pagina's) in de categorie Batterij-oplader. Deze handleiding was nuttig voor 27 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

Thank you for your choice of the SKYRC e4, 100-240V AC balance charger. This unit is simple to use but

its operation does require some knowledge on the part of the user. Please read this entire operating

manual completely and attentively before using this product, as it covers a wide range of information on

operating and safety.

SKYRC e4 Charger is an economic, high quality 100-240V AC balance charger, designed for charging

LiPo and LiFe batteries from 2-4 cells in balance mode. The circuit power is 20W and max charge current

can reach to 3A. There are three kinds of charge current 1A/2A/3A that can be selected. You could select

the proper charge current according to battery capacity.

INSTRUCTION MANUAL

INTRODUCTION

CHARGE PROCEDURES

SKYRC e4 comes with the built in power supply. You can connect the AC power cord to the AC socket

(100-240V AC) directly.

Insert the AC power cord into the charger.

Insert the AC cord into a wall socket (100-240V). All LEDS will light for 1 second and the charge

status LED will flash green which indicates the charger is ready to charge.

Select the battery type LiPo/LiFe by the toggle switch.

Select the proper charging current 1A/2A/3A by the toggle switch.

Connect the battery main charge lead to battery socket which is in the front side of the charger and

battery balance wire to balance port which is in the right side of the charger.

The charger starts charging. The charge status LED and the cell status LED will glow constant red. If

the battery pack is 2-cell, Cell 1 and Cell 2 LEDs will glow constant red; if the battery pack is 3-cell,

Cell 1, Cell 2 and Cell 3 LEDs will glow constant red; and so on.

During the charging progress, when the charge

status LED glows constant red, the charger is

charging in CC mode; when the charge status

LED glows constant orange, the charger is

charging in CV mode;

When the cell LED is flashing, this cell is

discharging for balancing.

When the battery is fully charged, the charge

status LED will glow constant green.

Unplug the battery from the charger and the

charge status LED will flash green which

indicates the charger is ready to charge

another battery.

Please refer to following steps to charge the battery,

- - - -1 2

SPECIFICATION

AC Input

Battery Type

Cell Count

Charge Current

Circuit Power

Current Drain for Balancing

Dimension

Weight

Charger/Cell Status

100-240V

LiPo/LiFe

2-4 cells

1A/2A/3A ± 10%

20W

200mA

69.4x110.7x40.5mm

176g

SK-100055

This diagram shows the correct way to connect your

battery to the e4 charger while charging in balance

mode.

Failure to connect as shown in this diagram will

damage this charger.

CAUTION:

CONNECTION DIAGRAM

Charger

Battery

10)

Battery Type Switch

Cell 2 LED Indicator

Cell 1 LED Indicator

Cell 4 LED Indicator

Cell 3 LED Indicator

Battery Socket

AC 100-240V

Power Jack

Charge Current Switch

Charge Status LED Indicator

Balance Socket

EXPLANATION OF LED STATUS

If the charger encounters a problem, all LEDs will flash red in sequence to alert you the errors. In this

case, please disconnect the power cord from the wall socket and unplug the battery from the charger.

* Error Message

LED green blinking

LED glows constant red

LED glows constant orange

LED glows constant green.

LED glows constant red.

LED flashes red

The charger is ready to charge.

The charger is charging in CC mode.

The charger is charging in CV mode.

The charging process finishes.

The cell is charging.

The cell is discharging.

Charge Status LED

Cell Status LED

7504-0293-01

Manufactured by

SKYRC TECHNOLOGY CO LTD ., .

www skyrc com. .

- - - -3 4

THE SET CONTAINS WARNING AND SAFETY NOTES

SKYRC e4 is suitable for charging rechargeable LiPo/LiFe batteries. Do not attempt to recharge dry

cells. Charging other types of batteries may cause fire or explosion.

Never leave the charger unattended when it is connected to its power supply.

The allowable AC input voltage is 100-240V AC. Never connect it to any other voltage.

Protect charger from dust, dirt and damp.

Never place the charger and batteries connected to it on any form of flammable surface. Never

operate the charger in the vicinity of inflammable material or gas.

Ensure that there is an unrestricted airflow to and from the charger's cooling slots. Never place the

charger on a carpet or similar surface.

Take great care to maintain correct battery polarity, and avoid shot-circuit. Read the battery

manufacturer's instructions and adhere to them strictly.

WARRANTY AND SERVICE

We guarantee this product to be free of manufacturing and assembly defects for a period of one year

from the time of purchase. The warranty only applies to material or operational defects, which are present

at the time of purchase. During that period, we will repair or replace free of service charge for products

deemed defective due to those causes.

You will be required to produce proof of purchase (invoice or receipt). This warranty is not valid for any

damage or subsequent damage arising as a result of misuse, modification or as a result of failure to

observe the procedures outlined in this manual.

LIABILITY EXCLUSION

This charger is designed and approved exclusively for use with the types of battery stated in these

Instruction Manual. SKYRC accepts no liability of any kind if the charger is used for any purpose other

than that stated. We are unable to ensure that you follow the instructions supplied with the charger, and

we have no control over the methods you employ for using, operating and maintaining the device. For this

reason we are obliged to deny all liability for loss, damage or costs which are incurred due to the

incompetent or incorrect use and operation of our products, or which are connected with such operation

in any way. Unless otherwise prescribed by law, our obligation to pay compensation, regardless of the

legal argument employed, is limited to the invoice value of those SKYRC products which were

immediately and directly involved in the event in which the damage occurred.

SkyRC e4 Charger

AC Power Cord

18AWG Wire Charging Cable

RECOMMENDED ACCESSORIES

Tamiya charging cable

5201-0030-01

TRAXXAS charging cable

5201-0033-01

Crocodile clip

charging cable

5201-0031-01

EC3 charging cable

5201-0034-01

Dean charging cable

5201-0012-01

Futaba RX charging cable

JST/BEC charging cable

5201-0044-015201-0043-01

CONFORMITY DECLARATION

SKYRC e4 satisfies all relevant and mandatory CE directives and FCC Part 15 Subpart B: 2008.

The product has been tested to meet the following technical standards:

This symbol means that you must dispose of electrical devices from the general household

waste when it reaches the end of its useful life. Take your charger to your local waste

collection point or recycling centre. This applies to all countries of the European Union, and to

other European countries with a separate waste collection system.

Conform

CE-EMC

FCC-VOC FCC Part 15B

Electromagnetic compatibility (EMC) -- Part 6-3:

Genericstandards - Emission standard for residential,

commercial andlight-industrial environments.

Electromagnetic compatibility (EMC) -- Part 6-1: Generic

standards - Immunity for residential, commercial and

light-industrial environments.

EN61000-6-1

EN61000-6-3

Test Standards Title Result

Electromagnetic compatibility (EMC), Conduction Emission

& Radiation Emission.

Conform

EN61000-3-3

Electromagnetic compatibility (EMC) - Part 3-3: Limits -

Limitation of voltage changes, voltage fluctuations and

flicker in public low-voltage supply systems, for

equipment with rated current 16 A per phase and not

subject to conditional connection.

EN61000-3-2

Electromagnetic compatibility (EMC) –

Part 3-2: Limits – Limits for harmonic current emissions

(equipment input current 16 A per phase)≤

Conform

EN60335-2-29

CE-LVD

Household and similar electrical appliances –. Safety –.

Part 2-29: Particular requirements for battery chargers.

Conform

Product specificaties

Merk:	SkyRC
Categorie:	Batterij-oplader
Model:	e4
Kleur van het product:	Zwart
Ingebouwd display:	Nee
Gewicht:	176 g
Breedte:	69.4 mm
Diepte:	110.7 mm
Hoogte:	40.5 mm
Soort:	Batterijlader voor binnengebruik
Ondersteund aantal accu's/batterijen:	4
Aantal per verpakking:	1 stuk(s)
Ingangsspanning:	100-240 V
Frequentie:	50/60 Hz
Compatibele batterij technologiën:	Lithium-Polymeer (LiPo)
Oplaadstroom:	1A, 2A, 3A
Uitvoer:	20W